Question about Honda Accord

2 Answers

Does the engine on the 90 accord have to be removed from the car to change the water pump or is there an easier way to do this? Also, does the fuel pump have a start or stop relay under the hood? Thank you.

Posted by on


2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

  • Expert
  • 60 Answers

NO, the engine does not have to be removed for water pump replacement.The water pump runs off of the timing belt,so you have to remove the timing belt.If you need instructions for this just e-mail me and i will get you through it.Yes,the fuel pump has a relay under the dash.It supplies voltage to the fuel pump and the electronic fuel injection if equipped.Hope this information helps,

Posted on Oct 08, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Honda Master
  • 22,326 Answers

I do them in situ but have not done one in ages ,well at least for the last 7 yrs ,cars have a annual vehicle mechanical here in spain so old cars are junked because things go wrong and its just not worth repairing ,mainly exhaust emmisions

Posted on Oct 08, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Have a 90 chevy Cheyenne,why does the fuel gauge always read around empty or just above? Is there an easy fix? Thanks.

Loosen the pickup box mounting to frame bolts.Remove all driver side bolts and lift/tilt driver side of box high enough to access fuel pump sender unit easily.Remove fuel pump assembly unit and cycle float while watching fuel gauge.Should be as simple as adding a little more pressure on the fuel gauge sliding contacts on the fuel pump assembly.
This job should take about 1 hour.
Always lift the box when changing pick up fuel pump assembles as it is faster and easier than dropping fuel tanks.

Apr 15, 2018 | Chevrolet Cars & Trucks

6 Answers

1992 Honda Accord, fuel filter replacement instructions, can you send these to me, thanks

It's not the filter. But replace it anyway. I would look more toward the ignition. Crank sensor, coils, and lose of power to them. Have the codes read.

Dec 13, 2014 | 1992 Honda Accord

1 Answer

My camaro stalls when its cold and hesitates when i push the accelerator

Sounds kinda like the engine is leaning out. Is it a 1990 or a 1997? Is the check engine light on? For 1990s, an inexpensive key can be purchased at a parts store that you can plug into the ALDL (Diagnostic Port) and then count the flashes of your check engine light to read codes. I would change the fuel filter too, just because it's easy and cheap. You may want to check the fuel pressure. If it's a '90, the regulators go bad easily and is surprisingly easier than you may think. - MUCH easier that rebuilding an old-school carb! Could also be the pump- hope not! Don't let it run low on gas if you can help it. the gas in the tank acts as a coolant for the motor that drives the fuel pump. GOOD LUCK


Mar 15, 2013 | 1997 Chevrolet Camaro

2 Answers

The car will not start. I have replaced the fuel pump relay and the fuel pump, but it still will not start

Alright, when you attempt to start you car, is the engine slowly trying to turn over, if so, your battery low, and maybe needs charging and replacement and if it is a new or fully charged battery, and your fuel pump is pumping and you do get pressure at the fuel filter ( located at the engine bay/firewall area) then your ignition coil is bad. Replacing the ignition coil (which is located inside the distruburator) or the whole distruburator unitt (if cheap) will work. Had this promblem on a 90 accord.

Jan 30, 2011 | 1991 Honda Accord

1 Answer

Hi mate, i got problem, i got honda accord vtec 2001 a/c, so where is fuel filter, and how its looks,cant find,cant see.. i dont understand from that car enything, i know that is fuel filter, becase car...

Fuel Filter Removal & Installation To Remove:
  1. Remove fuel tank.
  2. Remove fuel pump/fuel gauge sending unit.
  3. Remove fuel filter from fuel pump/fuel gauge sending unit.
To Install:
  1. Install fuel filter to fuel pump/fuel gauge sending unit.
  2. Install fuel pump/fuel gauge sending unit.
  3. Install fuel tank.
However, I would look at ignition or tune up issues rather than simply a fuel filter.

Find out what the engine problem is by having the engine's computer scanned through the OBD-II port.

Oct 23, 2010 | 1999 Honda Accord

1 Answer

Fule pump how to install

look under rear seats or in boot floor for round inspection cover. remove screws lift cover off and disconnect wiring and fuel pipes then remove unit from top of fuel tank. fuel pump should be located at bottom of unit. MUCH EASIER WITH NEARLY EMPTY TANK OF FUEL

Jul 17, 2010 | 1997 Honda Accord

1 Answer

On a saturn 2000 ls 2.2 liter engine do i have to take off timing beit covers can i just change the water pump

No, you should only have to remove the accessory drive belt. Remember to drain your cooling system, so you all your coolant doesnt spill out when you remove your water pump. Also, it is easier to remove the water pump from the passenger wheel opening, jack you car remove the tire and the inner fender splash shield and it should make the job a lot easier. Hope this helps, let me know if you have any other questions.

Feb 07, 2010 | 2000 Saturn SL

1 Answer

I need to change the water pump and im not sure how

This is a simple Job.
First you need to make sure that yoou drain your coolant system. This will make it so that when you remove your old water pump you wont spill all of the coolant. Thenn you will need to remove the accessory drive belt. The water pump should be located on the passenger side of the engine. It will be easier to access the water pump from the passenger wheel opening. You will need to jackk you car, remove the tire and inner splash sheild, this will make the job easier but if unable to use a jack, you may be able to remove it from the engine compartment. Once the drive belt is removed, remove the water pump mounting bolts and detach the water pump from the engine. If the water pump is stuck, gently tap it with a soft faced hammer to break the seal.

Hope this helps! Good Luck!

Feb 05, 2010 | 1994 Saturn Sl

2 Answers

Fuel filter on 98 neon

i doubt you will have to change the fuel pump it should be located under the car between the tank and engine possibly more less toward the tank.

Jun 21, 2008 | 1998 Dodge Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides