Question about Chevrolet Cobalt

1 Answer

How do i get into the fuse panel without breaking it?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 233 Answers

Remove the cover...

Posted on Oct 10, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My rear wiper for my Isuzu rodeo 2000 suddenly stop work, what could possible be the cause? I have check my fuse and the motor and those are good.

Pull the interior panels and trace the wire loom. Focus on the area where it bends with the hinges. Many vehicles are prone to wire breakage here. If you don't see obvious, broken wires, probe them with a voltmeter as they can sometimes break inside without breaking the insulation.
Once you've found any breaks, reconnect with crimp connectors and wrap with electrical tape to secure everything.
good luck.

Dec 02, 2016 | 2000 Isuzu Rodeo

1 Answer

How do I replace my brake light fuse?

The break light have a fuse in the fuse box. If this blows then both break lights will go out. Its usually under the hood in the fuse box or its in the panel on the right or left inside where the front doors close. Some cars have a fuse box under the steering column. If this is not the problem then it may be a break light switch. These are located just up the break petal. Its a switch that gets released when the break is pushed with your foot.

Jul 16, 2014 | 2005 Chrysler Sebring Sedan

1 Answer

Buick parkave 1999 rear defroster not working

ther is a break in the window grid. take a closer look

Nov 21, 2013 | Cars & Trucks

1 Answer

Where is the break light fuse on a 2003 dodge stratus

Check the power distribution box by the battery, or under the hood. The underside of the box cover should show the fuse location and its application. If not there, it would be in the fuse panel in the car. Owner's manual should tell location, if the panel cover doesn't show a diagram.

Jul 31, 2012 | 2002 Dodge Stratus

2 Answers

Brake lights out


If your break lights are out, most likely it is not a bulb, because chances are slim that both would go out. And most likely it is not the connections where the break lights are because again, chances slim that both would go out same time. So, this brings us to fuse panel or the break relay. So, look in your owners manual it should tell you were your fuse panel is and what fuse is for the break lights. Most likely it would say break lights on the inside cover of the fuse box to tell you which fuse it is. Then if it is blown, you need to replace it with same amp fuse. I hope this helps, but I am pretty sure it is just a fuse. Thanks Mike

Sep 17, 2011 | 1991 Toyota Camry

1 Answer

My lighter in my car is not getting power. and its not my fuse.

It's 999 times out of a thousand a fuse! When you use non factory accessories ( phone / i pod type chargers) there is every chance you'll eventually blow a fuse. Wires don't break without tampering and I assume you havn't tampered with the dash cowling or similar mounting panels on the car ! Give it one more check (test light/ circuit tester) .
Good Luck

Dec 13, 2010 | Kia Sephia Cars & Trucks

1 Answer

How do you get the door panel off without breaking the snaps

Some will always break. You take them to an auto body supply house,to look for replacements. Will have to buy a box of about 20
There are tools to get under the panel and sort of around the clips.(Christmas Trees) to help wiggle them out.

May 16, 2010 | Cars & Trucks

1 Answer

My brake lights wont come on..ive changed the bulbs and they still dont work...i cant find the brake light FUSE... 1993 TOYOTA CAMRY

Break light fuse would be in your main fuse panel, most likely under the dash somewhere on the drivers side. A "key" of sorts may be on a sticker near the panel or molded into the plastic cover. If not a key should also be in the vehicle manual as to what fuse is what. Next thing is the break light switch attached somewhere under the dash to the break peddal might be faulty. This is most likely a plunging kind of switch that activates the break lights as the pedal is being pressed. Good luck!

Nov 01, 2009 | 1993 Toyota Camry V6

1 Answer

Where is located the fuse or fuses from rear and break lights ,please. toyota sienna 98. is without rear and break lights

Remove push-on plastic nut beside parking brake. Detach side kick panel. Remove lower dash panel. Three screws, two bolts. The fuse diagram is on the back of the panel. That's for a 2000. Think it has the same body style.

Feb 18, 2009 | 2000 Toyota Sienna

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides