Question about Dodge Intrepid
There are bleeders on the motor you open them and close them when coolant comes out without air.
Posted on Nov 06, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: radiator dodge intrepid 1999
Remove the radiator cross member, remove all bolts, remove all hoses. Detach tranny lines. If you have AC disconnect the condensor from the radiator.
Posted on Sep 04, 2008
you should only have to remove the plastic filter holder and the hose is right there on top of the motor.the plastic breather/filter cover is the only thing you should have to remove to get to the hose
Posted on Jan 18, 2009
the easiest way is going to first be to remove the serpentine belt which requires you to loosen the nut on the end of the idler pulley just above the alternator, then behind the pulley is a bolt with a 13mm head on it that you will want to loosen after the pulley is loose to relieve tension off the belt. Remove the belt. Next make sure you remove the battery cables to ensure you dont fry yourself to the car when unhooking the electrical connections from the alternator, your battery is located on the passenger side, down behind and underneath the headlight. Then go under the car and remove the black plastic clips that hold the splash shield up under the bumper. After this the alternator becomes as accesible as it can be, remove it from the bottom. Thanks for using fixya!!
Posted on Mar 15, 2009
Ok well there are two issues here the boiling and the potential for the transmission to be harmed by the contamination of the tranny fluid by antifreeze. First A/T fluid is not going to harm the coolant system in the least, however antifreeze in the trans. fluid will harm the automatic transmission get the tranny flushed as soon as possible , Change out the thermostat then refill radiator using 50% water 50 % antifreeze ( premixed in container) fill radiator then run the car without radiator cap add coolant as needed, put you radiator cap on and wait 5 - 10 minutes until car comes up to operatimg temp. you must observe the engine to make sure the electric radiator fan comes on after the car runs for at least ten minutes if it does not the problem is the usually the radiator fan relay or the fan coolant temperature sensor last in rare cases the fan itself. As for the air bleed usually letting the car run with the radiator cap off for ten to fifteen minutes will do it just make sure you don't remove the radiator cap when the car is hot 2nd degree burns usually hurt.
Posted on Jul 14, 2009
check your oil and make sure you dont ahve a blown head gasket and that your thermostat is good (throw it in boiling water and see if it opens), and if you are losing water/coolant with no drips or puddles than it may be leaking in a cylinder which means bad head gasket as well
Posted on Aug 24, 2009
Tips for a great answer:
Apr 26, 2014 | 2004 Dodge Intrepid
Feb 23, 2013 | 2000 Dodge Intrepid
Feb 23, 2013 | 2001 Dodge Intrepid
Feb 01, 2013 | 2001 Dodge Intrepid
Mar 31, 2012 | 2001 Dodge Intrepid
May 09, 2011 | 2001 Dodge Intrepid
Aug 26, 2009 | 2000 Dodge Intrepid
Jul 12, 2009 | 2001 Dodge Intrepid
Jan 17, 2009 | 1995 Dodge Intrepid
Nov 18, 2017 | Dodge Cars & Trucks
Nov 17, 2017 | Dodge Intrepid Cars & Trucks
115 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: