Question about 1994 Mazda 626

2 Answers

My 1994 Mazda 626

When i come to a stop sign or just stop at a light or something my steering wheel and dash board vibrates can you tell me what causes that to happen

Posted by on

  • 1 more comment 
  • Arlene Bell May 31, 2008

    Thank you for your advise i will follow up on this and get back with you. Thanks again

  • Anonymous Aug 04, 2008

    me falta el intermitente delantero del lado derecho

  • hubbabubba62 Dec 22, 2008

    Yep, i have the same problem with my 1994 626lx. I've tuned it up and all, except for a new fuel filter, and EGR valve, I plan on changing next week. It does'nt do it all the time, but when it does, it shakes.



2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Replace motor mounts.

Posted on Aug 16, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 46 Answers

Sounds to me like you have a rough idle of some sort.. I would say either the car needs a tune up or something in fuel system.
Hope this helps

Posted on May 30, 2008

  • dude705
    dude705 Aug 13, 2012

    My 94 626 is in the middle of a fix... with 182k in miles, but has been running great. Replaced oxygen sensor, cleaned the ICV, a timing module, plug wires (when one fails you get a violent shake all the time), and plugs.. fuel filter. Now moving to replace the injectors, and clean the throttle body.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1997 Mazda 626 while turning I'm getting a vibration ( like a thumping sound) in the front end. I also pick up a heavy vibration starting about 55-60 . I have replaced the left cv shaft, wheel bearing and...

no not typically. Have you checked out the tires closely for any signs of tread separation on the tires? That could be associated with the vibration above 55.

Oct 14, 2013 | 1997 Mazda 626

1 Answer

Interior light buzzer won't stop 1990 mazda miata

Actually, it's just an simple buzzer associated with the seatbelt circuit and doors. Many of us with Miata's have just removed it as it's easy to do. It's located under the dash on the driver's side and easy to remove
  • put the key in the ignition and open the door
  • reach up under the dash to the left of the steering wheel and grab small rectangular plastic boxes until you feel the one that buzzing and vibrating
  • Now feel around for the latch that holds it into place - it's a squeeze-to-release type
  • Open the latch and pull off the wiring harness
  • Use a twist tie or some electrical tape to tape the wire harness to something so it doesn't bounce around.

Apr 19, 2013 | 1990 Mazda MX-5

1 Answer

Slight vibration when idleing and when stopped when running


Nov 14, 2012 | 1998 Plymouth Breeze

1 Answer

Vibrating noise in the drivers side wheel when im going 55 on the highway and when i slow down

Hi If the noise is like a buzzing or huming noise the most likely cause is the wheel bearing.
But if you are feeling vibration through the steering wheel at 55 then as you increase speed the vibration goes then thats usually the wheels need balancing.
Also some noises can come from brakes which are rubbing or lots of brake dust on them.
Anyway i hope i have been of some help to you good luck
John ( South Wales UK )

May 07, 2011 | 2000 Mazda 626

1 Answer

2.5, 6 cylinder miles 120K vibration/noise at 45 - 70 MPH maybe feel a little in steering wheel feels like under drivers feet tires look OK, drives straight etc. Pulled tires & did visual inspection...

Symptoms indicate tires out of balance. Can't necessarily tell by looking. If you want to troubleshhot yourself, try rotating front tires to back. If it gets better, you know the front tires were out of balance.

Aug 30, 2010 | 1999 Mazda 626

2 Answers

I am finding it impossible to remove the steering wheel of my mazda 626 to get the ignition key replaced

whats the prob how far you got?
you need some special tools also
like a steering wheel press too remove the retaining clip

Jun 19, 2009 | 1994 Mazda 626

1 Answer

My 1983 mazda 626 wont turn over, I have changed the battery still wont go, the light which looks like the handbrake signal with the exclamation sign comes on, what does this mean?

It sounds like either the starter or ignition switch is bad. The easiest way to check which is at fault is to look at the dash lights when you go to crank it over. If when you crank it over the dash lights dim slightly, then that tells you that it is probably not your ignition switch. I would then look towards the starter being the problem. Possibly just a wire loose or off. If when you crank it over the dash lights do not dim slightly, then it is probably your ignition switch. Hope this helps.

Jun 14, 2009 | 1983 Mazda 626

3 Answers

Vibration when car is in idle.

sounds like an engine mount..not a tranny mount. could also be a bent rod

Mar 16, 2009 | 2007 Mazda MAZDA6

Not finding what you are looking for?
1994 Mazda 626 Logo

Related Topics:

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8737 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides