Question about 1994 Cadillac Eldorado

1 Answer

When at idle the engine shuts off or if you've let off the throttle for a few seconds..very intermitant

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

Throtte positioning sensor is at fault

Posted on Oct 10, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 VW 1.6 FSI 1KZ will shut off when at operating temperature. It will always restart and might or might not shut off again. Usually it happens after starting and pressing the accelerator. Other times it...


Have the 'Throttle' or 'Accelerator' re learn performed. Some will re learn as follows : Turn ignition to RUN with engine OFF. Push throttle pedal to the floor and hold it there for 30 seconds.

Turn ignition off and then release throttle. Start engine and allow it to idle until warm ( 80C.) Do not rev the engine or put it in gear dueing warm up. It must be allowed to warm up at idle only. When you hear the radiator fan come on, turn engine off. Wait 10 seconds and restart engine. Test drive.

This procedure MAY have caused the throttle to relearn. If the same problem is present, go to dealer or VW shop and have them 'relearn' the throttle with a scanner.

Oct 27, 2013 | Volkswagen Cars & Trucks

1 Answer

OBD2 CODE READER P0562


fully charge battery and make sure everything switched off i.e rear window demist etc and take it for a run to get it up to tempature then park up rev engine at fast idle approx 2750 rpm for 180 seconds then take foot off throttle and allow to idle for 30 seconds this will clear your catalyst and get it up to the 600 degrees needed for it to operate properly this should remove the engine warning light

Apr 21, 2013 | Mazda RX8 Cars & Trucks

1 Answer

95 ford explorer idles for a few minutes then shuts off. Only when the engine is cold. When it is warm it dosent do it.


Engine stalls cold or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Oct 18, 2012 | 1995 Ford Explorer

1 Answer

1996,Silveroda,4.3L V6,1/2 Ton,2WD,5Spd. Engine: slow(5sec.) to return to idle speed.Example; When shifting from first to second and third to fourth etc. the RPM 'hangs' at 2200RPM for...


try this remove the throttle cable from the throttle body and re-ve the engine with the just the linkage on the side of the throttle body if the engine responds like it should replace the throttle cable if the throttle still sticks then replace the throttle body......good luck

let me know how it come out.

May 09, 2011 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Idles rough.replaced #8 injector have had coil banks replaced


Possible causes: Fuel Delivery or air leak in throttle body. These engines have a problem with the plenum in the throttle body tearing and causing a rough idle and usually codes P0171 & P0174.
Spray carburetor cleaner around the throttle body with the engine idling. If the idle improves for a few seconds that's it. $30.00 and about 2 hours to repair.

Mar 22, 2010 | 2003 Oldsmobile Aurora

1 Answer

Saab 9-5 need to give alittle throttle for cold engine start


the idle air control valve may be bad or just needs cleaned out. idle air control valve acts the same as a choke. if it is messing up it will cause engine not to run right.

Jan 27, 2010 | 2008 Saab 9-5

2 Answers

I got code p2176 I changed out the tps still got same problem did not have this problem with other engine just changed engine out now cant seem to get this code off causing the car to rough idle and low...


P2176=Throttle Actuator Control System - Idle Position Not Learned
Did you use all you old sensors,or is some of them from the new engine,I would swap out the IAC sensor or check for wires not hooked up.
If it can't relearn to idle the Idle air control might be different then your old one,but its not registering with the computer

Dec 17, 2009 | 2006 Chevrolet Impala

Not finding what you are looking for?
1994 Cadillac Eldorado Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...