Question about 2001 Ford Focus

1 Answer

Hello, i bought a replacment electric window motor for my 2001 focus but the connecters are not the same, on the original connecter there is 6 wires and on the new one there is just 2, i was hopeing that you could tell me which wires need to be connected to the new motor

Posted by on

Ad

1 Answer

Common sense tells you,you have been given the worn motor.
Take it back,and take your old one for a sample (always with any part)

Posted on Oct 09, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Dodge Grand Caravan driver side window wont go down after replacing switch but the other three windows still work


Probably the window motor, then. You will have to pull off the inner door panel to check that the two wires to the motor are connected good. Test the motor with jumper wires for operation before you pull it off, but if wires are connected, probably a bad motor.

Sep 06, 2013 | 2001 Chevrolet Impala

1 Answer

I have a 2001 Chevy blazer windows don't work rear


If windows are electric, check switch and replace if needed.
Check window motors wiring connections. If motors are bas, replace as needed.
If manual, window could be off track or cranking mechanism may be broken. Replace as needed.
If light fuses are good, replace bulbs to the lights.

Jan 21, 2013 | Cars & Trucks

1 Answer

My positive wire connecting to my battery looks as if it melted or got cut, how do i run a new positive and negative to replace thbe old ones


Safest Way is to REPLACE BOTH WITH "OEM" FROM DEALER, Simply Fallow the Old/Bad Onse to there Destination and RUN and Tie Down and Connect the Replacement The SAME as Original One, SOME Aftermarket Cables Work Fine as Long as there is NOT Special Connectors on the Originals. If So Original Equipment Manufactured Parts are Best. ALWAYS CONNECT the NEGATIVE Battery TERMINAL @ BATTERY LAST.

Sep 22, 2010 | 2001 Ford Focus

2 Answers

Window on drivers side dont roll down


try key on & door open,,may have a broken wire or switch or bad motor,,ck for power at motor or switch

Jan 31, 2010 | 2001 Pontiac Grand Am SE

1 Answer

Focus 1.6 2001 aftermarket stereo only comes on when the sidelights are turned on??


you have a wiring problem, remove the radio on the original car wiringloom you should have a grey wire with a yellow trace. that wire needs to be disconnected from the radio and the black wire with green trace should be connected in its place

Jan 29, 2010 | 2001 Ford Focus

1 Answer

2001 tribute electric window wont go up


Pull the door panel and use the hot wire off the switch (You might need some wire for this) But connect the hot wire to the window motor it self!!! and it should roll up if not you got a bad window motor!!!

Oct 10, 2009 | 2001 Mazda Tribute

2 Answers

Electric window


most likely the electric motor that raises and lowers the window is defective, u will need to remove the door panel and replace the window motor, about a 2 hour job and $100 in parts.

Apr 23, 2009 | 2003 Ford Focus

3 Answers

Ford Focus Sputters


The "speed sensor" is throwing way too much fuel through the injectors and flooding the cylinders, new spark plugs would burn longer, but still die after a while, so that makes sense... but I think the problem might go a bit deeper into the engine management system than that. You say it does this at a specific temperature, so a loose connection somewhere is possible inside the EMS, something that breaks a sensor connection at that temperature, due to expansion and contraction of metal parts. Try looking for evidence of that.

Mar 09, 2009 | 2001 Ford Focus

2 Answers

Power window on 2001 chevy silvrado


Sounds like your gears are striped out inside the motor. I had the same problem on a car of mine. I just went to a parts store and bought the gear and took the motor apart and fixed it myself. It cost 18 dollars with tax.

Good Luck.

Feb 02, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

Replace electric motor for ford focus front window


I bought a Haynes workshop manual.
I tried to find a PDF manual on the Internet but failed. If anyone could guide me to a site I would appreciate it. Thanks

Nov 14, 2008 | 2003 Ford Focus

Not finding what you are looking for?
2001 Ford Focus Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...