Question about 1999 Mitsubishi Montero

1 Answer

How to adjust the TPS (throttle positioning sensor) on a 1998 Mitsubishi Montero?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 571 Answers

Just change the TPS sensor for a new one. It's an a electronic part and can't be ajust it

Posted on Oct 21, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

High eratic idle


Try checking the adjustment screw on the throttle body. Two other possible causes could be the speed sensor or the TPS sensor.

Feb 28, 2014 | 1991 Mitsubishi Montero

1 Answer

Code po122 is suddenly coming on in my 1998 Pontiac Grand Am with the 3.1 li engine.


Symptoms may include:
  • Rough or low idle
  • Stalling
  • Surging
  • No/little acceleration
  • other symptoms may also be present
CausesA code P0122 may mean that one or more of the following has happened:(TPS) = Throttle Position Sensor
  • TPS not mounted securely
  • TPS circuit short to ground or another wire
  • Faulty TPS
  • Damaged computer (PCM)
Possible SolutionsSome recommended troubleshooting and repair steps are:
  • Carefully check the throttle position sensor (TPS), wiring connector, and wiring for breaks, etc. Repair or replace as necessary,
  • Check the voltage at the TPS (refer to a service manual for your vehicle for specific information). If the voltage is too low that is indicative of a problem. Replace if necessary.
  • If recently replaced the TPS may need to be adjusted. On some vehicles the installation instructions call for the TPS to be properly aligned or adjusted, consult a repair manual for specifics.
  • If there are no symptoms at all, the problem may be intermittent and clearing the code may resolve the issue temporarily. If this is the case then you should definitely check the wiring to be sure it's not rubbing on anything, grounding, etc. The code may come back.

Aug 26, 2013 | 2006 Mitsubishi Colt

1 Answer

Where is the tps on a 1998 plymouth voyager


The Throttle Position Sensor (TPS) is mounted to the side of the throttle body and connects to the throttle blade shaft. The TPS is a variable resistor that provides the PCM with an input signal (voltage).

zjlimited_1466.jpg

Fig. Pull the Throttle Position Sensor (TPS) off of the throttle shaft



Hope this helps (remember to rate and comment this free answer).

Jun 22, 2011 | 1998 Plymouth Voyager

1 Answer

Need to install throttle sensor in a 1999 montero sport


A TPS (throotle positioning sensor) is located on the throttle body of the motor. If you follow the air intake tube from the air filter to the motor, you will find yourself at the throttle. The TPS sensors are held onto the motor by two bolts, and a simple plug, clips onto them. On the back side of the TPS is a little indented rotor type cap, pay attention while you are removing the old one to see how it fits in.

Here is a photo of your TPS:



bbf87e8.jpg
Thanks for using FixYa, Come on back with any other questions!!

Good Luck!!

Mar 26, 2010 | 1999 Mitsubishi Montero Sport

1 Answer

How do i check the throttle positioning sensor on an 04 Mitsubishi Endeavor to see if it is bad.Service engine light is on. diagnostic tool wont clear the tps high voltage code. I need to know the process...


YOU NEED A DIAGNOSTIC SCANNER THAT WILL SHOW YOU TPS SENSOR OPERATION.WITH THROTTLE CLOSE TPS SENSOR VOLTAGE OUT PUT 0 AS YOU MOVE THROTTLE OPEN THE TPS SENSOR VOLTAGE SHOULD INCREASE TO 5.0 VOLTS THATS WIDE OPEN THROTTLE.

Mar 08, 2010 | 2004 Mitsubishi Endeavor

1 Answer

Idol is too low


you can not adjust the idle it is ctroled through the ecm(main computer) there is a sensor on the throttle body(tps) this needs to be replaced. also make sure you check all vaccum lines as well

Apr 27, 2009 | 2002 Mitsubishi Montero Sport

1 Answer

Is it possible to adjust a throttle position sensor on a 2000 montero sport?


when your vehical throws a code and you replace the defective part, you must clear the code or the ecm will still recognize it as an active code.

Aug 27, 2008 | 2000 Mitsubishi Montero Sport

Not finding what you are looking for?
Cars & Trucks Logo

1,095 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...