Question about Jeep Patriot
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the blower motor is located under the dash on the passenger side of the dash.a bracket with 1 screw and 3 other screws hold the motor in the heater box. remove them amd the electrical connector and the motor an be removed
Posted on Jan 04, 2009
It is pretty easy if you have a few tools and know how to use them.
1-You need to pry off the trim bezel. There are just snaps holding it on, but be careful you do not pull too hard or scratch it. Use a plastic stick or small srewdriver covered with tape.
2-There will be 4 bolts at each corner of the radio to remove.
3-Pull out the radio and and remove all the connectors and the AM/FM antenna plug.
4-Reconnect your new radio and repeat steps 2 and 1.
I did this same upgrade on my 2005 Jeep Grand Cherokee and it worked without the need for a theft code.
Posted on Mar 08, 2009
To run any wire through the firewall, find a spot that is both reachable and unobstructed on both sides of the wall. I generally use a very short bit so after penetrating, it does not accidentally plunge into other wiring or components, or I use a collar over the bit (a small piece of tubing, leaving only 1/4" of bit exposed) I sometimes also "cheat" by poking a hole in the rubber boot where the steering column goes through.
Whenever passing a wire through sheet metal you must install a grommet. (if none are available, you can make one by using a piece of rubber tubing or the cut off end of an old tire valve.)
When tapping power from the battery, you will need to use a relay and switch attached to the "accessory on" side of the ignition switch, to prevent whatever you are installing from remaining on after the vehicle has been turned off. Use fuses in all new power sources as well to protect the vehicle and your new install from damage.
In creating a new circuit, you have the opportunity to use shielded wire, which will prevent stray electrical "noise" in your set" not a bad idea to do that.
Posted on Oct 18, 2009
Hi I have been working for jeep for 8 years and i have found that to be normal on the Dodge Calaber,Jeep Paitriot,Jeep Compass cause they are all based on the same vehicle .
Posted on Nov 17, 2009
Tips for a great answer:
Sep 04, 2017 | Jeep Cars & Trucks
Jul 12, 2015 | 2014 Jeep Patriot
Mar 01, 2015 | Jeep Cars & Trucks
Sep 15, 2013 | 2007 Jeep Patriot Sport
Feb 06, 2012 | 2007 Jeep Patriot Sport
Jan 07, 2012 | 2007 Jeep Liberty Sport
Apr 26, 2011 | 2007 Jeep Patriot Sport
Nov 27, 2010 | 2008 Jeep Patriot
Jan 04, 2009 | 2008 Jeep Patriot
269 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: