Question about 2003 Chevrolet Tracker

1 Answer

Fuel pump relay

I want to change the fuel filter on my 2003 Chevy Tracker, 2.0 liter engine, 4X4, 2 door. How do I locate the fuel pump relay (which must be disconnected, engine started, & engine stops due to loss of fuel pressure) to release fuel pressure before replacement of the fuel filter?

Posted by on

  • Anonymous Mar 28, 2014

    location of starter relay for 2003 chevy tracker

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Fuel pump in back in the gas tank.

Posted on Jan 30, 2009

  • Ronson Jul 11, 2012

    Same problem but where is the fuse or relay before it gets to the pump? Thanks

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause you to lose fuel pressure while driving.


Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

Where is the fuel filter located at on a 1988 chevy s10 extended cab 4.3 liter motor 4x4


Most fuel filters are now in the fuel tank with the pump. If I knew the year, make and model, I could tell you for sure.

May 06, 2015 | Cars & Trucks

1 Answer

How to change 2003 kia optima sedan fuel filter


The fuel filter location varies with engine size on the Kia Optima. The 1.5-, 1.6- and 2.4-liter engines have the fuel filter located under the car in the front left corner of the fuel tank. The 1.8-liter engine has the fuel filter located on the driver's side firewall. All the filters have the same replacement procedure. There are actually two filters on the Kia Optima. A filter called a strainer is attached to the intake side of the fuel pump inside the fuel tank.

To change the filter follow this procedure:-

•Lift the hood and remove the cap on the fuse and relay box located on the driver's side fenderwell. Look at the bottom of the cap for the location of the fuel pump relay within the box. Pull the fuel pump relay out and lay it sideways in the box.

•2
Start the engine. It is not likely to start and even if it does it will only run for a second since the fuel pump relay has been removed, which disabled the fuel pump. This procedure will drop the fuel pressure in the fuel line. Raise the rear of the vehicle with the floor jack and support it by the frame with the jack stands. This is for engines 1.5, 1.6 and 2.4.

•3
Remove the fuel lines on both ends of the fuel filter. Use the scribe--a long pointy needle--to lift the white retainer straight up located in the center of the connector. This releases the fuel line from the fuel pump. Do the same to the other side of the fuel pump.

•4
Remove the bolt in the center of the fuel pump retainer bracket using a 10 mm socket. Pull the fuel pump out of the bracket.

•5
Insert the new fuel pump into the retainer bracket. Make sure that the inlet side faces the fuel line to the fuel tank and the outlet toward the fuel line to the engine. Install the fuel pump and bracket and tighten the bolt.

•6
Place a white retainer clip that came with the filter into the holes in each of the connectors. Just push it in enough to snap the bottom ends of the clip in place. The clip should now be standing straight up with just the bottom tips in the connectors. Push each of the fuel lines into the filter one at a time. Holding the fuel line tightly into the filter, push the white retainer clip down to lock the fuel filter and fuel line together. Lower the car and replace the fuel pump relay. Start the car and check for leaks.

Jun 19, 2014 | 2003 Kia Optima

2 Answers

Where is the fuel pump relay on the 2001 Chevy Tracker?


Hi, here is the location of the fuel pump replay below....

ameezle_1.jpg

Hope it helps....

Jul 12, 2011 | 2001 Chevrolet Tracker

2 Answers

Where is fuel filter located on 2000 chevy tracker


I have a 2000 Chevy Tracker and I would like to know the location of the fuel filter .

May 29, 2010 | 2000 Chevrolet Tracker

1 Answer

I have a 1993 chevy 1500 4x4,with a 4.3 engine,and tbi,i have no fuel pressure,i have changed the fuel pump,fuel stainer,fuel filter,fuel pump relay,and fuel pump fuse,but i have still have no fuel to the...


Chech the ground on the pump from wire harness from tank....they get old and lose the capacity to ground ....also check for power at the tank with a circuit tester....if no power...you have wiring issues...

Aug 09, 2009 | 2001 Chevrolet Blazer

1 Answer

Locate fuel filter, and safety switch to fuel pump


The filter is located at the rear seat, you have to remove it first, then you will see a cap attach with some screws. Inside that cap you`ll find the fuel filter. Before you change the fuel filter you have to release the fuel pressure first. To do that, first find the FUEL PUMP RELAY in the main fuse box located in the engine. Once you located open the fuel door and take off the cap and leave it open. Start the engine, take off the FUEL PUMP RELAY and leave the engine stop itself, when this occurs turn off the key, the you can take off the filter and changed it

Apr 21, 2009 | 2001 Hyundai Elantra

Not finding what you are looking for?
2003 Chevrolet Tracker Logo

995 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...