Question about 1998 Chevrolet Blazer

1 Answer

1997 chevy blazer with 4.3 liter v6

Using oil, no smoking, no leaks and pcv not stuck. Had a O2 fault code a few weeks ago, but I replaced O2 sensors up stream and down stream of the catalytic converter and the message cleared.

Posted by on

  • peter_zuraws Jul 24, 2008

    Hi.

    Can you help me with these problems.

    For the error vacuum leaks I checked out all hoses, I couldn't find defective or cracks. I would need a vacuum line drawings.

    I think it happens when I want to speed up or accelerate. Then the lamp flashes. I watch this phenomena many times.

    For the cylinder #6 misfire, I think it happens when I drive through uneven surface or when there is more vibration coming from the street surface. The the lamp flashes also.

    The shorted wires, the error code is low pressure transmission fluid. Also when I mistaken shift to Gear #3, that wants to start the engine, even though the engine is running already.

    Breaks all are making sound when starting the drive, it isn't not very loud, but always it is now. I check the temperature of the tires, nothing is hot. The driver side is little more warmer then other whiles. After ssome distance the sound goes away.

    Have you had this kings all problems before? What a wonderful car Chevy made.

    Regards

  • Danny Taylor May 11, 2010

    how much oil

×

1 Answer

Could be valve guides r worn n letting oil drain into cylinders

Posted on Jun 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 Chevy blazer with a 4.3 vortec motor it has a small leaking head gasket how long can I drive it until I have the money to fix it.


Troubleshooting a Blown Head Gasket (GM 4.3L, 5.0L, 5.7L)

troubleshootmyvehicle.com > GM > 4.3L, 5.0L, 5.7L
Mar 28, 2011 - There are so many ways to test for a blown head gasket on your 4.3L, 5.0L, 5.7L GM van (or mini-van, pick up, SUV) that it can get confusing.

Chevy Blazer Coolant Leak (Intake Manifold) - YouTube

? 4:33
https://www.youtube.com/watch?v=SC4VXdt5wiE
Oct 9, 2013 - Uploaded by eyetotheworld
I have localized a coolant leak on my 2003 Chevy Blazer to thegasket of the intake ... Turns out that this is common among this particular engine both in the v6 & v8 sizes. ... The guy has been generous to detail his projects. ... 98 S10 Vortec V6 4.3 IntakeGasket Replacement Part 1 of 5 - Duration: 18:17. by ...

Chevy 4.3l v6 oil leak issue 2001 Xtreme Blazer - YouTube

? 6:11
https://www.youtube.com/watch?v=Y8Ogd5voIYs
Nov 12, 2011 - Uploaded by smiatacz
This darn little engine just keeps going. ... I have a 2003 chevy blazer and the oil cooler line from the oil filter to ... I have a 95 Chevy s10 v6 vortec 2wd that is slightly dripping oil out of agasket ... I'm having same problem 2001 Chevy Blazer 4x4 (not xtreme) not sure if those same bolts are missing on mine.

Dec 28, 2015 | Cars & Trucks

1 Answer

When starting toyota fortuner 3.0 liter blowing blue smoke what is causing this


It is oil smoke. The most common causes are worn valve guide seals, a faulty PCV valve, or, worn or broken oil control rings on the pistons. Only 1 or 2 cylinders need be at fault.

Check the PCV valve for fouling. Have a compression test done. If readings are low or irregular, pour a few ccs of engine oil into the suspect cylinders thru the plug holes. If compression readings then improve, it is probably the rings at fault.

Less common causes are worn big end bearings spraying excessive oil up the cylinder walls, or a leak from the head gasket, oil to cylinder.

Apr 30, 2014 | 2004 Toyota Camry

1 Answer

Code p2197


disconnect the sensors cancel the codes start engine if the codes don't come back replace sensor

Mar 26, 2014 | 2005 Mazda MPV

3 Answers

2005 mazda 3 2.3l that is burning oil (no leaks)


possibly the pcv but check if your cars exhaust smoke is blueish or white in color if it does and your car doesnt have an oil leak then sure its burning engine oil along with fuel, the piston rings is defective, since you replaced engine oil the additive that the owner has put with the oil to prevent blowby is gone thats why it starts burning oil.....

