Question about Hyundai Excel

1 Answer

How do i get water out of my tail lights? - Excel Hyundai Cars & Trucks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Contributor
  • 254 Answers

Find the smallest drill bit that you can, and at the lowest point of the lens drill a very small hole. It will keep any water from collecting in that lens.

Posted on Oct 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do i keep water out of my trunk


New trunk seal , that rubber thing around the edge of the opening !

Nov 01, 2015 | 1998 Buick Regal

1 Answer

Tail light bulbs keep burning out


DEPENDS ON THE CAR, ARE YOU USING THE RIGHT LIGHT BULBS, ARE THEY NEW, IS THERE ANY SIGN OF WATER IN THE TAIL LIGHT, ARE THE TAIL LIGHTS FIRM IN THE CAR OR THE SOCKETS FIRM ON THE LENSS, ANY VIBRATION MAY MAKE THE BULB BURN.

May 22, 2014 | Cars & Trucks

1 Answer

1999 pontiac gtp tail light fuse


were the bulbs under water? direct short.

Dec 29, 2013 | Pontiac Cars & Trucks

1 Answer

2001 ford focus left tail light not working... left brake light does


You should have the computer scanned for trouble codes for the warning light.
As for the tail light, I would check the socket with a test light or meter to see if the socket is getting power for that circuit. The brake-turn signal circuit of the bulb is different from the tail light circuit.

Sep 25, 2012 | 2001 Ford Focus

1 Answer

Trunk leak-cant find the rear drains from sunroof


If water is in the trunk, then it is probably getting in through the rear tail lights. Common problem with early 90's Honda cars. To check, hose down the trunk area and tail lights, then look at the gaskets from inside the trunk. You'll probably will see some water. To fix, you need to take each tail light out and place a seal of silicon caulk between the body of the car and the tail light gasket and replace the tail lights. This should solve your water in the trunk problem.

Jan 23, 2011 | 1993 Honda Accord

1 Answer

2006 chevy impala rear tail light...


there is a connector that plugs into the light that should be looked at. is there any water leaks anywhere. there were problems with water leaks on some malibu models around the tail lights. pell open the inside covers and get to the tail light to inspect for this. also check those bulbs just in case they did go bad. any condensation in the light? not sure if the Impala has a single fuse for both tail light or one for each but you should check fuse box under dash and under the hood. good luck

May 14, 2010 | 2006 Chevrolet Impala

2 Answers

Water in tail light 2000 buick lesabre


hi, if you have water inside your tail light then this means that the seal on your tail light has become damaged due to corrosion the only thing you can do is replace the whole tail light.

Not doing this will cause the electrics to corrode causing you loads of problems with the lights and would also blow loads of fuses.

Its best you change this sooner rather than later as it would save you money in the long term.

Let me know how you get on or if you need further assistance ok

Oct 12, 2009 | 2000 Buick LeSabre

2 Answers

Water in tail lights


I had the same problem a few years ago with an 86 Volvo. I replaced the tail light assemblies but over time water was getting inside the lens again. My solution to the problem was to remove the tail light assemblies and drill a small hole (about 3/16") on the bottom of each compartment of the lens (if the tail light is sectioned off) and a 1/16" vent hole in the top or side area where it can't be seen. It worked for me and it didn't cost a dime. Hope this helps.

Apr 14, 2009 | 2005 Chevrolet Impala

1 Answer

HAVING PROBLEMS WITH THE TAIL LIGHTS ON A 1995 MITSUBISHI GALANT FUSES AND BULBS BOTH WORK, STILL NO TAIL LIGHTS, COULD THIS BE AN ELECTRICAL PROBLEM?


Problem caused by light assembly L or R grounding out when water seeps thru tail light housing gasket. Change light unit assy to solve problem.

Sep 26, 2008 | Mitsubishi Galant Cars & Trucks

2 Answers

Tail light removal


You remove the tail light by removing the nuts or bolts from inside the trunk area. This is what holds the tail light in place.

Jul 21, 2008 | 1998 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...