Question about 2003 Ford Windstar

Open Question

Where is oil sending unit locacted on 2003 Ford Windstar 3.8L?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: My Audi 98 2. 8l car is always overheating

Hi Counchcharles
Your service displays have to be reset with the correct electronic equipment....When you chage the engine oil the computer management system will have to be told...thats the job of the scanner....go to a service centre and have them cancel it for you.
The over heating problem is nothing to do with that though.....Check to see if you have any leakage....open the pressure cap only when the engine is cold....best is first thing before start up in the morning....check to see if you need topping up....if you do, it'll mean you have a leakage....Check the entire radiator and hoses where they go from the rad into the engine and ventilation system for stains from the coolant....If you can't find any look at the thermostat....If you remove it, replace with anew unit, do not dis-guard it also check the pressure cap and if needs be replace....Good luck
Best regards Johngee10

Posted on Aug 10, 2008

Ad
  • 508 Answers

SOURCE: locate the oil sending unit on a 2003 6.0 2500HD silverado

You will find it down by the oil filter.

Posted on Feb 07, 2009

  • 5 Answers

SOURCE: ford windstar van, 2003

I had a small plastic piece replaced in the transmission and it solved the problem(2007). My car was still under warranty, so it only cost me about $100.00. The actual cost was closer to $900.00 because of the labor involved. I used the Ford Dealer in Schulenburg, Texas. They would know exactly what you are talking about, if you ask them.

Posted on Mar 31, 2009

wyatt1582
  • 453 Answers

SOURCE: Where is the oil sending unit on a Windstar 1998

Should be close to the oil filter. It will be a metal tube sticking out with 1 wire running to a pod at the end of it.

Posted on Apr 22, 2009

  • 126 Answers

SOURCE: Where is the oil sending unit located on a 2003 Chevy Tahoe 5.3 engine

its in the block behind intake manifold .

Posted on May 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford windstar 2003 3.8 V6 where is oil sending unit located?


It could either be on the flange where the oil filter screws on or it might on top of the engine block at one end or the other. It won't be anywhere in the middle. If you don't know what it looks like, It will be screwed into where ever it is. It will be metal on the bottom to 1/2 way up where it becomes black plastic. At the middle where the metal and plastic meet, it will look like it will take a kind of large
funky looking socket to remove it. If you can swing a pair of channel locks in there, and if you are careful; you won't have to buy a socket that you'll probably never use again. At the top of the plastic half, there will be either a slip-on connector or possibly a nut holding a wire onto the unit. It only needs one wire as it goes to ground when activated. good luck. Jeff M.

Mar 20, 2014 | 2003 Ford Windstar

1 Answer

Oil sending unit locaction on a 1995 gmc


should be on the back of the block near the distributor

Mar 08, 2014 | 1995 GMC Sierra

1 Answer

98 ford windstar engine smoking from back center of engine as you look at it. smoke smells like oil somewhat. oil levels are fine, no white smoke from exhaust, could it be oil sending unit? Help me...


engine probly has some worn hardware or hoses--chec oil for any foaming to eliminate bad gaskets--valve guides or rings cud hav minor wear causin some burnt oil smell thru leakin exhaust

Nov 29, 2011 | 1998 Ford Windstar

2 Answers

My ford windstar 2003 is leaking from de oil pan by rusted


I think you know what has to be done, if you got under the
van & actually checked it out

You remove the oil pan,repair or replace it
& reseal it

Sep 23, 2011 | 2003 Ford Windstar

1 Answer

2000 Ford Windstar uses 1 gt. of oil per 300 miles no smoke on leaks


Have you actually got under the vehicle and made sure of the no leak. Loosing that much oil I would suspect the oil sending unit is bad. and they can still give a reading and be bad.

Feb 07, 2011 | 2000 Ford Windstar

1 Answer

My 1998 windstar just lost oil presure ,all oil pressure


If the engine runs quiet the gauge in the dash or the oil sending unit is bad. generally the sender on the engine goes bad from the heat of the engine. If the engine makes all sorts of noises and rattles inside the oil pump is shot

Mar 31, 2010 | 1998 Ford Windstar

1 Answer

Where is oil pressure sending unit?


lower right hand side, front of engine, below the power steering bracket.

Nov 07, 2009 | 1998 Ford Windstar

1 Answer

Where is the oil sending unit on a Windstar 1998 3.8 engine?


Should be close to the oil filter. It will be a metal tube sticking out with 1 wire running to a pod at the end of it.

Apr 22, 2009 | 1998 Ford Windstar

1 Answer

1995 Ford Windstar transmission is slipping and shifting hard


bad news, 1995 ford windstar transmissions fail extremely frequently at about 60000 miles, I would not waste money in a transmission flush as it will most likely not correct the problem. It is a dsign flaw, the transmission cannot handle the torque of the 3,8L engine and the 700Lbs of added weight of the windstar body.
I'd just use it untill it fails...

Mar 25, 2009 | 1995 Ford Windstar

Not finding what you are looking for?
2003 Ford Windstar Logo

Related Topics:

261 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...