Question about 2000 Hyundai Elantra

1 Answer

My tail lights illuminate bright like I'm braking when I turn on the parking lights (and don't have my foot near the brake). What would cause this?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

The rear brake light/park bulb was installed incorrectly make sure the alignment pins on the bulb line up in the light socket

Posted on Oct 14, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dim tail light.


Brake light switch under dash and actuated by the brake pedal lever is out of adjustment or faulty. Adjust or replace it and you'll have your brake lights back. The dim tail lights may just be that you have possible replaced them with the wrong bulbs or the ground to light housing is faulty.

Jul 11, 2017 | Cars & Trucks

3 Answers

Tail light dont turn off there on even when i turn the jeep off


no jeep stated, no year stated.
wow.
tail = parks
jeeps can have lots of PARK lamps, only 2 on tail
the park relay is bad (stuck)
if car drives perfectly, but you never said that.
if all else works that tells my battery voltage is OK
and that the BCM didnt go batty, (on low volts failures)

pull there relay, see?

this jeep? has tails, rear, only.


wow-umgzikckord4pbcxjbxc4rwc-2-0.jpg

Feb 10, 2017 | Jeep Cars & Trucks

2 Answers

1994 dodge dakota my headlights and tail lights and brake lights don't work my abs and parking brake lights are on my dash lights don't work either I replaced the headlight switch and still no


These are all different circuits. The brake lights are on a 10amp fuse - the headlights are on a 50amp fuse - and the parking and dash lights are on a 20amp fuse.
Do you have power going into the headlight switch and the brake light switch ?

Jan 29, 2013 | Cars & Trucks

1 Answer

Brake lights


Have you checked for a burned out fuse? Tail lights also (typically) have two filaments. One for parking lights and another for when the brake switch near/on the brake pedal is in the on position. This switch is another possible source of your lack of illumination. Reverse lights should/might be on a different bulb. If you have already verified that the bulbs and fuses are good, try changing/adjusting the physical switch at the brake pedal.

Dec 30, 2011 | 2005 Pontiac Bonneville

1 Answer

I have a 2000 Jeep Wrangler Trouble Symptoms: -When lights are on, brake lights (all three) remain illuminated and only flicker when brake pedal is depressed. Facts: -With lights off, dashboard lights...


sounds like wireing is shorted together. you need to trace down wires and check for bad spots in wireing. also be sure and check plug if you are set up for trailer lights.

Feb 13, 2010 | 1990 Jeep Wrangler

1 Answer

Tail light on 2004 Explorer will not go off even after car is in park and ignition is off. Could be brake light as there is no change in illumination when brake is applied


There is a switch under the dash that operates the brake lights when you apply the brakes. It is normally held in place by a bracket that has "lock nut" on either end of it. Sometimes you can inadvertently pull the switch out of place if you catch your foot on the brake pedal.
If you can, check to see if the lock nuts are still in place against both sides of the bracket.

Dec 13, 2009 | 2004 Ford Explorer

1 Answer

When brakes are applied parking and dash board lights come on.when headlights are on,brake lights and tail lights do not work.very first symptom was an intermittent tail or brake light out indicator...


you might have an open ground wire on your brake/tail lights .. when you apply the brakes then power would flow thru the brake light (not see ground) so would then provide power backwards thru the parking light (common ground open) to all the other things connected to the parking lights .. like the other parking lights and dash ... when you turn power on to those things (headlights on) then there is 12 volts on both sides of the light .. thats why the lights quit working ... if the missing ground is the problem then most of the lights that are improperly turning on should be at a lowered brightness level.. interesting problem .. its also possible to have a brake light bulb that has the common ground open inside or not making connection with its socket .. i would start by removing the brake lamps and see if the problem goes away .. if it does look for a broken ground or damaged lamp ..

Oct 12, 2009 | 1994 Honda Accord

1 Answer

1999 Toyota Corolla Seca - hatchback. the tail


If you put your foot on the brake, the tail lights and parking lights will still come on. Possibly your brake is sticking. Check to see if it is and if it is put WD40 for a quick fix. See a tech for them to fix your brake alignment. Good Luck!

Jul 26, 2009 | 1999 Toyota Corolla

1 Answer

Brake and dash lights no working


Had a similar problem and fixed it by installing a new headlight switch / turn signal lever. Hope this helps.

Apr 07, 2009 | 1995 Nissan Pathfinder

2 Answers

Tail lights wont work


sounds like ground problem- remove tail lights and look for wires going to body -remove screww clean grounding area and replace- both sides. You did not say whether the lights work when car is off? With car off and brake pedal pushed is there any brake lights ? If not procede with above.

Nov 07, 2008 | 2003 Chevrolet Cavalier

Not finding what you are looking for?
2000 Hyundai Elantra Logo

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...