Apr 14, 2010 | 2005 Mazda 6

2 Answers

I have a 1997 chevy silverado putting out a code of p0174 what does this mean?


Basically this means that an oxygen sensor in bank 2 detected a lean condition (too much oxygen in the exhaust). On V6/V8/V10 engines, Bank 2 is generally the side of the engine that doesn't have cylinder #1.

A code P0174 may mean that one or more of the following has happened:

•The MAF (Mass Air Flow) Sensor is dirty or faulty. Note: The use of "oiled" air filters can cause the MAF to become dirty if the filter is over-oiled. There is also an issue with some vehicles where the MAF sensors leak the silicone potting material used to protect the circuitry.
•There could be a vacuum leak downstream of the MAF sensor.

Possible solutions include:

•In the vast majority of cases, simply cleaning the MAF sensor does the trick. Consult your service manual for its location if you need help. I find it's best to take it off and spray it with electronics cleaner or brake cleaner. Make sure you are careful not to damage the MAF sensor, and make sure it's dry before reinstalling
•Inspect all vacuum and PCV hoses, replace if necessary
•Check for a dirty fuel filter and proper fuel pressure

Jan 10, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

I have replaced all 4 ox senors before I replaced intake man. gaskets. It is a 97 chevy W/Truck with a V6 auto, auto trans. 2WD. now service engine soon light came on after about 200 miles, it will go off...


First did you clear all the fault codes after your repairs? The reason I ask is po131 is bank one oxygen sensor, po174 is engine lean from faulty oxygen sensor, and po171 is engine lean condition, possibly from vacuum leak (intake manifold gasket?), pcv valve,etc. To check for vacuum leak at intake, start engine and gently spray starting fluid around intake gasket. If rpm raise slightly while doing this then there is a vacuum leak(stay away from air filter intake and housing though), and the gasket will need to be replaced again.

Jan 09, 2010 | 1997 Chevrolet C1500

1 Answer

Pcv valve and hose assembly replacement????


the pcv vaulve is a6.00 part at the parts store and only takes a few sec too install
someones treying too rip you off

Feb 20, 2009 | 1999 Chevrolet Camaro

1 Answer

O2 sensor problem


I have a 97 gmc sierra .This truck is the same as the chevy ok.Its a 350 5.7 liter 4x4 Z71.I took it to auto zone which was my first mistake.They put it the scanner and said bad O2 sensor.Ok so which one is it i said.They dont know.Well there four (4) O2 sensors in this truck i hope you know that.I had to replace all four of them before i had to take it to a real shop.It seems the fuel pump i replaced a week earlier with an auto zone fuel pump was bad.Ive changed my feul pump 4 times now and have 235000 miles on still running.You need to get your fuel pressure checked.It should be 65 psi to start it and 55 psi to run it.If the pressures are good it could be a different O2 sensor or maybe the mass air flow senor.My last option would be the fuel pressure regulator because it seems to be a waste of time and money.I would get that fuel pressue checked first.Good luck.

Oct 30, 2008 | 1997 Chevrolet K1500

1 Answer

Engine oil


It is not unusual for an older truck to be burning a little oil. It is burning very little so you will not smell burnt oil or see blue smoke in the exhaust. But the oil burn does add up and you may notice a drop on the oil dipstick after a few weeks. On a 9 year old truck under normal working conditions will burn a little oil. If you are having to add 1 liter between oil changes, that is ok, just shows normal engine ware. 2 Liters is acceptable between oil changes if the truck does a lot of heavy pulling or work. 3 or more liters indecates a problem, but at that rate, you should be able to smell oil and see blue smoke.

Oct 30, 2008 | 1999 Chevrolet Blazer

1 Answer

1997 blazer, 4.3 v6


whats the question? here?

May 31, 2008 | 1998 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

549 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...