Question about 2002 Ford Windstar Cargo

1 Answer

2002 windstar po133 and po153 codes on

No vac leaks found changed fuel regulator any ideas

Posted by on

1 Answer

Speed sensor

Posted on Jul 01, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have codes po130, po133',po150,po153


Unlikely that both sensors are causing the exact same codes. First I would check for vacuum leaks. Then check the wiring from the sensor to the ECM and fuse panel. Pull fuses and relays for the entire system. I have fixed many cars because of corrosion at the fuse or relay. Do this to every panel you have.

Aug 24, 2015 | Cars & Trucks

1 Answer

My check engin light came on the codes came up as po133, p1000 what do i do to fix my car is a 1998 ford windstar?


A code P0133 may mean that one or more of the following has happened:
  • The oxygen sensor is faulty
  • The wiring to the sensor is broken / frayed
  • There is an exhaust leak
the problem is more than likely the front Bank 1 oxygen sensor. You will likely wind up replacing it but you should also consider these possible solutions:
  • Check and fix any exhaust leaks
  • Check for wiring problems (shorted, frayed wires)
  • Check the frequency and amplitude of the oxygen sensor (advanced)
  • Check for a deteriorating / contaminated oxygen sensor, replace if necessary
  • Check for inlet air leaks
  • Check the MAF sensor for proper operation
  • code p1000 refers to emission monitors not fully run and requires a couple of drive cycles from cold start to fully warmed drive cycle at different speeds.

Oct 10, 2014 | 1998 Ford Windstar

1 Answer

Getting codes po171, p0174 and p0128


Code 171 is fuel system too lean bank one, and 174 is the same for bank two. Usually a vac leak or low fuel pressure.
Code 128 is for the engine not reaching normal operating temp. Usually a thermostat problem.

Jan 24, 2014 | 1999 Ford Windstar

1 Answer

Ihave a 2003 Jaguar S-Type, What do PO133, PO153 and P1000 codes mean? Afriend said oxygen sensors; how to change the oxygen sensor for a 2003 Jaguar S-Type?


You might check this site out for Jag codes. Oxygen sensors can be a sticky job, they're screwed into exhaust and can literally weld themselves in place. Plus in most cases you need special wrench/socket to get around the sensor. (they can be a real pain)

http://www.obd-codes.com/

Jan 04, 2011 | 2003 Jaguar S-Type

2 Answers

2007 tiburon po153 engine light 27000 miles?


P0153 O2 Sensor Circuit Slow Response - Bank 2 Sensor 1
For the 6 cylinder engine I got the above result which indicates an O2 sensor is bad or contaminated.

Would change the O2 sensor.

Oct 29, 2010 | 2007 Hyundai Tiburon

1 Answer

Locating & replacing the MAP sensor in a 2000 Saturn SL-1


CODE PO133 IS HO2S - 11 BANK 1 SENSOR 1 SLOW RESPONSE CONDITIONS. POSSIBLE CAUSES THE EXHAUST LEAK PRESENT IN THE EXHAUST MANIFOLD OR PIPES.FUEL SYSTEM IS TOO RICH.FUEL PRESSURE TOO HIGH FUEL PRESSURE REGULATOR LEAKING OR ONE OR MORE FUEL INJECTORS.STICKING LEAKING.HO2S ELEMENT IS SILICON WATER OR FUEL CONTAMINATED OR IT FAILED.TP SENSOR ELEMENT BROKEN.CAN CAUSE FALSE ACCELERATION EVENT.OR THE PCM HAS FAILED.

Jan 12, 2010 | 2000 Saturn SL

3 Answers

FORD WINDSTAR 3.8 V6 ENGINE IDLE ROUGH UP AND DOWN WHEN STANDING


Usually the fuel pressure regulator vac. hose pops off? If not listen for a slight whistling noise (vac leak).

Apr 23, 2009 | 1995 Ford Windstar

1 Answer

Rough idle/stall after hot soak 02 windstar


Check the fuel pressure regulator for leaks, if that isn't it, it might be a leaking fuel injector.

Feb 27, 2009 | 2002 Ford Windstar Cargo

1 Answer

Codes P0171 and P0316


code po316 is a random misfire like plugs or wires po171 will cause po316 po171 is a lean o2 code on bank # 1 that is a vacuum leak need to check it better for a vac leak

Dec 14, 2008 | 2003 Ford Windstar

2 Answers

2002 windstar with po133 and po153 codes


do you have the meaning for the codes? if you do please descrive it, it will help a lot

May 30, 2008 | 2000 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...