Question about 1988 Chevrolet K1500

3 Answers

Transmission I have a 1988 Chevrolet K1500 with 700r4 transmission. No matter what gear I put it in, it barely moves when I rev up the motor. It moves about 5-10 MPH when engine reved up real high.

Posted by on

  • Anonymous Mar 24, 2009

    Got a 1983 6.2L diesel with a 700R transmission that will not shift have to get the RPM's really high to get it to move at all, and thats barely...

×

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 715 Answers

Www.tvmadeez.com/tvinstadj.php
This is great info, need to pressure check trans to properly set up trans. for long life, check it out
Be cool

Posted on May 03, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 868 Answers

Worn clutch /Transmission

Posted on Jun 02, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

I hate to say it but chances are your transmission needs major work. It is a 700R4, and they are notorious for being junk. A rebuild can run between 1200-1800, or you can swap to a TH350 or TH400 and probably be better off....

Posted on Feb 15, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reverse it took a few seconds to engage into gear to move when it moved I put it in drive and went forward then a small thumb occur and the motor stopped what


Does it kill the motor when you try to put it in gear now(fwd or rev)? Sounds like the torque converter clutch. Transmission part. Usually at about 150,000 miles. Hope that helps.

Feb 26, 2016 | 2006 Jeep Grand Cherokee

1 Answer

Why won't my chevrolet silverado move when put in gear?


Hi, I am guessing it is an automatic transmission. Try putting the gear shift lever into a lower gear and see if it moves then. Sometimes the shift linkage gets mal-adjusted. I would also check the transmission fluid level. If it is really low, the tranny will not work either. If the fluid is really low, you'll need to look for a leak after you refill it. I am assuming that the transmission worked when you picked it up from the shop that repaired it.

Aug 27, 2014 | 2004 Chevrolet Silverado

1 Answer

Replaced gear shifterrod bolt at transmission and now tranny won't go into gear


you must have put shifter in side the car on PARK and down at transmission on REVERSE there is no room for shifter to move,unhook it manually move the shifter on tranny all the way to opposite side and then hook it back on

Apr 02, 2014 | 1988 Chevrolet Sprint

1 Answer

1998 malibu transmission slipping when it is cold


Sounds like a servo seal (o-ring) in the trans itself. If the seal leaks, it will not allow the proper pressure to build in the circuit that engages bands and clutches. I see a trans rebuild in your future.

Feb 27, 2014 | 1998 Chevrolet Malibu

1 Answer

Ford Escape will barely move when put in gear. (D or R) Floored to get to 10 MPH


If it smells of raw fuel look for a shorted injector dumping fuel into the engine

Dec 27, 2013 | 2002 Ford Escape

1 Answer

1986 K5 Blazer 4x4 wont move when put in drive or reverse even in 4x4


Hi Don, have you checked the gear box oil level? Regards John

Sep 01, 2012 | Cars & Trucks

1 Answer

1988 Ford Ranger 4x4- gear shifter moves into gear, but nothing happens. Truck appears to be in R, D, etc, but when I push the gas pedal the engine revs and the truck doesn't move.


check your lincage to be sure ite actually going into gear you will have to block the tires and have someone shift it from p to 1 then back again, if it does this then check the fluid level but it sounds like your transmission is bad.

Aug 25, 2010 | 1988 Ford Ranger

2 Answers

Transmission problem


im sorry to say no it will not.

Mar 02, 2009 | 1988 Chevrolet Astro Cargo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

464 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...