Question about Dodge Ram 1500

1 Answer

Where is the fusible link for 1999 dodge ram - Ram 1500 Dodge Cars & Trucks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 6,826 Answers

I know that fusible links on GM cars come directly off of the starter positive terminal. They can be identified by looking for a cylindrical (3/4" long by 1/2" in diameter) barrel of plastic on a colored piece of wire. If the technician pulls on a fusible link which is about 8" long (replacement), then the wire insulation will stretch by about 1" to 3" indicating the wire inside has broken.
---
I looked up fusible link on the 1999 Dodge Ram and came up with this information which is a little bit different as far as form factor:

Fusible Links Removal & Installation All Engines To Remove:
NOTE: If a generator cartridge fuse fails, be certain to inspect and test the vehicle charging system before replacing the cartridge fuse and returning the vehicle to service.

  1. Before servicing the vehicle refer to the precautions at the beginning of this section.
  2. Remove or disconnect the following:
    • The negative battery cable
    • The cover from the Power Distribution Center (PDC)
    • The two screws securing the generator cartridge fuse to the two B(+) terminal stud bus bars within the PDC
    • The generator cartridge fuse from the PDC
To Install:
  1. Install or connect the following:
    • The generator cartridge fuse onto the two B(+) terminal stud bus bars within the PDC
    • The two screws securing the generator cartridge fuse to the two B(+) terminal stud bus bars within the PDC
    • Tighten the screws
      1. Torque to: 30 in. lbs. (3.4 Nm)
      NOTE: Ensure that both screws are tightened to the proper torque values.
    • The cover onto the PDC
    • The negative battery cable
where is the fusible link - prev.gif next.gif

Posted on Oct 08, 2010

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 679 Answers

SOURCE: Where are the fusible links on 1999 dodge grand

Besides fuses there are fusible links up the chain near the battery.Thanks

Posted on Jan 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 1999 Dodge Avenger V6. Keeps blowing Engine Fuse under hood


Fusible link 3 feeds the PCM. the ASD relay, and fuel pump relay. Assuming it has A/T, that fusible link also feeds the starter relay, the EATX-ECM, and the EATX relay. A short in any of those elements could be causing the trouble.

Dec 16, 2016 | 1999 Dodge Avenger

1 Answer

What is the fusible link from starter on 1998 dodge ram 1500 5.9L "responsible" for?


A fusible link is basically a fuse built into a wire. It is designed to burn up whenever too high of an amp load is placed onto that circuit. If you have burned one up you will need to find out where the amp load came from and then replace with another fusible link of the same rating.

Apr 04, 2016 | Dodge Cars & Trucks

1 Answer

91 dodge ram charger wires on drivers side burnt were do i start car shut down


fusible links are short bits of fuse and can be easily replaced
it should have burnt before the harness was damaged
they are available at the spares section

Oct 22, 2015 | Dodge Cars & Trucks

1 Answer

Had a wire arc out on 1993 Dodge ram D150 and truck stalled no there's nothing when u turn the key over


Have to check all fuses and fusible links, fuses in fuse box and fusible links are in the line. They look like the wiring except when they blow they are very soft like only the outer cover of the wire is there. Hope that makes sense to you. Good luck.

Jun 06, 2015 | Dodge Ram Cars & Trucks

1 Answer

2014 dodge ram 3500 headlights work but nothing else.. no horn no start no crank


I believe most vehicles have fusible links which supply the fuse block, but that the headlamps are supplied through a different link. Kind of surprising if a 2014 truck has blown a fusible link though, so more likely there is some security system cutting power. Under warranty?

Jan 07, 2015 | Dodge Ram 3500 Cars & Trucks

2 Answers

Location fusible link 1998 dodge ram 1500 ignition


where exactly is the power lost at ? and what point do you have power to ? you won't get any power to ignition if coil is bad ? loose or bad connection to computer ? crank position sensor bad , I need more specific's to help you more.

Dec 22, 2014 | 1998 Dodge Ram 1500 4WD

1 Answer

I have a 2006 dodge ram 2500 and both of my headlights dont work what could be the problem


Check relay or fusible link (in line)--if okay--check for disconnected wires.

Feb 27, 2011 | 2006 Dodge Ram 2500

2 Answers

The AC fuse blows when I turn on the AC switch. It does not blow when the compressor is un-plugged. There seems to be a fusible link or something in the pigtail connector of the compressor that has...


I would investigate the fusible link to see if it is intact. Sounds like a problem with the A/C clutch or compressor drawing too much current, which blows the fuse. It would be a open, not a short, unless the wire has power and is touching ground.

Apr 29, 2010 | 1999 Dodge Ram

1 Answer

Electrical short no start 1999 dodge intrepid es 3.2 L


The newer cars have 'fusible links" installed to save us from ourselves. Coming from the positive battery post and or the solenoid are these wires - they are softer than regular wires and should appear burnt if they are bad. Please take it to a professional as you sound like a novice. If you find a fusible link bad and replace it with the wrong wire you can do permanent [ spelled expensive] damage so please take it to a pro.

I speak from experience about these as I damaged my own vehicle once messing with heavy wires on these.

Jan 28, 2010 | 1999 Dodge Intrepid

1 Answer

1999 3.2 Dodge Intrepid. Has had motor changed and can't read computer. Car dies at exit ramps and stoplights/signs.


It sounds like there is a fusible link blown under the hood. The link vary in location on chrysler vehicles but they should be near the computer.

Jul 02, 2009 | 1999 Dodge Intrepid

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

816 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...