Question about 1999 Chevrolet Astro

1 Answer

I guess I did not make my self clear on my post. I used the term "holes" NOT meaning a hole in the floor but a depression where the seat connects to. When removed there is a DEPRESSION indentation there. 2 part Epoxy is not an answer! I was thinking something along the lines of a removable cover. Any thing around like that? Thanks!

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,450 Answers

There is no direct cover to snap in place you would have to make something. like cutting a rubber mat or carpet to cover back area. a bed mat works great as they are almost 1/2" thick

Posted on Oct 11, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Strap stuck under 3rd seat and seat won't go all the way in or come out...

The obvious solution is to remove the seat again then clear the belt before replacing the seat.

Jul 19, 2015 | Toyota Land Cruiser Cars & Trucks

2 Answers

How to change a front seat belt anchor

You give no make or model of car. Usuallly you have to remove the seat. You will need a trox rachet to loosen the anchor from the vehicles side. You must torque the anchor when you repace it. What happend to the old one.>?

Dec 28, 2014 | Seat Cars & Trucks

1 Answer

Whats involved in fitting genuine ford rear seats into my connect panel van?

No the mounts in the floor should be there. You can't just drill holes, the sheet metal would tear away in a crash.

May 31, 2012 | Cars & Trucks

1 Answer

Where is battery located

The battery is behind the passenger seat, hidden under the floor. Move forward the passenger seat. Then open the rear right door, clear all the floor mats on that area. You will find this somewhat square panel cover at floor level. remove the single #15 torx screw , lift up on that hole area while pulling sidewards. I hope you get lucky. Have a nice day. : )

Nov 26, 2010 | 2008 GMC Acadia

1 Answer

Trying to change beanch seat to bucket seats what will interchange

You can put any bucket seat in the car. You'll just need to add spacers between the floor and the seat rails and create holes for the bucket seats to bolt to the floor. I have a 70 El Camino street rod and have bucket seats in it. I installed the outer seat rails to the factory bolt holes the best I could and created the inner 2 holes and added a couple of spacers to level the seat and make sure it was straight.

Apr 03, 2010 | Chevrolet El Camino Cars & Trucks

2 Answers

Water in getting in floor behind driver seat

Remove the Cowl vent panel under the wipers. Each corner in the basin has a square drainage hole. Make sure they are clear with a blower or long wire. They get clogged with leaves and debris. Test it by pouring water and see if it drains under the fender. Drill additional drain holes if you want, at the bottom of this metal basin. On the back of this basin you will see a large rectangular hole where the air is sucked in for the heater. That is where the water gets into if the drainage is clogged. It then shoots through the vent under the drivers seat, aiming to the rear. that is why you get a wet rear floor.

Jan 25, 2010 | 2006 Scion xA

1 Answer

Are there any other seats that fit Ford Transit Connect other than the original ones as the seat I have is giving me back ache.

You can get another seat from a scrapyard. You will need to do some measuring to find what will fit.Pay attention to seat height above the floor as well. Too wide seats will interfere with the door. Bolt holes can be moved by drilling but always use at least 3" washers under the floor to make sure they don't pull through in an accident situation. Always be careful not to drill into brake lines or other items underneath. If you have electric seats, you will need to re-wire harness to make it work.

Oct 19, 2009 | 2003 Ford Focus

3 Answers

Wet rear floor

I had a similar issue and found that the two rear drain holes for the sun roof came off and any water was running down into the trunk and also the rear floor was always wet. I pulled the rear of the roof panel down to expose the rubber tubes, re-seated them with glue so they would not come off again.

Nov 21, 2008 | 1994 Buick Park Avenue

1 Answer

Seat trouble

Yes! There is undercoating sprayed on the underside of your jeep to protect and deaden sound. This is dried onto the threads of the bolt protruding through the floorpan. When you try to remove the bolts the friction is so great that the bolts will always snap. To remove the seat, it is not necessary to take the support plates out, only slide the seat to one side or the other to clear the hole and grommet then pull seat upward on that side to remove. Pull back the fabric at the front of the seats and you will expose the pivot rod that is inserted through the hole that I spoke of above. There may be some kind of clip in the grove that needs to be removed so you can slide the seat and rod over to the side so that it will clear the opening.

Aug 14, 2008 | 1999 Jeep Wrangler

2 Answers

I have a stron mildew smell in my car and discovered water on the passenger seat under the seat and on the back floor. I had found this before and thought something must have spilled. Now after driving...

take the cover off of the door behind the outside mirror. if there is a hole where the cable goes through.. seal it was some type of elastic caulk such as silicone. water comes in around this when it rains but generally just runs down the door post and onto the carpet

Aug 05, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
1999 Chevrolet Astro Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides