Question about 2003 Lincoln Navigator

1 Answer

My 2003 Lincoln navigator warning tire very low chime goes off every minute. But the tires aren't low. How can I get it to stop?

Posted by on

Ad

1 Answer

You may have a failed Tire Pressure Monitor (TPMS -System) in one tire.
I would see, if a tire store could reset it, or if it failed,I would replace all four.

Basically a fancy tire valve, that is required by Federal Law on all 2008 and newer vehicles
The batteries go bad in 7 to 10 years,approx

Posted on Oct 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i reset the chime warning very low tire on a lincoln aviator 2003


most often refill tires to spec (35psi) make sure all tires are same pressure then must drive at 40mph or faster til light or chime goes off

Sep 08, 2014 | 2003 Lincoln Aviator

3 Answers

How do you reset the low tire pressure light?


To reset the tire pressure system, do the following:

(NOTE!....Do not reset the check tire pressure system without first
correcting the cause of the problem and checking
and adjusting the pressure in all four tires. If you reset
the system when the tire pressures are incorrect,
the check tire pressure system will not work properly
and may not alert you when a tire is low or high.)

1. With the engine off, turn the ignition to ON.
2. Press the MODE button until the DIC reads LOW
TIRE PRESSURE HOLD SET TO RESET.
3. Press and hold the SET button until you hear a
chime, and TIRE PRESSURE RESET is displayed.

You will hear three chimes, then the LOW TIRE
PRESSURE message will go off and the DIC will return
to TIRE PRESSURE NORMAL. If the LOW TIRE
PRESSURE message comes back on, the check tire
pressure system has not reset. Repeat the procedure.
The system completes the calibration process during
driving. The system learns the pressure at each tire
throughout the operating speed range of your vehicle.
The system normally takes between 30 and 60 minutes of
driving to learn the tire pressures. The system normally
takes 10 to 20 minutes of driving in each speed range to
learn tire pressures. The speed ranges are 20 to 40 mph
(32 to 64 km/h), 40 to 60 mph (64 to 96 km/h), and above
60 mph (96 km/h). This time may be longer depending on
your individual driving habits. The learning process does
not need to be completed during a single trip. Once
learned, the system will remember the tire pressure until
the system is reset.

Jun 02, 2014 | 2004 Buick Rendezvous

1 Answer

The low tire pressure warning is on and my tires aren't low. How do I reset them? 2003 monte carlo ss


Turn the ignition on, do not start. Turn the light switch from off to "park lights" three times within five seconds.

If that doesn't work there is a more lengthy reset procedure that involves using the radio. I can get that info to you if needed or you can also find it in your owners manual.

Feb 23, 2012 | 2003 Chevrolet Monte Carlo

1 Answer

How do i reset the low tire pressure light on a 2003 buick rendenvous


  • Follow these steps
  1. Turn the vehicle off while holding the mode button on the information center until it says "Low Tire Pressure Press To Reset"
  2. Then press and hold the "set" button until the chimes go off and you see "Tire Pressure Reset."
  3. The chimes should then sound three times and "Tire Pressure Normal" will display.
  4. That's it.
  • Do this only AFTER you fill the tire so it will recognize the level as being low compared to the pressure after you filled the tire.

regards, Tony

May 17, 2011 | 2003 Buick Rendezvous

4 Answers

How do i fix low tire pressure warning light that will not go away on 1997 lincoln continental. Spare is a donut, so dont think it is involved, I fill tires, and drive 10 minutes and sensor triggers light...


When you "fill" the tires they must be within 3 lbs of each other or the tire pressure warning light will come on. If the tires are "filled" correctly and the tire pressure light still comes on, you may have a tire pressure sensor that has gone bad. You would then have to take your car in to the dealer or tire shop to determine which tire sensor is bad.
Good luck.

Jan 30, 2011 | Lincoln Continental Cars & Trucks

2 Answers

How do I reset the low tire warning light?


TIRE PRESSURE MONITOR RESET PROCEDURE

IMPORTANT: There are 3 different ways to reset the Tire Pressure Monitor (TPM) system. After resetting, the TPM system requires up to 30 minutes of straight line driving in each of the 3 speed ranges to complete the calibration process.If the TPM system does not reset, or DTC C1245 remains current, refer to Diagnostic System Check - Tire Pressure Monitoring. For further information, refer to Tire Pressure Monitor Description and Operation.

USING THE EXTERIOR LAMP SWITCH
  1. Adjust all tire pressures to the recommended kPa/psi. Refer to Tire Placard.
  2. Turn "ON" the ignition, with the engine OFF.
  3. Cycle the exterior lamp switch from "OFF" to parking lamps 3 times within 5 seconds.
  4. Use the scan tool in order to clear the TPM DTC.
USING THE RDS RADIO, IF EQUIPPED
  1. Adjust all tire pressures to the recommended kPa/psi. Refer to Tire Placard.
  2. Turn the ignition to "ACC" or "ON", with the engine OFF.
  3. Turn the radio "OFF".
  4. Press and hold the "DISP" button until "SETTINGS" is displayed.
  5. Press the "SEEK" up or down arrows until "TIRE MON" is displayed.
  6. Press the "PREV" or "NEXT" button to enter the submenu. "RESET" will be displayed.
  7. Press the "DISP" button, A chime will sound and "DONE" will be displayed.
  8. Scroll until "EXIT" is displayed.
  9. Press the "DISP" button to exit the TPM reset mode. A chime will sound to verify exit.
  10. Use the scan tool in order to clear the TPM DTC

Oct 11, 2009 | 2003 Chevrolet Impala

1 Answer

Door sensor 2003 lincoln navigator where is it and how do you fix it


There should be a switch in the door frame which the door pushes in when it is closed. Sounds like it's loose or pushed back into the frame.

May 04, 2009 | 2003 Lincoln Navigator

1 Answer

Warning-tires extremely low.


you have answered your own question,proud of you i am.thats the right answer

Jan 31, 2009 | 2003 Lincoln Navigator

Not finding what you are looking for?
2003 Lincoln Navigator Logo

872 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...