Question about 1996 Chevrolet K1500

1 Answer

When it gets 1400rpm it starts to cut out give it a little gas &it goes some times it back fires

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 84 Answers

Sounds like your timing is a little off, have it checked and adjusted. May also be a bad rotor cap and button.

Posted on Oct 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1998 tj jeep is hard to start, i replaced fuel pump because the filter had come off the end of it. and replaced the crank position sensor because i got a code po320 It ran fine for a while and then...


try to give it a little more gas it sputters an back fires! In the first place your not giving it more gas unless it running ! If just cranking all your doing is letting more air in . Your vehicle has electronic fuel injection , not a carbuerator . Till the computer see's a RPM over 300 rpm , it's going by programming installed in the PCM - engine computer . It sputters an back fires because of a lean condition , low fuel . When starting a fuel injection engine you don't touch the throttle pedal . And if you were to push it to the floor and hold it , the computer goes into clear flood mode. If the vehicle were flooded that is what you would want to do .
P0320 OBD II Trouble Code
You may have O2 sensor problem or a map sensor or coolant temp . sensor . Your best take it an have a qualifiedd repair shop diagnose it .

Apr 27, 2017 | Cars & Trucks

1 Answer

When i start it for the first time everyday it idels ruff and when i give it gas it just falls flat on its face. its like it only gets enough fuel for an idel even though the gas pedal is on the floor. but...


Try changing the pickup coil in the distributor? This one had a lot of mechanics baffled, the guy at Auto Zone nailed it on the head. Cheap fix if that is it. Always overlooked

Nov 26, 2010 | 1992 Chevrolet C1500

1 Answer

My Subaru legacy grandwagon has started cutting out at idle speed (intermittently) & also sometimes if you go on a short errand then it wont start when you get back in the car. Engine turns over...


You could have a number of problems. First do a complete tune up, proper timing, new plugs etc.

Turn the key and do not give it gas. If it starts slowly give it gas and let me know what it does. I suspect it will cut out. In that case, you might have bad injectors. Let me know if I can be of further help

tom

Jun 20, 2010 | 1992 Subaru Legacy

1 Answer

I have an 1999 ford rsnger that wont start


DOES IT HAVE POWER/ A GOOD BATTERY? IF SO CHECK & SEE IF IT IS GETTING FIRE OUT FROM THE COIL PACKS,THE QUICKEST WAY TO SEE IF IT IS FIRE OR A FUEL PROBLEM IS SPRAY A LITTLE STARTING FLUID IN THE THROTTLE BODY,& IF IT CRANKS & THEN CUTS RIGHT BACK OFF ITS A FUEL PROBLEM,FUEL PUMP FUSE,FUEL PUMP RELAY,OR FUEL PUMP,& OR FUEL FILTER, IF ITS NOT GETTING FIRE IT COULD BE A CRANK SENSOR, A CAM POSITION SENSOR,COIL PACK(S) OR A FUSE OR RELAY.

Dec 05, 2009 | 1999 Ford Ranger SuperCab

1 Answer

1994 Explorer running rough


I would get the timing checked . backfiring is a real good indicator of that problem

Mar 16, 2017 | 2003 Ford Explorer

1 Answer

Lack-of-power


Pls Check Your Carburator Settings & Ignition Timing Settings.

Jun 11, 2009 | 1995 Pontiac Bonneville

2 Answers

95 Jeep spitting and sputtering


it sound like you have a problem in the air intake is there any air leaks there .

Mar 09, 2009 | 1995 Jeep Cherokee

1 Answer

I have 1993 nissain altima that is could cut off and is having a hard time getting it start back up while in the process of doing that it began to drain my battery and i have to jump it off. replaced the...


ijust had the same problem with my 93 it was the distributer itself.Once the new one was put on it fired right up/Make sure who ever does your work also cleans or replaces your plus they get fouled real quick from trying to start.

Jan 23, 2009 | 1994 Nissan Altima

1 Answer

Hard start and stalling with back fire when give it gas fast


sounds like you have spark plugs mixed up ever had them replaced

Nov 16, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
1996 Chevrolet K1500 Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...