Question about 1986 Dodge Ramcharger

1 Answer

1986 dodge ramcharger

The correct steps to transfer from 2 wd to 4wd.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 51 Answers

I'm assuming yours still has the stock CAD system with auto hubs. You will need to be in drive, going less than 35 mph to shift in and out of 4HI on the fly. Your RC must be stopped to go in and out of 4LO. You can visit Ramchargercentral.com to learn more...the members over there are awesome!

Posted on Jul 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1986 ramcharger starts but backfires bad what is the correct order of spark plug wires too


cap rotor bad timing it might run off the temp sensor no codes on this model you need to turn ign key on off 3 times and the last time leave key on engine off count the flashes on the dash you should have 1flash then 2 flash then the codes after done will flash 3 flash 3flash

Nov 03, 2013 | 1987 Dodge Ramcharger

1 Answer

Need to find a repair manuel for 1987 Dodge Ram Charger transmission


What you want/need is a Factory Service Manual for the '87 Ramcharger, it covers each transmission in depth.
Which, if i remember correctly, there were 4 transmissions available in 1987. The Torqueflite 727 3-Speed Automatic (Found in 2WD and 4WD Ramchargers), the 904 Torqueflite 3-Speed Auto (2WD only), the New Process 435 4-Speed Manual Transmission (2WD & 4WD) and the Chrysler A833 4-Speed Manual (2WD only)

Aug 23, 2011 | 1987 Dodge Ramcharger

1 Answer

I have a 1986 ramcharger royal se w150 4wd. What type of front axle does it have? dana 44,dana 60, automatic or full time locking hubs?


should be dana 44's.... the is a front axle disconnect on the tube operated by vacuum ...when shifted to 4wd, the slide engages the 2 axles to make one

Sep 17, 2010 | 1986 Dodge Ramcharger

1 Answer

Transfer case from 86 ramcharger w/ 727 interchange w/ 84 w/ 4-spd. Both NP 208 D w/ same ratio


Yes you will need to change the adapter fron the 86 to the 84 transfercase its a simple bolt on part

Jul 13, 2010 | 1986 Dodge Ramcharger

2 Answers

What is the automatic transmission fluid capacity for a 1988 dodge ramcharger 4wd 5.2L engine


To find the correct specification, we need additional information about your 1988 Dodge Truck Ramcharger 4WD 5.2L FI 8cyl:

A999/32RH Transmission model
Transmission Fluid Capacity 4 Quarts
Application:
Fluid and filter change

Transmission Fluid Type 06810

Application:
With automatic transmission
Note :
Castrol ATF +4 ATF


Transmission model A727 or 36RH
4 Quarts
Application:
Fluid and filter change
With lock up

Transmission Fluid Type 29201

Application:
With automatic transmission
Note :
Coastal(R)+4(R)ATF

06810
Application:
With automatic transmission
Note :
Castrol ATF +4 ATF

VV346
Application:
With automatic transmission
Note :
Valvoline ATF+4 Full Synthetic ATF


Lubrication chart for 1985-88 100, 200, 300 4WD

143b247.jpg

Hope helped (remember rated this post).

Feb 25, 2010 | 1988 Dodge Ramcharger

1 Answer

In my 1986 Dodge Ramcharger the transmission No reverse


Pull the bottom pan and check the Rear (Reverse) Band.

May 11, 2009 | 1986 Dodge Ramcharger

1 Answer

Electric door locks dont work 1986 dodge ramcharger


Probably the solenoid. A thread search at Ramchargercentral.com will give you all of the details on how to diagnose and repair them.

Apr 29, 2009 | 1986 Dodge Ramcharger

1 Answer

Over charge of battery in a 1986 dodge ramcharger


had same problem it was fuseable links by battery old and brittle

Dec 03, 2008 | 1986 Dodge Ramcharger

1 Answer

1986 dodge ramcharger


Check for power with 12VDC test light at switch down at the brake pedal. Should have power on one terminal without pressing pedal, then press pedal and see if power going through switch to other terminal. If going in but not coming out, replace switch. Can use jumper wire between the 2 connectors to confirm brake lights come on.

Oct 22, 2008 | 1986 Dodge Ramcharger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...