Question about 1997 Mazda MX-6

2 Answers

I have a mzda mx6 that ran last night and now it wont start. the engine rotates but doesn't fire any help would be awsome

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Sometimes it runs great the only time i have problems is when ill be driving and then it shuts off. I have found a solution on how to start the car back up again i unplug the distributer harness for a second than plug it back in. then it fires back up. sometimes it drives fine or dies again.

Posted on Jul 22, 2011

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Lossen your beather tube do not take off use a screwdriver to open it enough to spray a little bit of either.Then try to start right away if it tries to start your fuel pump in the tank is possible or fuel filter.If it ndoesn't even try pull a spark plug wire put a screw drive in it and hold it near a part connected to the motor have someone turn the key look for and arc no arc tune-up with coil pak if it has one if it doesn't remove the distributor cap without pulling any wires off have someone turn the key see if the rotor turns if not maybe timing chain or belt not sure which your car has try these things 1st

Posted on Oct 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

It starts, but why doesn't it keep on running?


Your best bet is to take your vehicle to a ASE certified repair shop .

Feb 01, 2016 | 2004 Chevrolet Cavalier

1 Answer

Car ran fine last night. but today it turns over but wont crank. sounds like no fire or fuel. its not even trying to start. any suggestions?


If you live in a cold climate your gas line may be frozen or you may have water in your gas adding gas line antifreeze may help.

Jan 16, 2011 | Mercury Marquis Cars & Trucks

1 Answer

My truck wont fire I have replaced the distributor cap rotor in distributor and ignition control switch in the distributor what know replace the computer it ran fine last night but it wont start today


first you need to test circuits see where the fire is going in and coming out when you find the spot that you have no firing coming out theres your demon replace it also check your fuse if it didnt show signs of a problem befor you parked it make sure you ignition relay or fuse isnt blown also check your ignition control moule and pick up some call them stators

Sep 29, 2010 | 1989 GMC K2500

1 Answer

HAVE SPARK DUMP FUEL WONT START SAT OVER NIGHT TRK FIRED RAN A LITTLE AND WONT START AGAIN


REPLACE FUEL FILTER FIRST CRANK ENGINE.WHEN IT DIES AGAIN GET A FUEL PRESSURE READING WITH ENGINE OFF.IF FUEL PRESSURE REAL LOW OR ZERO FUEL RELAY FAULTY OR FUEL PUMP RELAY.FAULTY.

Aug 30, 2010 | 1991 Ford F150

2 Answers

My friend pulled all the plug wires off of my 1989 MX6 gt turbo and i cant figure out how they go can you help?


Nice friend. If you can figure out which terminal on the distributor is for #1 (cylinder at front of engine), this diagram from AutoZone.com should work for you. Look for a #1 mark on the distributor.


0900c1528004e762.jpg Engine Firing Order: 1-3-4-2-nl-> Distributor Rotation: Clockwise" rel="width:950,height:660" index="0" $included="null">enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 1: 4-Cylinder Engines-Except FWD GLC-nl-> Engine Firing Order: 1-3-4-2-nl-> Distributor Rotation: Clockwise

Aug 29, 2010 | Mazda MX-6 Cars & Trucks

1 Answer

Timing setting for a automatic mazda mx6 92


The non-turbo 2.2 Liter engine?
6 Degrees.
Should be on your Emissions label under the hood.

(Firing Order is 1-3-4-2. Front of the vehicle is Number 1 spark plug. Distributor rotation is -> Counterclockwise. Spark plug gap is .044
44 thousandths of an inch)

Turbo 2.2 Liter engine?
9 Degrees. Emissions label is under hood.

(Firing Order is 1-3-4-2 Front of vehicle is Number 1 spark plug. Distributor rotates ->Counterclockwise. Spark plug gap is .044)

Aug 12, 2009 | 1992 Mazda MX-6

1 Answer

Wont start 1995 bmw 525. just stopped on me pushed out of road day later it started and ran fine for 15 min. now it wont start unless it sits for a few days and is cool outside. when it starts last few...


next time it wont start, spray some starter fluid into the air intake on the engine, if it fires then you have spark, if not.....prolly a spark issue.

Jul 13, 2009 | BMW 525 Cars & Trucks

1 Answer

Wont start


tap the solenoid on the starter probably a bad starter solenoid.

Mar 18, 2009 | 1997 Ford Expedition

1 Answer

Car won't start - battery reads 12.96 volts,


Im not an expert on it but the ground wire on the egnition might not be making contact.

Mar 13, 2009 | 2000 Saturn SW2

Not finding what you are looking for?
1997 Mazda MX-6 Logo

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8274 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...