Question about 1994 Chevrolet S-10 Blazer

1 Answer

I have no prob with 1st 2nd rev. or park but when driving and shifts from 2nd to drive i loose drive and overdrive motor just revs somtimes i can rev motor to grab gear but most time nothing slow back down and i get 2nd and 1st back. Truck sat for 2 years with no fluids i have replaced filter with no results. your advise and recomendations will be appretiated greatly

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 178 Answers

The splines in the bucket are stripped out this is very common at my shop it needs an overhaul.

Posted on Oct 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2001 trooper 2wd trans not going into forward gears unless rev motor .it started 2 days ago while in drive shifting to 2nd it would rev up then go in gear.Yesterday put in drive felt like parking brake...


it looks like you have pressure problem valve body related issue shift solenoid could be at fault need proper testing before replacing if no engine codes showing for the symptom

Jan 19, 2010 | 2001 Isuzu Trooper

1 Answer

1992 GMC Suburban not shifting into OD, Transmission Modulator?


The shift down linkage on the carburetor below the gas pedal cable might need to be adjusted to increase the hydraulic pressure on the internal clutch plates in the transmission it shows you how to do that in a car manual.

Jan 07, 2010 | 1992 GMC Suburban

1 Answer

4l60e going from 1st to 3rd and dont have overdrive any more


You most likely have a broken sunshell inside the transmission. They tend to go out when the transmission is shifted to drive when while still rolling in reverse.

Dec 28, 2009 | 1994 Chevrolet C1500

3 Answers

Automatic car won't shift from 2nd to 3rd, it just revs up


no you have a failed transmission on your hands, it is slipping.

Aug 13, 2009 | 1993 Oldsmobile Cutlass Ciera

1 Answer

Nissan Sentra 2005 automatic. gear shift from 1st to 2nd


drain and fill trans with fresh fluid
trans may have to be rebuilt

sorry

Jun 24, 2009 | 2004 Nissan Sentra

2 Answers

The engine rpms rev when shifting


Your trans is slipping, u are going to need to have it checked out at a trans shop, they will test drive it in most cases for free and report what they think is wrong or recommend more diagnostic work if they are unsure..

May 21, 2009 | 1999 Honda CR-V

1 Answer

Overdrive light is flashing and tranny is slipping in drive and 2nd


my overdrive light is flashing due to a shattered speedo cable tip. check your fluid level. you may have to change the tranny filer and redo all the fluid.

May 21, 2009 | 1992 Toyota 4Runner

1 Answer

Transmission passing gear keep either getting stuck or it dont work because the motor keep idling up in first gear


this could be relative to many things, however you should check a few things before asessing the possibilities. When you put the truck in gear from park, Drive (overdrive) Should be the third notch you come to. so your in park, pull down clunk you're in reverse, clunk you're in neutral, clunk, now you are in drive. If you dont feel/ hear four notches/ clunks, you should be in overdrive. If you take off and it over revs 1st ( you shouldn't see more than 15 mph before it shifts on a stock transmission unless your flooring it and taking off fast) and then hard shifts to second gear, progresses to third gear normally, but wont progress into overdrive, it may be related to your vaccum advance, your shift linkage, or even possibly your timing. From the sounds of it, I would say vaccum advance is the likely cause, if it is otherwise in stock condition. If this is the case it could be as simple as reconnecting a vacum hose to the distributor. Should be to the left hand side of the cap, between the cap and intake manifold as you are looking at the firewall.

Mar 15, 2009 | 1990 Chevrolet Suburban

2 Answers

1992 Mitsubishi Eclipse transmission slips in overdrive


well the low cost way to go first would be to try and change the trans fluids. If the problems still remains the it may be an internal problem

Feb 25, 2009 | 1992 Mitsubishi Eclipse

Not finding what you are looking for?
1994 Chevrolet S-10 Blazer Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...