Question about 1992 Jeep Cherokee Briarwood

1 Answer

Starting problem I replaced a fuel pump, fuel filter within the last week. The pressure is where it should be on the injector rail. But I am experiencing a hard grinding while it is trying to start. Any suggestions. PS. I also checked the fuel regulator and that is okay. HELP ! Do you think it could be a crankshaft sensor ? I can here the fuel pump priming.

Posted by on

  • Anonymous Aug 05, 2008

    My problem is the same as 1992 Jeep Cherokee Briarwood, but I experience the hard starting and then my fuel pump gives out. I have replaced all parts associated with the pump, filter, fuel regulator, crankshaft sensor. Any suggestions.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

If the hard grinding noise is a metallic sound only when you start it, sounds like your starter bolts are loose or the starter itself needs replacing. fuel pressure doesnt cause any particular noises like that. If your fuel pressure or pump had problems, your vehicle simply wouldnt start

Posted on May 30, 2008

2 Suggested Answers

shaggyrat
  • 1224 Answers

SOURCE: 1992 Ignition problem

out aligned starter this requires some shims this is where you would get grinding noise from

or just bad starter replace accordingly

Posted on May 30, 2008

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1997 Ford F-150 4.2 V6 boggs down going up hill and stepping on gas.


Check or replace fuel filter again. You could have had a lot of sediment in your tank. If it ran good for a week, that's where you need to start figuring out what was replaced during that time. If you can, check fuel pressure at schraeder valve on fuel rail.

Oct 16, 2015 | Ford Cars & Trucks

1 Answer

I have a 2000dodge Dakota quad cab 2whl DRV. 5.9ltr v-8 within last 9 months replaced fuel pump, filler cap, injectors, map sensor, tps, coil, plugs, wires, transmission filter, rear end fluid and cover,...


It's possible the fuel pressure regulator is not operating properly, or the fuel pump relay is an issue. Slim possibility the fuel pump
wiring you did is a little off. I don't see that you replaced the fuel filter or filters, could be blocking fuel flow to or from fuel pump.

Feb 13, 2015 | Cars & Trucks

1 Answer

Fuel rail pressure problems


The injectors may have gotten dirty from changing the fuel pump and filter. Also check for water in the fuel system. It may not be fuel related at all.check plugs ,coils ,wires to see if they need replacing. Hope this helps.

Dec 29, 2013 | Oldsmobile 88 Cars & Trucks

2 Answers

Crank tolong before it start


First check your fuel pressure regulator by pulling the vacuum line off and check for fuel there should not be any.Then start the car and with a pressure gauge hooked up to fuel rail pull the vacuum line off the pressure should rise 5-10 psi if it does'nt replace regulator.Next check the fuel pressure it should be 41-47 with key on and engine off if not within specs replace fuel pump.

May 02, 2011 | 1995 Buick Roadmaster

1 Answer

Just replaced my dirty fuel filter last week, after replacement its noticed in hard restarting for almost 1 day used. For the second day in the morning I started my Starex CRDI 2005 model and won't start...


well if the fuel filter was plugged it has already caused damage to the fuel pump, first thing you need to do is check to see how much pressure is getting to the fuel rail, then check the volume, if this is all ok then you may have a dirty injector... if not look at your pump itself.


Good Luck

Apr 11, 2011 | Hyundai Tucson Cars & Trucks

2 Answers

Runs for less than a half hour and shuts down. Fuel to the rail but not into injectors.Fuel pump, fuel filter,brain, module, crank sensor, oil pressure sensor have all been changed. Starts again after...


Hello: If this is a 4cylinder engine with the distributor on the back of the engine (toward the passenger compartment) I would rebuild/replace the distributor. Including distributor cap and rotor.

Jan 31, 2011 | 1989 Chevrolet Cavalier

1 Answer

Low fuel rail pressure, warning light on dash on! (so i have been told!) any ideas what could be wrong and where to find the fuel rail?


the fuel rail is on top of the engine. look for the injectors the rail is the metal fuel line that supplys fuel to all the injectors. you can also find a fitting on this rail that a pressure gauge can be screwed onto. it should have a black cap on it. kinda looks like a valve stem like for the tires. but you may have a faulty pressure regulator. a clogged fuel filter or a bad fuel pump. replace pump last. it will be more expensive.

Apr 15, 2009 | Lincoln Continental Cars & Trucks

3 Answers

'03 F-350 7.3 Powerstroke cranks but doesn't start.


with out doing alot of testing
we have found alot of cam sensors going bad in the 7.3 powerstrokes
i just had one in last week with a new sensor that only lasted a month

5a4633f.jpg

Nov 03, 2008 | 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

1992 Ignition problem


out aligned starter this requires some shims this is where you would get grinding noise from

or just bad starter replace accordingly

May 30, 2008 | 1992 Jeep Cherokee Briarwood

Not finding what you are looking for?
1992 Jeep Cherokee Briarwood Logo

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...