Question about 1999 Volkswagen New Jetta

1 Answer

What is the drive cycle for a 1999 vw jetta - 1999 Volkswagen New Jetta

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Volkswagen Master
  • 76,109 Answers

The drive cycle is as follows
For all OBD2 VW's

OBD-II Drive Cycle Stages
The OBD-II Drive Cycle is an eight-stage course, as illustrated in the
chart on page 3. An explanation of each step is provided below.
Stage 1: Cold Start-The ECM determines the presence of a cold start
by comparing the engine coolant temperature to the ambient air
temperature during startup. The engine is considered cold when:
• Engine coolant temperature is below 122°F (50°C).
• Engine coolant and intake air temperatures are within 11°F (6°C) of
each other at startup.
During this period, the O2S heater, misfire, AIR, fuel system, and EVAP
monitors run.

Stage 2: Idle 2½ Minutes-Turn the air conditioning (A/C) and
headlights on to help the misfire monitor-the additional electrical loads
help even out combustion pulses. During this period, the O2S heater,
AIR, EVAP, misfire, and possibly fuel system (if operating in closed loop)
monitors run.

Stage 3: Accelerate-Prior to accelerating, turn off the A/C and
headlights (if possible). Open the throttle halfway until you reach
55 MPH (89 KPH). During acceleration, the misfire, fuel system, and
EVAP monitors run.

Stage 4: Steady State Cruise-During this portion of the cycle, the
O2S, AIR, EGR, EVAP, misfire, and fuel system monitors run.

Stage 5: Decelerate-Gradually coast down without applying the
brakes. Also, on manual transmission vehicles, remain in high gear and
do not press the clutch. During this period, the EGR, EVAP, and fuel
system monitors run.

Stage 6: Accelerate-Apply ¾ throttle until reaching 60 MPH (97 KPH).
During acceleration, the misfire, fuel system, and EVAP monitors run.

Stage 7: Steady State Cruise-During this period, the CAT, O2S, AIR,
EGR, EVAP, misfire, and fuel system monitors run.

Stage 8: Decelerate-Gradually coast down without applying the
brakes. Also, on manual transmission vehicles, remain in high gear and
do not press the clutch. During this portion of the Drive Cycle, the EGR,
EVAP, and fuel system monitors run.

You can try this a couple times, but if it doesn't work you should go to a VW specialty shop like the dealer or a shop that does mostly European cars and they can use the scan tool to force the car through readiness.


Posted on Oct 11, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76109 Answers

SOURCE: Car cuts off while driving

the most likely cause of this is the carberater throttle kick up solenoid is defective or the carb deceleration damper is defective, u may one or both of these, have them tested for proper function, u don't have an airflow meter (this engine is not fuel injected) so ignore that mis-directed advice from exper tfrcs68

Posted on May 29, 2009

solasknows
  • 199 Answers

SOURCE: jetta wont start

serious electric problem, i think is the computer module try to get code with a mechanic

Posted on May 26, 2009

  • 3 Answers

SOURCE: vw jetta

Check the cable that runs from the battery to the starter.

Posted on Aug 08, 2008

  • 1 Answer

SOURCE: 1999 VW JETTA anti-theft alarm keeps going off & car won't start

pop the truck and the alarm will disable

Posted on Aug 17, 2009

  • 58 Answers

SOURCE: I have a 1999 VW Jetta that keeps running hot. I

Is the cooling fan comming on?
It must.

Posted on Oct 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 vw jetta turns off after 10 min of driving


It would be worth checking/replacing the ignition module ( see if you have a spark when it WON'T start) . Coil assy are plentiful and the most likely given your description. Very prone to over heating and shutting down. Good luck

Aug 26, 2012 | 1999 Volkswagen Jetta

2 Answers

I have a 99 vw jetta and my rear brakes have locked up. while leaving work i noticed my car was dragging but i thought it was because i hadnt let my car warm up. 2-3 miles down the road car was still...


Where can I get a lug nut key for my 99 VW Passat? Will my 2008 Jetta have ... My rear brakes on my 1999 VW jetta are grooved into my rotter so i cant slide ... 1999 Volkswagen Jetta Problem. okay i have a 1999 vw jetta new body style

Dec 15, 2010 | 1999 Volkswagen Jetta

4 Answers

Do I need any special tools or wedge to change a timing belt for 2001 tdi jetta diesel.


Timing Belt Spanner Wrench
AST tool# H 2587-1

- Used for the Adjustment of the Timing Belt
- Applicable to 2004-2005 VW Golf, Jetta Pump Duse and 2002-2005 Audi 3.0 V6

Used for the adjustment of the timing belt.

2009 Suggested user price: $52.67

Assenmacher Specialty Tools
1 800 525 2943
Timing Belt Spanner Wrench
AST tool# H 2587-2

- Used for Adjusting the Timing Belt Tension
  • Applicable to 1999 and later VW Golf and Jetta, Passat and 1999-2003 VW Beetle with 2.0L Gas Engine and 1.9L T.D.I. Diesel Engine
Used for adjusting the timing belt tension and is comparable to VW tool# T10020. Applicable to 1999 and later VW Golf and Jetta, and 1999-2003 VW Beetle with 2.0L gas engine and 1.9L T.D.I. diesel engine.

2009 Suggested user price: $52.67

Assenmacher Specialty Tools
1 800 525 2943
128947643

Jul 02, 2010 | 2001 Volkswagen Jetta TDI

1 Answer

Please advise how to change 1999 VW Jetta ATF? I


If there is no dipstick, chances are you have what is known as an 01M transmission. The fluid CAN be changed, but it is a bit more involved than normal. I STRONGLY suggest you read the Bentley manual or better yet, Google "Dan's VW page". Good Luck

Feb 27, 2010 | 1999 Volkswagen Jetta

3 Answers

How do i find the transmission code for my vw 1999 jetta


Hello
Code is engraved on a plate on the side of the transmission it self and usually it is a 3 letter code.

Jun 13, 2009 | 1996 Volkswagen Jetta

1 Answer

Jetta wont start


serious electric problem, i think is the computer module try to get code with a mechanic

May 26, 2009 | 1996 Volkswagen Jetta

1 Answer

Vw jetta


Check the cable that runs from the battery to the starter.

Jul 01, 2008 | 1999 Volkswagen Jetta

1 Answer

Looking for binder for 99 Jetta Owner's Manual


Go to vw dealer they might have one..

Jun 29, 2008 | 1999 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

1,513 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...