Question about 2007 Toyota Tacoma

2 Answers

What number is the fuse in the manuel that operates the compass & temp display in the overhead?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 273 Answers

Check the The 7.5 amp ECU-B fuse is in the fuse box under the hood.If it is not blown then it is most likely an internal issue with the console. These units are notorious for failing internally. Very poor circuit board design. I offer a repair service with a lifetime guarantee. Check it out: www.autoclockrepair.com
I also have tech info, removal instructions, etc there. Hope this helps!

Posted on Oct 15, 2010

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 53 Answers

It almost certainly isn't the fuse, but these are repairable, fortunately. Our company repairs them in a manner that precludes the problem from occurring again. If you re-solder the surface mount resistors, the unit will generally quickly fail again due to oxidation on the old components. We install all new components, and guarantee out work!
What number is the fuse in the manuel that - silicongeek_9.jpg
For more information, please see our website here: http://www.toyotatacomacompassrepair.com

If you have any questions, feel free to go to the website (our email address is available on every page).
Good luck!

Posted on Jan 03, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Compass not working on 2006 Mercury Grand Marquis


Electronic Compass The compass display and module are contained in the overhead console and are replaced as an assembly. For additional information, refer to Section 501-12 . The compass display can be turned off and on by pressing the MODE button in the overhead console. The vehicle heading is displayed as one of N, NE, E, SE, S, SW, W, or NW.
Inspection and Verification
NOTE: Press the MODE button to turn on the display.
  1. Verify the customer concern by operating the vehicle along roads of known direction to duplicate the customer concern with the compass.
  1. Visually inspect for obvious signs of mechanical or electrical damage.


Visual Inspection Chart Mechanical Electrical
  • Compass module
  • Central junction box (CJB) fuse 15 (7.5A)
  • Circuitry

  1. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  1. If the fault is not visually evident, determine the symptom and GO to Symptom Chart .
Pinpoint Test A: The Compass Is Inaccurate/Inoperative
Normal Operation The compass receives battery voltage from the central junction box (CJB) through circuit 964 (DB/LG). Ground for the compass is supplied through circuit 676 (PK/OG).
    Possible Causes
  • fuse
  • circuit 676 (PK/OG) open
  • circuit 964 (DB/LG) open or short to ground
  • compass zone setting
  • compass calibration
  • compass module
PINPOINT TEST A: THE COMPASS IS INACCURATE/INOPERATIVE NOTE: Always set the zone and calibrate the compass before replacing an inaccurate compass.
NOTE: After installing a new compass, always set the zone and calibrate.
Test Step Result / Action to Take A1 CHECK THE OVERHEAD COMPASS DISPLAY
  • Key in ON position.
  • Check the overhead display.
  • Does the overhead compass display remain on after prove out?
Yes
GO to A3 .

No
GO to A2 . A2 CHECK THE COMPASS MODE
  • Press and release the SELECT switch on the overhead console.
  • Does the overhead compass display turn on?
Yes
If the compass display turns on correctly, GO to A3 . If the compass display turns on, but the heading is inoperative/inaccurate or the display indicates VAR, GO to A4 . If the compass display turns on, but it does not display all directions, or indicates CAL, GO to A5 .

No
GO to A7 . A3 CHECK THE COMPASS DIMMING
  • Turn the headlamp switch to the parking lamps ON position.
  • Does the compass display dim?
Yes
TURN the headlamp switch to the OFF position. GO to A4 .

No
TURN the headlamp switch to the OFF position. GO to A8 . A4 CHECK THE COMPASS ZONE SETTING
  • Set the compass to the correct zone for your location. Refer to Compass Zone Adjustment in this section.
  • Does the zone adjustment set correctly?
Yes
GO to A5 .

No
INSTALL a new overhead console. REFER to Section 501-12 . TEST the system for normal operation. A5 CALIBRATE THE COMPASS
  • Calibrate the compass. Refer to Compass Calibration in this section.
  • Is the compass calibrated correctly?
Yes
GO to A6 .

No
INSTALL a new overhead console. REFER to Section 501-12 . TEST the system for normal operation. A6 CHECK THE COMPASS ACCURACY
  • Position the vehicle at each of the 8 directions (N, NE, E, SE, S, SW, W, NW) and verify that the displayed heading is accurate. The vehicle must be stationary for at least 10 seconds at each direction.
  • Is the compass display accurate in each direction?
Yes
The compass is OK. REVIEW the operation of the compass with the customer.

No
INSTALL a new overhead console. REFER to Section 501-12 . TEST the system for normal operation. A7 CHECK THE VOLTAGE SUPPLY TO THE OVERHEAD CONSOLE
  • Key in OFF position.
  • Disconnect: Overhead Console C930.
  • Key in ON position.
  • Measure the voltage between the overhead console C930-1, circuit 964 (DB/LG), harness side and ground.
  • Is the voltage greater than 10 volts?
Yes
TURN the key to the OFF position. GO to A9 .

