Question about 2003 Lincoln Navigator

Open Question

My 2003 navigator makes a loud clunking sound every time i turn the the truck left or right i hear the sound even when i go over bumps or train tracks.and my liftgate would not close with key or manually i hear the hydruailc moveing but it does not close all the way

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76109 Answers

SOURCE: clunking noise when i go over bumps

have it put on a lift and the shocks and struts checked, they may be loose or defective.

Posted on Apr 22, 2009

Ad
localwonder
  • 6784 Answers

SOURCE: Loud clunking noise in 2008 Pontiac G5

HI, i would inspect the strut assembly for loose structure asap. i would also inspect the wheel knuckle and rotor and tie rod ends for loose fit as well. inspect thoroughly.

Its most likely the CV-joint assembly. the boot may have slipped off, allowing the joint assembly to dry up. i advise to inspect all the above before looking at the CV-half joint assembly and boot.

Posted on May 25, 2009

  • 105 Answers

SOURCE: loud clunking noise when i turn a corner both sides rear

check the sway bar kinks for play both rear wheels will have to even ramps work good if you have them if the is any play in the links it wil rattle also check for play in the bushings that the bar goes threw tis will also give you the noise you complain of

Posted on May 28, 2009

  • 4 Answers

SOURCE: My 2003 LIncoln Navigator liftgate is not working.

check relay and fuses,make sure that automatic liftgate is on. You will have to to the command center and go through the defaults and make sure that the system is on. if you are not comfortable doing that, disconnect battery for approximate ten minutes, this will reset the system defaults.

Posted on Jul 23, 2009

  • 3 Answers

SOURCE: 2003 where is the modules for the liftgate in a 2003 lincoln Nav

does anyone know were's the body security module on a 03 linc navigator?

Posted on Jul 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clunking when taking a sharp right or left turn


Sue, normally a faulty CV joint, $300/$400 job, may be done cheaper if you shop around or supply the part. links below tell more.
to show your appreciation press the helpful button and follow me on fixya for more tips and info.

CV Joint how it works symptoms problems

Front Axle Shaft Replacement Cost for Toyota Corolla RepairPal Estimate

How to Know If CV Joint Is Bad

http://www.autopartswarehouse.com/shop_parts/axle_assembly/toyota/corolla.html

Feb 15, 2016 | 2010 Toyota Corolla

1 Answer

2003 Isuzu Rodeo right front tire making noise when going over speed bump and loud popping noise when turning to the left


Two faults here ,one is the drive shaft universal on the end of the drive shaft and the other noise ? well could be anything and without a good look and a wiggle with a 4ft crow bar i honestly couldnt say

Jul 05, 2013 | 2003 Isuzu Rodeo

1 Answer

Loud thumping inback end when i hit a bump and ginding on turns in the front end


check the u joints in the drive shaft or the rear end needs greased,or it could be going out.have you changed both the inner bearings as well on the front end?

Aug 10, 2012 | 2003 Buick Rendezvous

2 Answers

Have a clunking noise problem coming from the back of my "03 Toyota Avalon. Every time I go over bumps it clunks. Can't tell where its coming from. Sometimes sounds likr the left side and...


Did you check your spare tire? Sometimes either it was not tightened down properly or the jack or handle works loose. Since you can't tell where the clunking sound is coming from, you need to start with the basics to zero in on the problem. You might to want to take everything out of your trunk and see if the problem goes away.

Jun 24, 2011 | 2003 Toyota Avalon

2 Answers

I need help with my 1994 pontaic grand am. I just bought the car and it has a terrible clunking noise in the front mostly when I turn the wheel. What could this be? Could it be tie rod, cv joints,shocks or...


Jack up the wheel and see if it has play up and down and left and right. Have someone watch inboard as you move it. A bad cluck will usually show itself.

Jan 12, 2011 | 1994 Volkswagen Jetta

2 Answers

2005 Dodge Grand Caravan 3.3L, hear clunking near right side of vehicle while in drivers seat facing forward. More pronounced over bumps, large or small as if something is not mated properly or...


check the stabilizer bar bushings and the stabilizer bar links. They are very common to wear out and cause clunks over bumps. In an open area and just barely moving turn the wheel to the left and right fast and far enough to get the whole vehicle rocking back and forth. If you hear it under these conditions than it is 99% of the time either the links or the bushings.

Nov 15, 2010 | 2002 Dodge Grand Caravan

1 Answer

I have a loud clunking noise that happens when I turn the steering wheel left and right. And I have a clunk when you put in to drive, but when car is warmed up it doesn't seem to be as bad. Can anyone...


The clunk you are hearing when the car is placed into drive is the "slack" in the drive train being taken out. It should pose no problem and without knowing the type of car you are driving is difficult to judge if it may be something more serious. If anything it could be the universal or CV (constant Velocity) joints making the sound from excess wear. The clanking when the wheel is turned could be CV joints getting old and needing replaced (Front wheel drive and 4WD only. Rear Wheel drive Universal Joint) or it could be excessively worn parts in the steering system. Definitely have this looked at.

Jun 19, 2009 | 1998 Chevrolet Malibu

2 Answers

A clunking on passengers side at rear


universal joints clunk,is it in the rear end then maybe it is the rear end.you kinda need to be more specific if this information doesn't help

Apr 23, 2009 | 1999 GMC Jimmy

1 Answer

There is a loud noise coming from my engine ..sometimes..


oh ok, you probably have air shocks and that is the compressor running... makes sense that it sounds with the engine off... it should not be a loud sound though, normally it's quite quiet and you only hear a faint noise... if it is that loud it's probably a bad compressor

Jan 13, 2009 | 2003 Lincoln Navigator

Not finding what you are looking for?
2003 Lincoln Navigator Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

fordexpert

Level 3 Expert

5520 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...