Question about 1988 Mercury Tracer

Open Question

How do I change the water pump on an 1988 Mercury Tracer

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Mike258
  • 1498 Answers

SOURCE: serpentine belt for 1998 mercury tracer

Hey there MSM,

  • Get a 14mm or 9/16" socket and a long handled ratchet or breaker bar.
  • Get the belt around all the pulleys except the A/C compressor or Alternator. The routing diagram is on one of the radiator supports.
  • The tensioner pulley is near the Alternator toward the center of the engine. It's on a spring loaded arm. Get your socket on the center nut of this pulley.
  • Slowly pull the ratchet toward the center of the engine. The pulley will pivot on the arm allowing you to get the belt on the final pulley.
  • Slowly release the tension.
  • You're done
Mike

Posted on Dec 14, 2008

  • 1201 Answers

SOURCE: Fuel pump reset switch

I don't have my manual right now, but check in the back compartment, right or left side behind a panel, or up front behind one of the kick panels.

Posted on Mar 30, 2009

MNfisherman
  • 11896 Answers

SOURCE: replacing door speakers in a mercury tracer

first remove any screws in door panel, then remove lock and window controls, then take flathead screw driver and SLOWLY pry panel off door. You now will have access to speaker. Speaker is held by 4 screws and wire harness that unclips.
Reverse procedure to reinstall. Door panel pops back in the wholes to reattach

Posted on Jun 27, 2009

  • 7353 Answers

SOURCE: I think my fuel pump went out..98 mercury tracer.

you better KNOW its bad... before you replace it, because its a big job, and they wont take it back after you installed it. the gas tank will have to be removed. after you have verified that the pump has power and ground, and it still does not operate THEN it will need replacement.

Posted on Oct 01, 2009

ZJLimited
  • 17970 Answers

SOURCE: belt routing diagram for 1997 mercury tracer?

Check this...

f307936.gif

Hope helps.



Posted on Jul 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 Mercury Tracer running hot


"rule out" questions - is coolant level OK? Any leaks, especially around the water pump? Has the system ever been flushed. out? If this is the original radiator, it could be clogged. Is the thermostat installed correctly with spring end toward the engine?

Mar 22, 2014 | 1993 Mercury Tracer

1 Answer

How do you change the water pump in a 1997 mercury tracer


I have the same problem few days ago, and still didn't find any solution. Can any one please help?????17

Jul 28, 2011 | 1997 Mercury Tracer

1 Answer

How to remove rear brakes and install them on a 1988 Mercury Tracer. Also how to bleed the brake system.


Without being hurtful in any way

If you have to ask a general question
about brakes,that implies you have never
done brake work,I would suggest you don't

Use the repair shop and watch as they perform the job

Feb 12, 2011 | 1988 Mercury Tracer

1 Answer

Do you have to pull the engine yo change the water pump on a 94 Mercury Tracer


no you have to take the timing belt off and there is a pulley connected to the water pump and that should give you access to water pump hope this helps the water pump will look almost flush with the engine its a little thing nesr bottom of the motor

Sep 11, 2010 | 1994 Mercury Tracer

1 Answer

My battery keeps going dead it is new and so is the alt. on my 1988 mercury tracer


you have a power drain with key off. Need to see if you have a glove box light on, a hood lamp, trunk lamp on etc.

Jun 03, 2009 | 1988 Mercury Tracer

2 Answers

1988 mercury tracer


Check the timing belt

Oct 21, 2008 | 1988 Mercury Tracer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...