Question about 2007 GMC Sierra 2500HD
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
go to jcwhitney they have a full line of replacement and auxiliary fuel tanks, as well has the selector valve that switch's from one tank to the other and this does the switching of fuel gauges as well, just go to jcwhitney.com or call em at 1-800-529-4486 and you may have to call em as its a 2007 may not be listed yet, check with your dealer and see if 06 is the same just in case, but with the 08s coming out already they should have it in stock, also check summitracing.com, they have a full line as well or call them at 1-800-230-3030
Posted on May 18, 2008
SOURCE: 2007 gmc sierra 2500 IAT sensor
Well, the IAT (Intake Air Temperature) sensor is located on the air intake duct between the filter and the throttle body (Assuming you have the 6L motor). The wires are easily visible at the plug that connects the sensor to the wiring harness. That's the easiest place to access them.
Posted on May 18, 2008
As long as there is not damaged areas, and all connections are the same. Should work.
Posted on Jun 23, 2009
ITS A SPIN ON FILTER, YOU NEED TO DISCONNECT THE WATER SENSOR ON THE BOTTOM OF THE FILTER, THEN USING A STRAP FILTER WRENCH LOOSEN THE FILTER AND SPIN IT OFF.
CHECK THE FILTER HOUSING TO BE SURE THE INNER FILTER SEAL ISN'T ON THE HOUSING AND CAME OFF WITH THE FILTER.
REMOVE THE WATER LEVEL SENSOR AND DISCARD THE SEAL.
INSTALL THE WATER LEVEL SENSOR ON THE NEW FILTER. USING A LITTLE GREASE ON THE INNER FILTER SEAL AND ON THE OUTER O-RING TO HOLD IT IN PLACE, SPIN ON THE NEW FILTER.
OPEN THE VENT ON THE UPPER SIDE OF THE FILTER HOUSING. PUSH DOWN ON THE HAND PUMP QUICKLY UNTIL THE FUEL IS COMING OUT OF THE VENT. CLOSE THE VENT AND PUMP THE FILTER PUMP UNTIL IT FEELS SOLID. AT THIS POINT START THE ENGINE. IF IT STALLS PUMP IT UP AGAIN AND RESTART THE ENGINE. IF YOU HAVE AN ASSISTANT THEY CAN PUMP THE FILTER PUMP WHILE THE ENGINE IS RUNNING AND QUIT WHEN YOU FEEL THE ENGINE IS NOT GOING TO STALL. ABOUT 10 TO 15 SECONDS USUALLY WORKS.
CHECK FOR LEAKS.
BEFORE STARTING THE ENGINE USE BRAKE WASH TO REMOVE THE FUEL SPILLED DURING THE FILTER REPLACEMENT. ALLOW IT TO DRY BEFORE STARTING THE ENGINE.
RATE ME PLEASE.
Posted on Jul 07, 2009
1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down
until instructed to release in step 9.
4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by
door locks locking and unlocking automatically. (If locks do not cycle after you let go,
not before you let go of the unlock button, then the vehicle has not entered programming
mode and you must start procedure over. Remove key from ignition, open drivers door
and return to step 1 ). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and
unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
13. Test remote(s).
Posted on Mar 06, 2010
Tips for a great answer:
Jul 07, 2016 | GMC Cars & Trucks
Aug 23, 2015 | GMC Cars & Trucks
Aug 13, 2014 | 2005 GMC Sierra
Sep 21, 2013 | 1994 GMC Sierra
Mar 10, 2011 | 2003 GMC Sierra 1500
Sep 09, 2009 | GMC Cars & Trucks
Apr 15, 2009 | 2003 GMC Sierra 2500HD
127 people viewed this question
Usually answered in minutes!