Question about 1995 Porsche 911

1 Answer

95 911 wing is stuck in the up position - 1995 Porsche 911

Posted by on

  • lpsnider Dec 20, 2010

    Thanks it was just a matter of cleaning the contacts back by the wing motor. All I did was scrape them a little with a flat screw driver. That was a few months ago but appreciate the reply.


    Larry

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Porsche Expert
  • 330 Answers

Hello there
Your problem could be the rear gear is broken.It is located on the left inside your tail under the plastic cover.To remove use phillips screwdriver and try to diconect the gear cable.If the wing goes down it is the gear.If not the gear try to lok for an relay which is on pass.side under the dash-behing knee pad.This relay controls the manual and an electric operation.
Part number 964 618 212 00


ivan
proporsche@yahoo.com

Posted on Dec 20, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Please can you help. on our Toyota Sacio the wing mirror motor is not engaging and wont stop running.


you can try disconnect battery and see if it resets or that motor drive is stuck on , BUT before you disconnect battery get and use a memory saver (its a small device that plugs into cig lighter or power outlet) it keeps you computer memory from being lost.
Woody

Sep 10, 2014 | Cars & Trucks

1 Answer

I have a 93 caddilac fleetwood and the injectors


Both Injectors? If not, then just replace the one that is leaking. If they are both doing it, then check the computer or for faulty wiring. When the key turns on the fuel pump comes on, If an injector is stuck open then it will dump fuel into the engine as it is doing. If they are both doing it then something is telling it to, thus computer or wing problem.

Aug 31, 2014 | Cars & Trucks

1 Answer

Subaru Fuse


use your car manual and locate the fuse box then use the diagram on the fuse box to show you which fuse is for the lighter and remove it and fit a new one and you should be good to go

May 22, 2012 | 2002 Subaru Legacy

1 Answer

Wing_Mirror_Problems


Shaun,
I've never had to disassemble a Jeep power mirror. One of two possible problems here. Depends on how Jeep conveys the power to the "wing". If they use brushes and contacts, it may just be that the brushes got dirty when you folded it in [onto a corroded contact area] If this is the case, spray some penetrating oil into the gap between the wing and the base. Then fold and unfold the wing several times to clean the contact. Make sure that you have the wing pulled all the way out. There should be a detent that you can feel.
If they use a wiring harness going up all the way inside the wing, one of the wires has broken. you would need to remove the mirror, disassemble it and repair the damaged wiring.
Charlie

Nov 08, 2011 | 2000 Jeep Cherokee

1 Answer

Loose wing mirrow


Check this guide as reference for solve ypur problem; this is one DIY about replace Wing Mirror...
1.- Disconnect your negative battery cable, if your Ford Focus has power side mirrors. If it has manual side mirrors, disconnecting the battery is unnecessary.
2.- Pry off the wing mirror's inside sail panel (shaped like a triangle). Insert a trim panel tool between the door skin and the plastic panel to pry it off.
3.- Carefully pull the sail panel away, minding the wiring if the mirror is power-operated. Unplug the electrical harness and set the panel aside.
4.- Open the door and hold the outside part of the wing mirror steady. Remove the mounting bolt with a socket wrench, and then remove the mirror screw with a Phillips screwdriver (the mirror bolt and screw is visible with the panel removed).
5.- Pull the wing mirror assembly from its mount (from the outside). Insert the replacement mirror assembly in place; tighten the bolt and the screw.
6.- Attach the wiring connection to the replacement mirror. Position the sail panel in place and push it against the door to snap it back on.

Hope helps (remember comment and rated this). TY for using Fixya.

Jun 26, 2010 | 2000 Ford Focus

1 Answer

One of the two wings that pop up, while you are taking the top up and down, snapped. how much will this cost? the wing doesn't move up or down anymore.


interesting you had this issue. Same thing here, but my wing was getting "stuck" trying to come up by a piece of the car! Thought it strange fix, but the dealer "burned out" some room for it and it works now. any chance that same side had window regulator issues because I think mine was a result of somebody not fixing that correctly.

Mar 25, 2010 | 2004 Volkswagen Beetle

1 Answer

My 350z wing mirrors dont work wen in reverse can u plz help


350z's have electronic tilting wing mirrors with an on/off position for reverse gear. Some people don't want the mirrors to be adjustable while backing so Nissan put an optional switch on them for enable/disable while the shifter is in reverse position. That is how the car came from the factory. Not sure where that switch is located.

Nov 13, 2009 | 2004 Nissan 350Z

1 Answer

X5 wing mirrors wont stay retracted


the micro swithes inside the mirror unit(s) have probably broken inside

Jun 12, 2009 | 2005 BMW X5

1 Answer

Power window broke, stuck up need temporaily lower then back up


you can disconnect the motor and the gear and the window should slide down.. if you can't access that.. you can force the gears to turn

Apr 05, 2009 | 1999 Ford Explorer

Not finding what you are looking for?
1995 Porsche 911 Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Porsche Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

905 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...