Question about Cadillac DTS

Open Question

How to remove and replace blower motor on 2000 cadillac dts

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: heater blower motor on 1996 cadillac eldorado

very tight but you can clear the engine just moving some spark plug wires and the vacuum controls (controlled units?) right in front of it. when you get the bolts off the blower fan housing and its free to move you just have to rotate it so the flat part can clear the rear valve cover. do yourself a favor and be sure to isolate the problem to the motor (and not the electrical connections or the computer disabling it for something rediculous like lack of a/c charge) as it's an expensive part for a little motor and worse (around 250 i think) if you need end up replacing the entire fan.

Posted on Feb 19, 2009

michigan man
  • 3533 Answers

SOURCE: 2008 Cadillac DTS navigation manual

try www.edmonds.com

Posted on Mar 21, 2009

  • 5 Answers

SOURCE: blower motor has no power 1994 cadillac deville

If there is only high speed fan, then replace the resistor assembly in the heater plenum. If there is no fan at all, then check the ground to the blower- the wire fails down in the fender well. Just run a new ground from a convenient spot to the motor's plug harness. Or it could just be a bad blower motor.

Posted on May 29, 2009

  • 1986 Answers

SOURCE: rear door panel 2002 cadillac dts

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 18 Answers

SOURCE: my 2000 cadillac dts keeps

could be head gaket faliure have it block tested

Posted on Nov 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 dts caddy blower motor resister location


Your not going to like to hear this , but you'll need to take the dash apart !
Blower Motor Resistor Replacement
Preliminary Procedure
  1. Remove the HVAC module. Refer to HVAC Module Assembly Replacement .
Preliminary Procedure
  1. Drain the cooling system. Refer to Cooling System Draining and Filling .
  2. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  3. Remove the evaporator tube from the thermal expansion valve. Refer to Air Conditioning Evaporator Hose Assembly Replacement .
  4. Remove the heater hoses from the heater core. Refer to Heater Hoses Replacement .
  5. Remove the brake pedal bracket assembly. Refer to Brake Pedal Assembly Replacement .
  6. Pull back and reposition the carpet.
  7. Remove the lower instrument panel (I/P) support brace. Refer to Instrument Panel Center Support Bracket Replacement .
  8. Reposition the auxiliary air distribution duct. Refer to Auxiliary Air Distributor Duct Replacement .
  9. Remove the instrument panel carrier. Refer to Instrument Panel Carrier Replacement .
  10. Disconnect the HVAC module assembly electrical connectors.
1
HVAC Module Assembly Nut (Qty: 5)
Tip
Tighten the nuts in sequence.
Tighten
9 N?·m (80 lb in)
2
HVAC Assembly Module
Disconnect the blower motor resistor electrical connector.

Jul 28, 2016 | 2008 Cadillac Dts

1 Answer

Blower motor resistor location?


Find a place that clean remove as much as part in order as you can. oil pan drop it transmission pan drop it battery remove and keep thing clean as possible. starter intake everything fan power pump and radiator than you can remove hood and get a lift for engines and unbolt the trans than the motor mounts

Jul 24, 2014 | 2004 Cadillac DeVille DTS

1 Answer

2000 Eldorado blower not working


INFORMATION
Subject:
Revised HVAC Blower Motor Installation Procedures

Models:
1994-1997 Cadillac Seville
1994-1999 Cadillac DeVille
1994-2002 Cadillac Eldorado

The intent of this bulletin is to provide technicians information regarding the proper installation of the Heating, Ventilation and Air Conditioning (HVAC) Module blower motor (with impeller) assembly.



The current available HVAC Module blower motor for the above listed vehicles can be identified by the three mounting holes (1). The original equipment blower motor had five mounting holes.

In order to avoid confusion and ensure a high level of customer satisfaction, when replacing an HVAC Module blower motor, refer to this bulletin for the appropriate procedure.

Eldorado/Seville-HVAC Blower Motor
Caution: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

Removal Procedure
1. Disconnect the negative battery cable.

2. Remove the camshaft cover.

3. Remove the blower motor.

^ Disconnect connector from the blower motor.

^ Remove the blower motor screws (either 3 or 5 screws).

^ Remove the blower motor from the HVAC Module.

Installation Procedure
1. If present, remove the 2 ribs located on the barrier. Refer to Step 3 and the illustrations in the Instruction Sheet, P/N 52494110, found in the blower motor kit.

Important: Ensure the blower motor gasket makes a complete seal around the blower motor.

2. Install the new blower motor with heat shield. Refer to Steps 4 and 5 in the Instruction Sheet, P/N 52494110, found in the blower motor kit.

3. Install the blower motor retaining screws.

Tighten

Tighten the screws to 4 N.m (35 lb in).
4. Tighten the lower heat shield retaining screws to 4 N.m (35 lb in).

5. Connect the connector to the blower motor.

6. Install the camshaft cover.

7. Connect the negative battery cable.

Oct 09, 2012 | 2000 Cadillac Eldorado

1 Answer

Blower not working for heat or air


first check your fuse box for burnt fuses then check the relays.if these check out alright find the blower motor and remove the connecting plug and test for power at the plug.if you have power at the plug then the blower motor is burnt and needs to be replaced.

Nov 28, 2011 | 2000 Cadillac DeVille

1 Answer

Replacement of the oil pan on a cadillac 2006 DTS


Big job.

gmlogoflat.gif Service Information
bhome.gifbpublication.gifbnumsrchbutton.gifbnews.gifymkbutton.giffeedback.gifbhelp.gif
2006 Cadillac DTS ' DTS VIN K Service Manual ' Document ID: 636855 Oil Pan Removal

    1527739.gif
    tif.gif
  1. Rotate the engine so that the oil pan is facing up.
  2. Remove the oil pan drain plug.

  3. 1373472.gif
    tif.gif
  4. Remove the oil pan bolts.

  5. 1373475.gif
    tif.gif
  6. Remove the oil pan from the lower crankcase oil distribution manifold plate.

  7. 1373484.gif
    tif.gif
  8. Remove and discard the oil pan gasket.

  9. 204585.gif
    tif.gif
  10. Remove the oil level sensor (1).

Jul 29, 2011 | 2006 Cadillac DTS

1 Answer

Heard a crunching noise when I rolled up my passenger window in my 2000 cadillac dts. Now window does not go up or down


it is your window regulator...expect them all to go out.all four went out in my 2000 dts within a couple months..buy aftermarket or you'll be payin about 300 for just the regulator.they are real easy to replace by yourself.

Aug 22, 2010 | 2000 Cadillac DeVille

1 Answer

How much would a motor for a 2000 cadillac dts cost?


parts and labor approx $4k. and you will want to get new motor mounts installed also whenever replacing and engine.

Apr 29, 2010 | 2000 Cadillac DeVille

1 Answer

I have a 2000 Cadillac DTS. It steers hard at low


power steering pump is/may be going bad or the rack and Pinion unit could be bad.

Jul 31, 2009 | Cadillac DTS Cars & Trucks

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...