Question about 2004 Chrysler Pacifica

1 Answer

How to bleed front brakes on a 2004 chrysler pacifica?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Normal bleeding procedures should work. there is nothing special about the Bosch twin calipers on the front of the Pacifica.

If you have a friend try the following.

1. with engine running have your friend pump the brakes several times and then push down on the brake pedal with about 20 lbs and hold it down. Now open the bleeder screw on one of the front calipers.
2 The pedal should drop and your friend needs to keep pushing on it and do not let up.
3. Now close the bleeder screw/
4. now have your fiend take his/her foot off the brake pedal.
5. wait 15-30 seconds and repeat. Do the same thing for the other side.
6. Check the fluid level in the resevoir every couple of strokes to keep it at least 2/3 full.
that should do.it.
Be sure to open the bleeder screw at least a full turn because you want a lot of flow rate.

good luck

Posted on Dec 25, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is my TCM located in my 2004 Chrysler Pacifica all wheel drive


its located near the battery , generally inside front bumper driver side

May 25, 2017 | 2004 Chrysler Pacifica

1 Answer

I have a 2004 Chrysler Pacifica brake lights are on ABS light on in car pedal sensor to Russia CV joints and might have got air in lines how to bleed brakes


Modern ABS systems require special tools to bleed them. In any case if the system has air in it then you have a problem that must be repaired. Anytime the lights are in the dash the system will record a fault code or codes, have the ABS codes scanned.

Oct 07, 2016 | 2004 Chrysler Pacifica

1 Answer

My 2004 Chrysler pacifica locks up when turning corners


I see you didn't mention was CV boots. If it is equipped with that and the boot gets torn the U joint can look up and eventually break. Easy to overlook them, one of the things we take for granted.

Feb 14, 2015 | 2004 Chrysler Pacifica

1 Answer

My car has no heat back vents blow cold air only i also have no defrost


Possibly air in the coolant system. Some Chryslers have a bleeder screw located at the front of the manifold to bleed off air.

Dec 20, 2012 | 2004 Chrysler Pacifica

1 Answer

What is the correct sequence in bleeding a 2007 chrysler pacifica with ABS brakes?


Left rear, right front, right rear, left front. The way the Pacifica's brakes lines are plumbed, this is the correct sequence which is against conventional wisdom.

Aug 07, 2012 | 2007 Chrysler Pacifica Touring

1 Answer

Where does the brake fluid go in a 2004 chrysler pacifica


Look under the hood and either on the right or left side near the firewall will be the master brake cylinder. There should be a screw cap for the brake fluid, put it in there to the FILL line. DOT3 fluid probably.

Feb 28, 2011 | 2004 Chrysler Pacifica

1 Answer

Rear end squeeking noises


Check the brake pads . they may need to be replaced. They make that noise to wrn you that it's time to replace them. Replace all pads in front too. It is what is suggested.

Apr 05, 2009 | 2004 Chrysler Pacifica

2 Answers

Brake peddele pushes back


some one needed to clean your hubs when they changed the rotors pulsation in front brakes is common on these vehicles.also check for loose tie rods

Feb 28, 2009 | 2004 Chrysler Pacifica

Not finding what you are looking for?
2004 Chrysler Pacifica Logo

Related Topics:

601 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...