Question about 1997 Toyota T100

Open Question

How do you remove the drivers side door panel to fix you lock

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: Drivers side rear door lock inoperative

You need to replace the electric solenoid/actuator for the door lock. The door panel pulls off very easily.

Posted on Oct 25, 2008

  • 1861 Answers

SOURCE: driver side door lock

Pull the door panel & replace the electronic lock solenoid.
Not easy, but this is what you need to do.

Posted on Sep 09, 2008

fcsr
  • 43 Answers

SOURCE: remove driver's side door panel on 2002 nissan altima

Removal instructions are available with images and step by step directions, www.carstereohelp.com/strnissan.htm

Posted on Nov 13, 2008

  • 840 Answers

SOURCE: left front door auto lock-unlock only buzzes. How remove door?

thei are screws in the door hidden by caps that you need to take off the door and near the mirror shoud pop off

Posted on Jan 24, 2009

  • 38 Answers

SOURCE: Replacing driver side mirror

Take off side door panel, screws securing it are revealed, unscrew screws remove them and and the mirror drops off. If the wing mirror is on the bodywork, then the screws should be either in the wheel arch or under the bonnet.

Posted on Feb 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

My drivers side window will not go up or down. Also, the door lock/unlock on the same side doesn't work either


Sounds like a connector is disconnected inside the driver side door. The connector is usually located near the front of the door. Removing the door panel could be a job you do not want to attempt, but the car being a 2004 you may want to try. The wiring for the door windows and locks goes through this door.

Mar 11, 2015 | 2004 Chrysler Sebring

1 Answer

How do I remove the driver side door panel on a 1994 Lincoln Mark VIII


Remove mirror mount cover assembly.
Remove inside door handle cup (22634).
Remove door lock control bezel.
Remove window control bezel.
Remove interior lamp lens.
Remove screw from interior lamp assembly body.
Remove screw from window control bezel opening.
Disconnect mirror, lock switches and memory seat on driver side from bezels and wire harness.
Disconnect window switches from window bezel and wire harness.
Lift front door trim panel (23942) vertically, out of weatherstrip and over lock rod.
Disconnect interior lamp (13776) from wire harness.
Remove front and rear door trim retention hooks into door inner panel.
To install, reverse Removal procedure, paying special attention when inserting inner door trim into weatherstrip. Rock inner door trim into weatherstrip and push downward until lower trim belt character ditch lines up with score mark on inner door panel.

Aug 16, 2014 | 1994 Lincoln Mark VIII

1 Answer

On driver side and rear side on driver side, both doors will not lock and unlock when use remote key. How can I fix the power lock to lock and unlock?


If the door locks by using the door switch the fault is with the master control unit. So there is a link failure from the master control to the sub units in the door, it can be a break in the wiring harness in the door hinges as this remote trigger can be lost on the driver side and which goes parallel to the rear side.
remove the panel and check the lines, compare to the other side to find the missing line - open wire. You can loop or wire a new connection from the open section.

Sep 17, 2011 | 2008 Toyota Camry

1 Answer

Driver's side power window was inop. Window failed to go back up. Chevy dealer replaced the regulator motor and now working. Now the power dood lock switch on drivers side won't unlock doors.. Is the...


Hi, that wire is disconnected when the door panel is removed to work on the window motor. Take the car back and ask them to reconnect your door locks. If you want to fix it yourself, you may be able to access the connector by removing only the control panel where the door lock switch is installed. Remove any visible screws and then pry gently to pull up the panel. Odds are, however, that the whole door panel will need to be pulled loose to find the cable. You can possibly just pull the bottom of the panel loose, but do it carefully. Feed the wire back up to the control panel and reconnect to the switch. Thanks for using Fixya.

Jan 24, 2011 | 2003 Chevrolet Venture Passanger

1 Answer

98 Chev Blazer. power lock problem. driver's door would not unlock doors, now it will not lock doors. passenger side works fine


you may just have a bad connection under the lock button under switch panel on your drivers door. check electrical plug in at door lock switch by removing that panel from driver door.it may be that you have to replace that door lock switch .thers only one fuse for door locks and if pass side works, it's not blown.

Aug 19, 2010 | 2001 Chevrolet Blazer

3 Answers

Drivers side rear door will not lock. or unlock, with FOB or main lock control on drivers side front door. I have to loc and unlock this door manually


THE DOOR LOCK ACTUATOR IS BAD THIS WHAT CONTROLS THE LOCK ELECTRONICALLY. WHAT IT IS THAT GET HOT AND THE CONTROL GETS HOT SO MANY TIMES BURNS UP CONTRFOL CONTACT. THE ONLY FIX IS TO REPLACE THE ACTUATOR.

Jul 17, 2009 | 2000 Toyota Camry

2 Answers

Power lock on driver side door does not work on2003 Toyota Celica


remove the door panel and change the solenoid on the inside of the door

Apr 16, 2009 | 2003 Toyota Celica

1 Answer

Passat rear drivers side door won't open


On a similar problem i removed the window controll switch unit on the drivers door and cleaned the multipin socket and this solved the same and other problems i had.

Mar 12, 2009 | 2003 Volkswagen Passat

1 Answer

Drivers side rear door lock inoperative


You need to replace the electric solenoid/actuator for the door lock. The door panel pulls off very easily.

Oct 11, 2008 | 2004 Toyota Sequoia

1 Answer

Driver side door lock


Pull the door panel & replace the electronic lock solenoid.
Not easy, but this is what you need to do.

Sep 07, 2008 | 2004 Toyota Sienna

Not finding what you are looking for?
1997 Toyota T100 Logo

Related Topics:

421 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...