Question about 2000 Jaguar S-Type

1 Answer

HOW DO YOU CHECK THE TRANS FLUID TO SEE IF LOW FOR AN S TYPE?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jaguar Master
  • 22,219 Answers

Dealer only ,its done from underneath on a four poster ramp

Posted on Oct 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What can cause my 2002 Kia not to go into the 4th gear


low auto trans fluid, or sensor issue, check for fault codes at transmission with code reader, check fluid type and level.

Jan 14, 2017 | Kia Cars & Trucks

2 Answers

1977 351 Windsor motor and trans. was put in 1978 ford pickup and will not go in reverse after trans. fluid and strainer kit was put in. whats wrong


I dont like asking obvious questions but,did the trans work prior to installation and did you use type f fluid

Apr 04, 2015 | Ford Cars & Trucks

1 Answer

Why will automatic trans. not go into gear?


Check the transmission fluid level. There is a dipstick ( typically a yellow or red handle) at the back of the motor - I think it may be on the driver side of the motor. Start the motor and check the fluid. DO NOT TRY TO DRIVE THE TRUCK!! low fluid can burn up the transmission. the dipstick will have the exact fluid type needed imprinted on it. add fluid with motor off, 1 quart at a time, and start the truck and let it run for a few minutes while you shift from park, reverse, neutral, and drive, back to park for 30 seconds per position before checking again until the level is between the add and full marks on the stick.

Feb 21, 2015 | 1985 Ford F150

1 Answer

2007 kia rio losing power on hills rpm stay high


MANUAL TRANSMISSION, CLUTCH SLIPPING
AUTO TRANS. CHECK FLUID, IF LOW ADD
CORRECT TYPE OF FLUID, IF BURNT SMELL
HAVE DEALER CHECK

Dec 28, 2013 | 2002 Kia Rio

1 Answer

Dear Sir, My Huyndai Sonata 2002 4 Cylinder. Transmission problem, it takes **** during shifting gear 2 to 3 and hangs on gear no 3. Some times its shifting normal. Please let me know the solution.


First check the fluid level on trans dipstick while engine is running,on flat ground and in 'park' a low reading may be the cause.I always like to change the fluid and filter when I have a transmission fault in the shop,but normally I wait until fault is located so as not to throw out the evidence(but I recommend to do).This type of fault is usually caused by dirty fluid in the trans not allowing valve body to function correctly, or a fault with the electronics,they being usually a speed sensor on the trans, or the throttle position sensor(tps)on the engine throttle body,It is better to have the vehicle engine and transmission computers(ecu)checked on a scan tool for any fault codes logged,this will save hours and $$.check around there are a huge number of scan tools out there for the home handyman(just ensure it does your car type),or check out the local garages,Prices can vary for this service,but it is quick and easy to have done. Prior to fault was there any work done on your car?I often get them in with plugs not reconnected or damaged by messy workmanship.A WORD OF WARNING! Do make sure that you have the correct trans type fluid for this model,most take an atf 3 type but some are cvt trans and they do not run on this fluid at all!trans codes should be on the vehicle ID badge.

Mar 22, 2011 | Hyundai Motor 2002 Sonata

1 Answer

2002 Chevy Malibu with a 3.1ltr enging and a 4 speed automatic trans. The trans has a whinning sound when driving. It's not slipping and shifts correctly. It just has a whinning sound. What could the...


The most common whining noise from that tranny is the transmission pump. Sometimes they have a high pitch whine noise yet nothing wrong its normal. Sometimes its an indication of the pump being over-worked due to a dirty filter or fluid low. Turn engine on and check tranny fluid level. If low add to cold mark on dipstick, check for leaks under vehicle. If fluid appears very black or burnt smell, recommend flushing fluid and replacing filter (located inside tranny pan) yours will be a 4L60E type tranny.

Jan 29, 2011 | 2002 Chevrolet Malibu

1 Answer

I need to know what type of oil and transmission fluid this car takes.


This vehicle takes 5w-30 weight oil and dextron 3 trans fluid.The types are on the oil cap where you fill the oil and on the trans dip stick where you check the level.Do not over fill it and make sure to check the trans fluid level with the car in park and engine at operating temperature.The oil level always check with a cold engine.May also be checked warm but may read slightly low.Hope this helps.Good luck.

Oct 21, 2010 | 1995 Oldsmobile Cutlass Ciera

1 Answer

Shift to reverse and somtimes it wil not engage, have to wait a second and then it engages, otherwise if i engage it imediately it will slip or **** the mission, is it electronic?


Check fluid level with car level and idling. Level must not be to low or overfilled. These conditions could cause slipping and slow engagement. If fluid level is ok. Have fluid and filter changed. Correct type of fluid is vital for longest life. If problem still exists have a trans shop road test and diagnose issue. Trans repairs will not be a favorite item . Good luck

Sep 09, 2010 | 2000 Saturn SL

1 Answer

When shift to drive the car wont respond. on 1 2 or reverse it responds normal


check the trans fluid,this happens when the fluid is very low, only goes in reverse,i had the same with my car,low trans fluid, PLEASE ADD NOW BUT CHECK FIRST IF IT IS LOW????

Oct 30, 2009 | 1997 Chevrolet Lumina

1 Answer

My a604 transmission wont shift into 3rd or overdrive.


You may be low on fluid, so check that first, after driving a bit and getting the trans up to operating temp. If it is low, fill it with the proper type of trans fluid and then see how it operates.
Check it with the motor running, gear in park and parking brake on. If that is not the culprit, it could be a solenoid or other fault that is causing the trans to operate in "limp mode" meaning it will only allow first and second gear to get you home.

Nov 24, 2008 | Chrysler Voyager Cars & Trucks

Not finding what you are looking for?
2000 Jaguar S-Type Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...