No
VERIFY the CJB fuse 15 (7.5A) is OK. If OK, REPAIR the circuit. TEST the system for normal operation. A8 CHECK THE DIMMING CIRCUIT
  • Key in OFF position.
  • Disconnect: Overhead Console C930.
  • Turn the headlamp switch to the parking lamps ON position.
  • Measure the voltage between the overhead console C930-4, circuit 484 (OG/BK), harness side and ground while rotating the instrument panel dimmer switch.
  • Does the voltage vary between 0 and 10 volts?
Yes
GO to A9 .

No
REFER to Section 413-00 for further diagnosis of the instrument cluster and panel illumination. A9 CHECK CIRCUIT 676 (PK/OG) FOR OPEN
  • Measure the resistance between the overhead console C930-2, circuit 676 (PK/OG), harness side and ground.
  • Is the resistance less than 5 ohms?
Yes
INSTALL a new overhead console. REFER to Section 501-12 . TEST the system for normal operation.

No
REPAIR the circuit. TEST the system for normal operation.

Nov 30, 2017 | Mercury Grand Marquis Cars & Trucks

2 Answers

Temp and compass stopped working


The overhead console is quite prone to internal failure. Dim, intermittent, or dead displays are a common symptom of an internal failure. We offer a reasonable repair service with a lifetime guarantee. Check it out: www.autoclockrepair.com

Aug 01, 2010 | 2007 Toyota Tacoma

2 Answers

Toyota tacoma temp & compass not working


The overhead console is quite prone to internal failure. Dim, intermittent, or dead displays are a common symptom of an internal failure. We offer a reasonable repair service with a lifetime guarantee. Check it out: www.autoclockrepair.com

Jul 20, 2010 | 2005 Toyota Tacoma

2 Answers

2004 f250 powerstroke console with compass, temp,


This is a very common problem with many of the mid 2000 Ford truck and SUV overhead consoles. The console is very prone to internal failure. If the dome lights work but the compass unit does not then it is a faulty computer unit. I offer a reasonable repair service with a lifetime guarantee, check it out: www.autoclockrepair.com
There is a bunch of useful info there. Drop me an email if you have questions, thanks!

May 15, 2010 | 2004 Ford F250

3 Answers

The compass and outside temp on my 2006 Toyota Tacoma quit working. Is there a fuse for this unit and where would I find it?


Are your cruise control, dome, and tail lights also out? If so then it is a fuse. If not then the control unit has gone bad internally. You may be able to get it fixed under your warranty.
If it is not covered by your warranty, check out
www.autoclockrepair.com. We offer a very reasonable repair solution.

May 11, 2010 | 2006 Toyota Tacoma

2 Answers

The electric compass and temp. display isnt working in my 2001 ford sport trac. Also,the power side mirrors and the keyless entry? Is this a fuse problem and if so does any one know the fuse #, my owners...


I believe that the mirrors and entry issues are not related to the overhead console. Compass/temp failure is a very common problem with many of the mid 2000 Ford truck and SUV overhead consoles. The console is very prone to internal failure. If the dome lights work but the compass unit does not then it is a faulty computer unit. I offer a reasonable repair service with a lifetime guarantee, check it out: www.autoclockrepair.com
There is a bunch of useful info there. Drop me an email if you have questions, thanks!

Apr 10, 2010 | 2002 Ford Expedition

3 Answers

Is there a fuse for the overhead compass/temp dispaly for a 2006 Toyota Tacoma and where is it located?


The 10 amp IGI #2 fuse controls several other components including the dome light, cruise control, and brake lights. If these are working but the compass is dim, intermittent, or dead then the control module has gone bad. You can get a replacement from toyota but I believe it costs $500+.
I offer a repair service with a lifetime warranty. Check it out:
www.autoclockrepair.com
thanks!

Jan 14, 2010 | 2006 Toyota Tacoma

2 Answers

Overhead Digital Compass & Temperature Display Inoperative


The 10 amp IGI #2 fuse controls several other components including the dome light, cruise control, and brake lights. If these are working but the compass is dim, intermittent, or dead then the control module has gone bad. You can get a replacement from toyota but I believe it costs $500+.
I offer a repair service with a lifetime warranty. Check it out:
www.autoclockrepair.com
thanks!

Jan 10, 2010 | 2006 Toyota Tacoma

1 Answer

Compass and Outside Temp display not working.


http://www.tacomaworld.com/forum/2nd-gen-tacomas/18497-overhead-console-fix.html?highlight=console+fix

Jul 28, 2009 | 2005 Toyota Tacoma

Not finding what you are looking for?
Cars & Trucks Logo

367 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...