Question about 1995 Plymouth Voyager

1 Answer

I know i need trans seals because it is leaking bad, but lately it jerks real bad when i put it in dr or rev, and if i don't give it some gas before i put it in any gear it will cut off. If i can go far enough to make it change gears it will do fine until i come to a stop, then it will try to cut off again. If i pour a quart of fluid in it every is fine, but that last about 8 hours. Then same problem.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 81 Answers

Your transmission is going to act poorly when it is low on fluid. Replace the seals before you break the transmission.

Posted on Oct 09, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

For some reason my 98 honda accord 2.3 engine. Its starting to jerk slightly when I drive over 45 miles an hour nd I break to a complete stop thats when I feel the jerk. Sometimes the jerk can be harder...


Front brake rotors need to be turned and new pads. Adjust rear brakes. the front brakes are doing all of the stopping. (overheating the rotors, premature pad wear).

May 20, 2017 | Cars & Trucks

2 Answers

Transmission leak spraying bad under motor on 2000 crycler concord LX 3.8


transmission line is loose @ connection, or has a hole(leak) in the line, even a crack in housing. trans is a large pump, high pressure, if you have a leak, just start your car and look under it, you'll know real quik.

Jan 18, 2013 | Cars & Trucks

1 Answer

Can a 2007 suburben transmission interchange with 99 chevy ext cab silverodo 2 wheel dr


no they are not the same the compuer was changed as well as the drive ratio in 05 but it sounds like it could be as simple as a shift solenoid

Dec 15, 2012 | 1999 Chevrolet Silverado 1500

1 Answer

Sounds like its in neutral when in drive


If it's an automatic trans and you mean it revs real high(like in nuetral)then jerks into gear then the ****** is going bad.check to make sure the fluid level is right(do not overfill) and check to see wether you are leaking any ****** fluid.Also if you pull the ****** dipstick and it gives off a burnt smell then you know its going up.

Apr 08, 2012 | 2001 Honda Civic

1 Answer

99 silverado when I take off motor revs up but truck don't wanna go eventually it will get going but will do the same when it shifts don't know if its the trans or rear end


if it was the rearend it would bang or clunk when the teeth meet. check fluid in trans, i assume its auto? if so check for burn smell on dipstick. if brown that means your clutches burnt. if still red but bad smell try changing filter and fluid. a complete flush is better but more expensive at a shop. if brown your too late and prob need a rebuild! ask a trans expert

Feb 04, 2012 | 1999 Chevrolet K1500

2 Answers

1989 ford ranger jerking problem


HAVE YOU EVER SERVICED THE FUEL FILTER ? EVERY 30,000 MILES ,"DEFINE JERKING REAL BAD" IS IT A STICK SHIFT? ANY OIL LEAKS COULD BE GETTING ON CLUTCH. AND CHECK ING SYSTEM COULD HAVE SPARK JUMPING

Nov 15, 2011 | 1989 Ford Ranger

1 Answer

TRANSMISSION LEAK


Pretty basic. If it's leaking that badly, you should have no problem locating the leak source. Line leaks are best done using compression fittings. (cut line and install). You can also use high pressure hose (like what's used when installing a trans cooler) slide it onto the line so there is at least three inches on each side of the line and use two mini-clamps with the screw parts opposite each other on each end.
If the leak is from the unit itself, each repair is different, some require trans removal. such as a front seal failure (fluid coming from the bellhousing.)
Hope it's just a line!
Once repaired, I recommend that you put in a container of lucas trans treatment to mitigate any ill effects of the run low condition as well.

Jun 04, 2010 | 1993 Jeep Grand Cherokee

1 Answer

Leaking trans fluid ,,looks like coming from flywheel


That is caused by a worn front seal on the transmission. If the leak is very minor, often a product like Lucas trans sealer and conditioner (one of few additives I know of that work without doing any damage elsewhere in the transmission) will stop it.
If it is a bad leak the only real cure is to have the unit removed and re-sealed.

Apr 30, 2010 | 2001 Toyota Celica

1 Answer

My 2000 daewoo nebria jerks to the left when the automatic transmission changes into 3rd gear. it's kinka spooky. where do i need to start looking for the solution? Don Frasier come711@yahoo.com


I would start with your trans, 3rd gear is much higher the 1 and 2 and if it only jerks in 3 the problem is a tranny issue, possibly late shifting or bad shift solenoid for 3rd gear. Your ecu could also be casueing the late shifts.....hows your fluid level/age

Nov 05, 2009 | 2000 Daewoo Nubira

2 Answers

1994 saturn sl2 automatic,with really bad oil leak.


There are only two paths for oil there. The rear main, and a oil galley plug a little higher up, about 2 o'clock.

Nov 12, 2008 | 1992 Saturn SL2

Not finding what you are looking for?
1995 Plymouth Voyager Logo

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...