Question about 2003 Jeep Grand Cherokee

1 Answer

Feel like front end is coming out.pulling bad to left then bad to right

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Contributor
  • 254 Answers

Its very important that you get your front end check first. A little small thing like tire pressure will also cause that. How good are the tire treads. When was the last time that you had your front end aligned.

Posted on Oct 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car feels crooked


When you said you had several alignments, where they just front wheel alignments, or all four wheel alignments?

Sometimes, the rear can get out of alignment, also.

Jan 21, 2014 | 2009 Hyundai Accent

1 Answer

WHILE DRIVING THE ENTIRE JEEP PULLS TO THE RIGHT WHILE TURNIN RIGHT


id say, (i cant drive it or feel it or test it) but...
id say, its too dangerous to drive.
pulls to right. car move to right, with no braking ,rigth>?
ok the right front , wheel bearing is seized or bad rotor/caliper.
gee, jack up front wheel, spin it by hand is it free. or loose or wobbling?
if you dont know how it should feel , then try the left side.

can be;'s?
bad wheel bearing
bad brakes ,or horrific rotor crack (man killer that is) sized caliper pistons or caliper, slider pins seized,
collision damage
or road hazard hit front right end parts and its all messed up, (look)
diagnosing on the internet is , well impossible, it takes, hands, eyes and hears. on car and test.

Id already have the wheel off looking not posting.. sure would.
I think its dangerous. so take it any mechanic, with the ASE badge
on his/her sleeve. and save you life and maybe all those folks
on the right sidewalk.

Nov 28, 2013 | 2002 Suzuki Grand Vitara

1 Answer

Steering problems in 91 ford festiva.


Sounds like lower control arm is lose. Either ball joint or tierod end are bad or not tight. Check nut for tightness. If tight jack front of car up and shake tire up down left right. That will show you whats lose

Jan 23, 2013 | Ford Festiva Cars & Trucks

1 Answer

Front end issues


it sounds like you have a freezen right front caliper

Nov 05, 2012 | 2006 Jeep Grand Cherokee

1 Answer

Pulling back and forth in steering almost feels like in 4 wheel drive


Could the front control arms be worn out and letting the differential shift around ?

Sep 26, 2012 | 1996 Ford F250 Crew Cab

1 Answer

Front end shakes all the time could it be the tires? it also pulls to the left


A bad tire will cause a pull and can also make the car shake.It could also be loose front end parts.You may need new tires and the front end checked.If you get new tires you should also get an alignment done.Hope this helps.Good luck.

Jun 15, 2012 | Mitsubishi Galant Cars & Trucks

2 Answers

Something Humming


sounds like a wheel bearing is going bad

Feb 07, 2012 | Chevrolet Venture Cars & Trucks

2 Answers

When driving down the road the truck pulls to the left or to the right


you have a worn out or loose steering component. easiest way to find it is to jack up the front of the truck so both tires are off the ground. grab the tire and "turn" it left to right, to simulate the actual steering. you will probably feel some kind of movement. like a loose feeling...its difficult to put into writing. but if you watch the steering parts while a buddy trys to shake the tire around a bit, then you should be able to spot what is loose or worn. keep an eye on the tierod ends, and the ball joints especially. but it could even be a bushing on the control arm. once you find whats loose, you either tighten it up, or replace the parts as needed. you may have to try shaking both tires (not at the same time), depending on what side of your truck the bad part is on. also check to see if the tire moves when you try to move it front to back. that would indicate bad wheel bearings.

Aug 09, 2009 | 2005 Ford F 250 Super Duty

1 Answer

Just Got A Honda Prelude What Do I look For?


Take a look at the cv joints....the boots that cover the ends that go into the tranny and the end that attaches to the tire area. Look at the color of the oil...see if it is grey or tainted with anything other than motor oil.

Take a look at the belts....cracks fraying, shredding....is the belt tight....that type of thing for the belt inspection....look for shiny spots...leads to squealing.

Drive the vehicle at different speeds....you're paying attention to the "feel" of the steering...this will give you indications of the front end....it pulls left, it pulls right.....wobbles....make turns left and right....listen for clunks....all this will let you know the condition of the front end/steering system.

Get on the highway or open road.....drive about 45-65 and slow down faster than usual...if it pulses in the front end, and you can feel it in the steering wheel...good bet the rotors are warped from high speed braking. Squeeks when you apply breaks....brake wear indicator telling you the brakes are worn.

Jack the front of the car up and twist and pull...push and pull the left and right tire....anby wobble or noises...may have bad bushing/ball joints/cv joints.

there is a lot of stuff to look for...but this is a few things to keep you busy.

Hope this helps you.

Please don't forget to rate.....Thanks

Mar 14, 2009 | 2005 Chrysler PT Cruiser

1 Answer

Car steering


There could be numerous problems going wrong. Your car is rear wheel drive so it could very well be a bad wheel bearing. If it is extremely loose it can cause a shake in your steering wheel. You may want to check on the condition of your tires and rims especially the left front. A bad tire can cause a shake and pull. If you know how to use your car jack you can try jacking the vehicle up, and put both hands on your front wheel and move it manually to see if there is looseness. Most shops only charge about 1/2 hour to shake down the front end. BMW parts are expensive so be prepared!

Jul 19, 2008 | 1994 BMW 3 Series

Not finding what you are looking for?
2003 Jeep Grand Cherokee Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75824 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...