Question about Jeep Grand Cherokee

1 Answer

My oil pressure guage shot up immediently to the highest number it can go...i was told it was the oil sending unit but im not sure!

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Did you just change oil to a different viscosity?oil sending unit is easy fix and cheap like yours I believe is under $20.00

Posted on Oct 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

WILL CHANGING THE PCV VALVE HELP SOME WITH MY OIL PRESSURE


PCV valve isn't likely to change your oil pressure at all. All it does is vent the crankcase to your intake.

I don't know your engine, but some have both a "sending switch" and a "sensor" for oil. One for the light, one for that gauge.

You could also have a bad wire from sensing switch to gauge.

Nov 09, 2015 | 1996 GMC Jimmy

1 Answer

I have a 92 GMC K1500 SIERRA 4.3 L V-6 I am just wanting to fix my oil pressure guage and was told to change the sending unit by distributor...do i have to pull the distributor?


Not with the right tools by the Oil Pressure Sending unit (AKA OPS) tool that will fit in there you may have to contort your body a little.

Mar 18, 2015 | 1992 GMC Sierra K1500

2 Answers

Cadillac Escalade oil pressure guage stays on highest point


Make sure oil is at full level....Oil sending unit/solenoid is at fault..At times wiring connector attached to unit will become only loose....But rare..

Feb 19, 2015 | Cadillac Cars & Trucks

1 Answer

NO OIL PRESSURE READING ON DASH


remove sending unit and install mechanical gauge to see oil pressure psi if psi reads ok- change sending unit again if psi to low less then 6 replace oil pump och.

Sep 18, 2012 | 1990 Toyota 4Runner

3 Answers

How to you check to see if the oil pressure guage is bad or if there's a pressure problem itself?


Connect test leads to the guage and apply 12 volts, if the guage activates upward this works, if it's the oil preaaure in regards to the oil pump, you need to hook up a oil pressure guage.

Mar 31, 2011 | 1991 Ford F150

2 Answers

Oil pressure guage sticks


u need to have a manual pressure guage hooked up to verify that the oil pressure is within specs and comes up to spec within a few seconds, don't fool around here u could ruin the engine if the oil pump has a problem, if all checks ok replace the sender, if that doesn't do it the guage needle is sticking, I have seen both at the Ford dealer I work at.

Mar 07, 2009 | 2000 Ford Explorer

2 Answers

Sudden change in oil pressure gauge


DIAL IN CAB COULD BE AT FAULT, NEED TO GET ANOTHER DAIL GUAGE AND CONNECT TO SENDER, IF SAME COULD BE SENDER, IF STILL THE SAME, PRESSURE VALVE IN BLOCK STICKING DUE TO DIRT OR U/S, OR AT WORSE !!! ENGINE WORN, THIS WILL BE CONSTANT IN MOST CASES, FAULT IN GUAGES ARE NORM INTERMITANT.
LOTUS

Feb 02, 2009 | 1993 GMC Suburban

2 Answers

Oil pressure gauge low how do i check pressure


Install a manual oil pressure
A thumbs up would be greatly appreciated if this answer is helpful to you. oil-pressure-gauge-low-check-pressure-mwdt2vrbt00jbpmuqzzq10sf-4-0.jpg

Nov 29, 2008 | 1992 Ford Bronco

3 Answers

Oil pressure gauge


This is most likely a sending unit problem or a poor ground to the guage, try the sender first.

Sep 21, 2008 | 2002 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...