Cars & Trucks Logo

Related Topics:

Posted on Oct 11, 2010
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Where is the fuel pressure regulator located on a 1996 jeep grand cherokee, laredo, straight 6 cyl.?

1 Answer

Jeffrey Turcotte

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Jeep Master 8,991 Answers
  • Posted on Oct 11, 2010
Jeffrey Turcotte
Jeep Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Aug 22, 2010
Answers
8991
Questions
7
Helped
4372651
Points
33683

It's under the throttle body

Where is the fuel pressure - 2fe257d.gif

Fig. Fig. 1: TBI fuel pressure regulator

  1. Remove the throttle body assembly from the vehicle as outlined in this section.

WARNING To prevent spring pressure release, hold the regulator housing against the throttle body while removing the mounting screws.
  1. Remove the three retaining screws that hold the pressure regulator to the fuel body.
  2. Disassemble the pressure regulator assembly. Note the location of the components for reassembly. Discard the gasket.
To install:
  1. Install a new gasket and the regulator assembly. Tighten the three retaining screws.
  2. Install the throttle body assembly as outlined in this section.
WARNING The pressure regulator diaphragm MUST be installed with the vent hole aligned with the vent holes in the throttle body and regulator housing!

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Ok my 2001 Grand Cherokee Laredo wont stay in park

Transmission sticks in reverse- won't go into park. - JeepsUnlimited

www.jeepsunlimited.com/forums/showthread.php?...won-t-go-into-park
Jun 14, 2013 - 12 posts - ‎5 authors 2003 6 cyl 4x4 Grand Cherokee Laredo automatic- Occaionally, when shifting from REVERSE TO PARK, my Jeep will stay in reverse. Typically its ... '2001 WJ'4,0L'42RE'NV 242'380000 km'ECE Compliant' ??????????? ??? ...

2001 jeep grand Cherokee laredo - CarGurus

www.cargurus.com > Questions > Jeep > Grand Cherokee
CarGurusJan 27, 2014 - 2001 jeep grand Cherokee laredo - Just purchased a 2001 Jeep GrandCherokee Laredo and ... It starts in PARK sometimes and sometimes it won't and I have to start it in Neutral. ... Hatch shuts flush, but won't stay shut. help!
1helpful
2answers

I have a 1997 Jeep Grand Cherokee Laredo, 6 cyl. It will stall while I am driving, and may restart right away or may not restart for 20 minutes. I keep hearing this is a common problem for these Jeeps...

check fuel pressure regulator.....Fuel on one side of diaphrag, and vacuum pressure on other if there is fuel on the vacuum side then diaphragm is leaking...causing ecu to think there is plenty of pressure and holds back the signal to turn on fuel pump....
1helpful
1answer

Where is the gas regulator located on a 1996 jeep cherokee (2wd) ? Why is my jeep turning off and want start, until it sits for awhile; I have change the fuel filter and fuel pump?

You meant the fuel pressure regulator? It is located on the fuel rail and has vacuum attached to it. This is not the problem with your car tho. Check the ignition module, and the ignition coil.
1helpful
1answer

Wont start 1996 jeep grand cherokee laredo inline six4.0 fuel inj

The first thing I would do since you think it was flooded is to replace the sparkplugs, sometimes if a spark plug has been washed out with gas you cannot get it completely dried out. After you replace sparkplugs try to start the engine. If the engine starts I would still recommend that you change your oil because of fuel saturation. If your engine fails to start I would suspect that you have a bad crankshaft position sensor as it is known to give problems. The crankshaft position sensor is located on the top of the transmission bell housing on the drivers side.
1helpful
1answer

Engine fan wont come on

My moms fan switch went on her 01 gr cherokee and had the whole fan and relay replace, when is doesn't come on the fan motor is bad and won't regulate power, so the mechanic says, Please rate is thanx
0helpful
1answer

1996 JEEP SAYS ITS MISS FIRIENG ON ALL 6 CYL.

your timings off, if its a straight six the distributor is on the left side of your engine, if its a v 6 i think its on the intake manifold
but your definitly out of time!
0helpful
1answer

Where is the Oil Pressure Sending Unit 96 Jeep Grand Cherokee 4L

the sensor is located right above the oil filter, careful they crack very easily...but are really easy to replace...
2helpful
2answers

I got a 99 jeep grand cherokee laredo with a 4.0 straight 6 and looking for the radiator fan relay...any suggestions???

It's behind the passenger headlight.Need to take off grill,bumper fascia to get access to it.Mine took about an hour alltogether.
Not finding what you are looking for?

968 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...