Question about 1984 Chevrolet S-10

1 Answer

I need the wiring layout for an 1984 chevy s-10 ignition module

Posted by on

1 Answer

Got an 84 shop manual with wiring

What do you need ?

Also got a 1984 S10 Blazer since new

Posted on Oct 08, 2010

  • Charles Glass Sep 01, 2012

    I need to replace the eng harness on my 84 s10 a diagram would be very helpful. It caught fire after I parked it I forgot something in the truck and it was smoking from under the hood. I don't know what would have caused it. Do you have any ideas? I'd like to fix the problem before I install the new harness.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1984 chevy citation 2i died in the middle of the road...4 cylinder model.... its not spraying fuel and not getting spark the fuel filter is good fuel is getting to the injector but not spraying..... i...


Are you getting power to the coil ?
It could be the stator-pickup in the distributor or a lack of voltage to the ignition system.
Is the check engine light on when you turn the key on ?

Aug 01, 2012 | 1984 Chevrolet Citation

1 Answer

Where is the ignition modulator located in a 1984 toyota truck


Ignition "modulator"??? I assume you mean "ignition module" or "Ignition control module". If this is what you mean, it is mounted on the ignition coil assembly. Toyota refers to this part as "transistorized ignitor".

Jun 13, 2012 | 1984 Toyota Pickup Deluxe

2 Answers

Trying to locate the ignition module for chevy blazer s10 1994


Ignition module sits in the ignition distributor, remove distributor cap, there will be two elec. harness plugs, the one with two wire's is for the pick up coil, the other one is for the ignition module, just unscrew module out of distributor and install new one.

Sep 23, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

1984 ford f-150 4x4 ignition wiring diagram i need to see a break down wire for wire from starter to soloid to voltage regulator new starter new ignition module new started soloid and vechicle will not...


when looking at it from the front the most left is from the battery, now going right from there the little pin is from ignition, basically to flip this giant switch on. next little pin goes to your fuel shut off relay, it will turn on that relay to send power to your pump while cranking, next is the large out. far right. that goes to your starter.

May 16, 2010 | Cars & Trucks

2 Answers

I have a 1988 chevy s-10 pick up with the 2.5l 4 cylinder engine with high miles. The truck died while driving and now will not strat. I think it may be a bad ignition module.


The easiest way to check for spark is to pull a spark plug wire or the coil wire enough that the spark has to jump a gap. The spark will jump a quarter of an inch and make a snapping noise doing it. Have someone else turn the ignition key while you look and listen for the spark. Don't hold the wire during this, it might use you for a spark plug. It's 20,000 volts (or more) for a very short time, which won't usually kill you, but it is an unpleasant jolt (the voice of experience talking here)...

Aug 13, 2009 | 1984 Chevrolet S-10

1 Answer

98 s-10 2.2 Fuel Pump Pressure


40 psi good lower than that bad

Apr 21, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

1984 chevy p/u with 305 no spark


computer coil power try to disconet the spout wire..... its under the hood by passenger firewall ....... its a brown wire or behind the glovebox

Oct 21, 2008 | 1984 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

203 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...