Question about 2005 Chevrolet Silverado 1500 2WD

Open Question

How to replace a transfer case motor on 2005 chevy silverado

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 7 Answers

SOURCE: 2003 Chevy Silverado Transfer Case

well make sure it is the tranfercase because if it was u wouldent have 4wd and u wouldent be able to drive it but it would be cheper to rebuild it but make sure first because some people are just out for your money good luck

Posted on Feb 02, 2009

  • 32 Answers

SOURCE: Chevy Transfer Case

The most common thing to go wrong with chevy transfercase is the rear tailshaft has a snap ring that breakes. Just remove the bolts holding it on and inspect the shaft and see if the snap ring is broken.Then just replace it with a new on from the dealer.

Posted on Feb 12, 2009

csmock132
  • 4669 Answers

SOURCE: Transfer case leak

You mean between the case halves? It is just silicon, no gasket. These are good for the pump wearing a hole in the rear housing and leaking oil. The cure for it is a new rear housing and a piece called a case saver that keeps the pump from doing it again. Taking the transfer case apart to fix it is easy, I can tell you how to do it.

Posted on Mar 02, 2009

  • 10 Answers

SOURCE: 1996 chevy silverado z71 electronic transfer case wont work

It's the transfer case vacuum switch. Easy fix.

Posted on Jun 17, 2009

  • 17 Answers

SOURCE: stuck in 4 wheel drive and wont come out.

hey there i cant tell you what you are missing but i can tell you how to disengage the front wheels . ok you have a vacum line that runs right under the battery and a line that comes up from the front diff. to the same place ( you may have to remove batt and batt tray to get full access to this) un bolt it and temporaly put batt and batt tray back in start it up and decompress this and see if it comes out .... you should here clunking noise if it goes back in ... if thats the case just pull that big vaccum line off .... to test get all four tires off the ground and have some one put it in drive but dont hit the gas it should turn on its own ...if that dont work check the cable that runs down to the differental

Posted on Aug 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 schevy silverado stuck in 4x4


you will need to have the transfer case control module scanned for codes.it may be a encoder motor/sensor concern or even a module concern.

Mar 05, 2014 | 2005 Chevrolet Silverado

2 Answers

Transfer case keeps blowing gaskets


I need a bit more information I take it this a 4x4 cause when you talk about transfer case it means 4x4 and am I to understand you replaced the transmission and transfer case and tail shaft?

Jan 16, 2013 | 1999 Chevrolet Silverado 1500

1 Answer

How to repair pin hole in 2002 chevy silverado 2500 transfer case


Go to Walmart to automotive and they have a tube,it's black on outside,gray in middle,you have to kneed it,mix it up,then apply over hole,it will dry hard as steel,about 4.00.

Dec 20, 2012 | 2002 Chevrolet Silverado 2500HD

1 Answer

My 2001 silverado w/69,000 miles has no light indicating 2 or 4 h


THE TRANSFER CASE MOTOR IS NOT WORKING TO INGAGE 4 WHEEL DRIVE. CHECK WITH DOOR OPEN WHEN YOU PUSH 4 WHEEL SWITCH YOU SHOULD HEAR MOTOR INGAGE 4 WHEEL DRIVE. IF YOU HEAR MOTOR BUT STILL NO 4 WHEEL DRIVE THE GEAR ON MOTOR COULD BE DAMAGED. REPLACE TRANSFER CASE MOTOR.

Jan 08, 2010 | 2001 Chevrolet Silverado 1500

1 Answer

I have a 2004 chevy silverado and the 4 wheel


the most likely cause is the front axle shift motor if bad your your front axle shaft will not lock in.if there is no shifting of transfer case there is also a electric motor that engages that in .

Oct 17, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab

2 Answers

2003 Chevy needs transfer case replaced for the 2nd time


I just had my transfer case rebuilt on my 2002 2500 silverado duramax. They told me that the spring that holds the pump inplace in the transfer case wore a hold through the case. He said this was common on these transfer cases. Chevy has not acknowledge the problem. He designed a steel plate, with flanges that holds the pump in place and will not wear a hole in the case again. And as far as the post to engage it once a month, the chain turns even when in 2WHL drive.

Jun 14, 2009 | 2003 Chevrolet Silverado 3500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

698 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...