Question about 2001 Pontiac Montana

1 Answer

I have a question about what hose i broke its right under the windshield wiper under the hood

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 110 Answers

Probably the windshield washer hose.

Posted on Mar 27, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevy s10 windshield wiper- the driver side wiper doesn't work.


that will most likely be the way to get to it . It appears that the arm has fallen of the crank. There is a small clip that holds them on and it may have rusted / broken off.

Apr 04, 2014 | Cars & Trucks

1 Answer

My saturn sc1 1999 stopped spraying washer fluid out of the driver side, the passenger side sprays fine. How can I fix this?


Sounds like the rubber hose broke between the Tee fitting and the spray nozzle. If the nozzles are between the hood and windshield, you may have to remove the wiper arms and the panel under the windshield to get to the hose.

Jan 31, 2013 | Cars & Trucks

1 Answer

Subaru legacy wagon wiper fluid hose disconnected


Look up at your hood... there will be one hose running to the left side of the windshield, and one running to the right side. The right (Driver's) side goes down to a "T" connector, which is right near your master brake cylinder, but up on the hood itself... it connects back there. I couldn't figure it out either... luckily I have 2 Outbacks... a 1998 and a 2001... both connect the same way.

Jan 18, 2013 | 2001 Subaru Legacy

1 Answer

Good Morning, The hood release broke on my 72 Corvette. How can I release the hood and replace the cable? Thanks Kent


there should be a rubber plug right under the front window on either side (the plug on the left can only be removed by removing the windshield wiper) once you have done this use a screw driver to push down on the latch under the hood

Jul 25, 2011 | 1972 Chevrolet Corvette

1 Answer

2002 Pontiac Sunfire windshield washer fluid sprays under the hood when used, what is the problem? The fluid still comes through the wiper blades but most of it under the hood.


The hose that the fluid runs through has a hole in it or one of the little plastic hose connectors has sprung a leak or is partially disconnected.

Dec 26, 2010 | 2002 Pontiac Sunfire

2 Answers

My passenger side windshield wiper does not work. It is on a 1985 Buick LeSaber Collector'd edition.


is the wiper itself spline drive stripped out or is it simply not connected properly ?
also under the hood and under the plastic cowl you should be able to see whether or not the wiper arm is connected it will be one of those 2 options i assure you

Dec 09, 2009 | 1985 Buick LeSabre

2 Answers

2002 Chevy Tahoe-Drivers Side windshield wiper not working


There is a bar that connects both your windshield wipers together check that to see if it is broke or has come unscrewed. Should be underneath the hood upagainst the firewall.

Sep 22, 2009 | 2002 Chevrolet Malibu

1 Answer

I cannot find the front window screen wiper pipes to clear them to work the water from the front wipers, Toyota Hiace 1994,


if the nozzles are not on the hood, they may be in the wiper arms themselves, I have seen them under the vent grille at the bottom of the windshield as well, you should be able to see the hoses under the hood at the base of the windshield

Mar 25, 2009 | 1994 Toyota Pickup

1 Answer

Bad wiper motor on 1996 dodge grand caravan


According to the Haynes repair manual Chapter 12:

1. Disconnect the negative battery cable
2. Detach washer hoses, lift the wiper arm covers and mark the wiper arm locations on the pivot shaft for later re-installation. Remove the wiper pivot nut and remove the wiper arms.
3. Remove the cowl cover (from chapter 11)
3a. Remove the wiper arms then remove the screws that hold the lower area of the cowl cover to the wiper module.
3b. Disengage the quarter turn fasteners that hold the outer ends of the cowl cover to the wiper module.
3c. Open the hood and release the wing nuts that hold the front of the cowl cover to the wiper module.
3d. Close the hood but do not latch it. Now remove the outboard screws and lift the cover up enough to get to the washer hose.
3e. Disconnect the washer hose from the right washer nozzle. Close the hood but do not latch it. Lift the cowl cover toward the windshield and off the vehicle.
3f. Installation is the reverse of removal
4.Open the hood. Disconnect the wiper motor electrical connector.
5. Disconnect the windshield washer hose from the coupling inside the unit. Disconnect the drain tubes from the bottom of the wiper unit.
6. Remove the wiper unit mounting bolts. (Picture appears to be three (possibly allen head) bolts)
7. Remove wiper unit.
8. Installation is the reverse of removal. Wiper blade and wiper arm adjustment is measured with the wipers parked; correct adjustment is the lower wiper arm approximately 1.5 inches distance from the cowl cover and the upper arm approximately 2.5 inches from the lower arm. Operate the wiper motor and check that the wiper motor parks when the wiper switch is OFF.

Mar 21, 2009 | 1996 Dodge Grand Caravan

1 Answer

I have a 1990 Sentra. I turned on my wipers when the windshield was frozen. Unfortunately, now only the right one works. What could I look for to see if I can fix it.


you probably bent or broke the wiper linkage check under the hood and see if you can get to the wiper linkage from there to see if it just popped off. If not you will have to take the cowling off the bottom of the windshield and check it out.
A replacement linkage is not that expensive and if your halfway decent with tools you could replace it just remember if you remove the wipers do not leave the arms up incase they drop down and crack the windshield.

Nov 27, 2008 | 2003 Lotus Elise

Not finding what you are looking for?
2001 Pontiac Montana Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...