Question about Ford F

1 Answer

Ford feista lookin for drivers side boot lid piston that holds boot lid open please

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 46 Answers

Try your local junk yard.. that is NOT an item autozone would carry.. you might get lucky but doubtful
good luck

Posted on May 30, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I remove the trunk lid hinges on a 01 ford escort?

you will have to get the boot open first and you will find a hinge at either side Ther should be 2 bolts at each hinge that screw up into the metal bracket. Remove these carefully( Need a mate to hold the lid)

Jan 24, 2013 | Cars & Trucks

1 Answer

How to fit a boot lid on a 1999 ford cougar

Firstly, open it up, remove all wiring, any light lenses which you need to switch over, lock, inner lining, number plate brackets, lights, etc.

Then, once everything has been removed, undo the bolts which hold the lid to it's hinges, and take the lid off.

Reverse the procedure for fitting the new lid.

Close the new lid gently at first as it may not locate well on the first attempt.
If it's all askew, then slacken off the hinge bolts and position the lid to how it closes well. Once in the correct position, tighten the hinge bolts, and you're almost done.

Final step: Run some water over the lid for a while and then open it up to check for any leaks.
If you do have any leaks, then as extreme as it sounds, climb in, close the lid and have someone run water over the lid, while you lie inside with a flashlight/torch and look for leaks.

Good luck.

Nov 14, 2012 | Cars & Trucks

1 Answer

Can't unlock or lock on driver side of my x reg ford galaxy. only opens boot. doesn't work on passenger side either.

X ?? does this mean a swear word ,now please be more specific with description ,do you mean the key doesnt work in the lock or the dorrs not opening with the remote also year of manufacture would help a little

Mar 30, 2011 | Ford Fiesta Cars & Trucks

1 Answer

1967 ford f100 firing order for spark plugs has 1968 390 v8 aoutomatic

According to my Chilton book the firing order for that motor is 1-5-4-2-6-3-7-8. Cylinders are numbered 1 through 4 on the passenger side from front to back. Cylinders 5 through 8 are the same on driver's side. The distributor,on the front, turns counter clockwise. The clips to hold the cap on should be at 12 and 6 o'clock and #1 piston is the first one to the driver's side of the back clip. Hope this helps

Sep 07, 2010 | Ford F-100 Cars & Trucks

1 Answer

Brakes on the drivers side where the parking brake is are dragging.Can the brakes be adjusted without taking the drum off ? 2001 ford focus

no they cannot ,remove the drum because it could be a sticking /corroded pistons in the wheel cylinder holding the brakes on

Jun 12, 2010 | 2001 Ford Focus

3 Answers

1992 Honda Prelude Si brake caliper piston prob

As your car has a handbrake fitted to the rear calipers,you will need a piston wind in tool to retract the piston fully back into the caliper as when you adjust your handbrake the piston automatically winds itself to the required position for usage without this tool you are getting nowhere,so get hold of a tool to do the job and you should not have problem unless the piston has totally siezed on the screw then you will have a problem being the only way to repair would to be a new or refurbished caliper.

Feb 28, 2010 | 1992 Honda Prelude

1 Answer

Had problem with boot lid popping open when driving itpopped open today and i closed it and locked car when i opened car again the boot lid will not open

Same thing happened on my Focus. I suspected dirt had been preventing the boot from fully locking. A generous application of WD40 on the locking mechanism located on the boot seems to have resolved the problem.

Feb 24, 2010 | 2005 Ford Focus

2 Answers


My wife had a mid 80's capri and the latch/release button was on the drivers side door pillar at the back of the door near the bottom of the pillar, the door had to be open to see it, there was a second one that we only found when selling the car on the bottom of the drivers side door arm rest. Not sure if that helps as yours is newer but it might give you a couple of more places to start. On my son's Mercury Topaz you have to open the glovebox and push a semi=concealed button on the right..Those lovely engineers at Ford! lol...

May 11, 2009 | 1994 Ford Aspire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5626 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides