Question about 1992 Daihatsu Charade

1 Answer

350 built chevy motor is getting oil in the radiator?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Daihatsu Master
  • 5,763 Answers

This may be due to a bad trany cooler inside the radiator, if its engine oil then it may be a bad intake or gasket, first detremine what kind of oil motor oil or trany oil.

Posted on Oct 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevy 350 oil pressure sending unit


The Oil Pressure Switch is located:Under hood, center, rear engine area, driver side of distributor, mounted in block. Here's what it looks like.he oil pressure switch is mounted to the top rear of the engine.

  1. Remove the electrical connector from the switch.
  2. Remove the oil pressure switch.
  3. To install, reverse the removal procedures.

Jul 18, 2013 | Cars & Trucks

1 Answer

I have a 1976 buick regal 350 engine and the oil light comes on when the engine gets hot and it is at an idle. when you give it gas the light goes out. could this be the oil sending unit and if so where is...


it might be the sending unit, is it a buick 350 or a chevy. 350? if a buick engine the sinding unit should be on the side of the timing cover if a chevy 350 next to the dist.

remove the oil sinding unit and install a manuel gauge and see just what the oil pressure is if below 10 psi at hot idle replace the bearings and oil pump in the engine. if this is a chevy 350 make sure you replace the camshaft bearings this is were we use to see the gratest oil pressure loss.

Aug 20, 2011 | Buick Regal Cars & Trucks

2 Answers

1979 chevy 350 modded to 383 stroker i have been


Sounds like the engine can't breath,
make sure pcv valve is good,or oil cap is vented.
your engine is building up pressure and has no where to vent,so it blows the easiest thing,the dip stick

Nov 18, 2009 | 1983 Chevrolet K1500

1 Answer

Turns over but dont start let off key and sputters 3or4 times 1998 Vortec 350 Chevy Z71 4x4


The freeze plug you replaced was due to rust or was it pushed out by freezing temperature? These plugs are not designed to protect the engine block from cracking during freezing temperatures, they are there to remove the sand from the block after casting it. I would drain your system completely and flush out the radiator thouroughly and fill with plain water, then run the engine and see if oil gets in the water, if it does and the plug was out due to freeze, then your block is probably cracked, although you could just have a head gasket leak. Oil pressure (40psi) is higher then water pressure (17psi), so getting oil in the water is always more prominent than the other way around. Flush out the system and let me know if oil returns to the water, hope this helps

Jun 03, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Oil in the water (radiator) 1996 Vortec 350 Chevy Z71 4x4


i would try to flush the cooling system completely
if I had to guess someone put stop leak in it when the freeze plug started leaking
also check the oil to make sure there is no water in the oil

Apr 15, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

Chevy 350 - oil pressure drops at high RPMs


yes, my Chevy Suburban did the same thing. i had to re haul the internals. it was time. the rings were in bad condition. i had massive blow by. in your case, you could grab a few more miles by replacing the rings but, i would re haul if possible.

Mar 10, 2009 | 1994 Chevrolet S-10 Blazer

1 Answer

350 chevy Lost compression and engine began to smoke.


pull out your spark plugs and try cranking the motor again, see if you're spitting out coolant from the plug holes. I'm asking you to do this, cuz it sounds like you blew a head gasket.

Mar 02, 2009 | 2000 Chevrolet Blazer

1 Answer

Adjust valves on 1971 chevy 350


either the intake is sucking oil from the bottom of the manifold, very common, other is the rings are gone, also very common,lighterr oil usage is a valve stem seal issue. the valves are hydraulic and unless u are installing new rocker arms require no adjustment.

Feb 17, 2009 | 2000 Chevrolet Blazer

1 Answer

Will a chevrolet v8 350 fit in a 1986 ford f-250


yep, it will take some modifcations, but you can put a 350 in a pinto if you want to bad enough.

Your looking at motor mounts, radiator hoses (possible a radiator) and redoing most of the wiring and linkages and don't forget the tranny, Chevy will not bolt to a ford tranny.

Aug 13, 2008 | Chevrolet C2500 Cars & Trucks

Not finding what you are looking for?
1992 Daihatsu Charade Logo

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daihatsu Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Are you a Daihatsu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...