Question about 2004 Jeep Grand Cherokee

Open Question

Where is the crankshaft sensor located on a 4.0 liter 6 cyl 2004 Jeep Gran Cherokee Laredo

Posted by on

  • cheap repair Oct 07, 2010

    2004 Jeep GRAND CHEROKEE Recall ID from NHTSA: 04V112000
    Auto Recall Date: 03/04/2004
    Vehicle Component: ELECTRICAL SYSTEM:STARTER ASSEMBLY
    Estimated Vehicles Affected: 14621
    2004 JEEP GRAND CHEROKEE Defect Summary:
    ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH 4.0L ENGINES, THE CRANKSHAFT POSITION SENSOR WIRING INSULATION MAY CRACK AND EXPOSE THE WIRE.
    Defect Consequence:
    IN THE PRESENCE OF MOISTURE, THIS COULD RESULT IN SENSOR MALFUNCTION, WHICH COULD CAUSE THE ENGINE TO STALL, INCREASING THE RISK OF A CRASH.
    Remedy:
    DEALERS WILL REPLACE THE CRANKSHAFT POSITION SENSOR. OWNER NOTIFICATION BEGAN ON MARCH 29, 2004. OWNERS SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
    Notes: DAIMLERCHRYSLER CORPORATION, D13

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2004 jeep gran cherokee front end clunk

you must replace and lube the front sway bar bushings,chrysler service bulletin calls it a squak, but can sound like a rubbing, a clunk etc the common factor is this is really noticeable the colder it gets outside

Posted on Mar 03, 2009

  • 10 Answers

SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997

left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,

Posted on Jun 13, 2009

  • 285 Answers

SOURCE: crankshaft sensor located 98 jeep grnd cher 4wd 6cy

it is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker on the end of it...leave it there,it is used for correct spacing between the sensor and the flywheel,hope this helps

Posted on Sep 23, 2009

Testimonial: "Everything was just like you said but as a not atleast for my jeep it is an 11mm not 13mm. Works great so far (keep fingers crossed) "

dburns60
  • 410 Answers

SOURCE: Where is the Intake Air Temperature Sensor or the

The air temperature is taken between the air filter and the throttle body. Look in the roof of your air cleaner box. (usually 2-pin plug) After the air cleaner, the tube that sends the air to the throttle body has the mass air flow sensor in it.(usually 4-pin plug)

Posted on Apr 29, 2010

  • 1757 Answers

SOURCE: need firing order for 1998 Jeep Cherokee gand

For the 1998 Jeep Grand Cherokee Laredo:
I do not know if you have the 4.0L In-Line 6-Cylinder, the 5.2L V8, or the 5.9L V8; however I have included ALL below:

For the 4.0L In-Line 6-Cylinder:
Firing Order:
1-5-3-6-2-4
Cylinders:
(back)
...6
...5
...4
...3
...2
...1
(front)

Distributor:
....(back)
.....5....3..(+)-screw
1.............6
(+).4....2

For the 5.2L V8: AND 5.9L V8:
Firing Order:
1-8-4-3-6-5-7-2
Cylinders:
.......(back).......
|..8..|.........|..7..|
|..6..|.........|..5..|
|..4..|.........|..3..|
|..2..|.........|..1..|
.......(front)
Distributor:
.....(back)
.......3
..4.........6

8.............5
..1.........7
.......2
......(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

Posted on May 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I HAVE TO CHANGE OUT A CRANK SENSOR IN MY GRAND CHEROKEE.


Jeep Crank Sensor Replacement, P Codes P0351, P1391 ...

? 6:24
www.youtube.com/watch?v=7D0vUEDSwXo
May 12, 2013 - Uploaded by Robert DIY Replaced the crank sensor on this 2003 Jeep Grand Cherokee.... to replace my crankshaft position sensor on my 1998 grand cherokee laredo.

Jeep Crankshaft Position Sensor Replacement (CKP, CKPS ...

? 4:07
www.youtube.com/watch?v=1Ho5iAKQV00

Oct 27, 2013 - Uploaded by WeekendHandymen
hi , do you think if I replace crank sensor will solve the problem ,my jeep .... Where's the crankshaft located in 99 jeep grand Cherokee laredo .


Oct 24, 2015 | Cars & Trucks

2 Answers

Fireing order diagram


cylinder firing order is: is 1-5-3-6-2-4 .... In Jeep Grand Cherokee Laredo ...Happy motoring.

Sep 04, 2014 | 1996 Jeep Grand Cherokee

1 Answer

What is the location of the crankshaft sensor


If you have a 6 cyl engine it is locted at the flywheel drive plate, if you have a 4.7L v8 it is at a reluctorwheel at the rear of the crankshaft.

Jul 11, 2014 | 1995 Jeep Grand Cherokee

1 Answer

Wher is the ignition control module located in a jeep grand cherokee lorado


6 or 8 cylinder? Either way the computer (ECM) controls the coils. 6 cyl has a 'coil rail' and 8 cyl had individual coils on each cylinder. There are crankshaft and camshaft sensors that tell the ecm when to fire each cylinder

Dec 12, 2012 | 2000 Jeep Grand Cherokee

1 Answer

Power steering fluid leaking 2000 jeep gran cherokee laredo 4.0 liter 6 cylinder


Possibly a bad P.S. hose, or maybe a loose hose connection. Close inspection is the only way to find the leak.

Feb 17, 2012 | 2000 Jeep Grand Cherokee

2 Answers

Trying to locate my 2003 grand cherokee laredo 6 cyl, upstream oxygen sensor.


The sensor will be screwed into the exhaust pipe or manifold and will have a one wire lead attached to it. It will be forward of the catalytic convertor. A 7/8" combination wrench should remove it but a special socket (at any auto parts store) may be required.

Sep 05, 2011 | 1996 Jeep Grand Cherokee

1 Answer

Need firing order for 1998 Jeep Cherokee gand


For the 1998 Jeep Grand Cherokee Laredo:
I do not know if you have the 4.0L In-Line 6-Cylinder, the 5.2L V8, or the 5.9L V8; however I have included ALL below:

For the 4.0L In-Line 6-Cylinder:
Firing Order:
1-5-3-6-2-4
Cylinders:
(back)
...6
...5
...4
...3
...2
...1
(front)

Distributor:
....(back)
.....5....3..(+)-screw
1.............6
(+).4....2

For the 5.2L V8: AND 5.9L V8:
Firing Order:
1-8-4-3-6-5-7-2
Cylinders:
.......(back).......
|..8..|.........|..7..|
|..6..|.........|..5..|
|..4..|.........|..3..|
|..2..|.........|..1..|
.......(front)
Distributor:
.....(back)
.......3
..4.........6

8.............5
..1.........7
.......2
......(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

May 28, 2010 | 1998 Jeep Grand Cherokee

1 Answer

I have a 1994 Jeep Grand Cherokee Laredo 6 Cyl. The vehicle was kind of running rough on idle. Take in consideration that I have replaced the spark plugs, spark plug wires a while ago. So I decided to...


CHECK ASD RELAY THAT IS AUTOMATIC SHUTDOWN RELAY IN THE POWER DISTRIBUTION CENTER UNDER THE HOOD IN ENGINE COMPARTMENT.IF ASD RELAY GOOD PROBLEM COULD BE CAMSHAFT SENSOR IN THE DISTRIBUTOR.TO SAVE TIME AND MONEY HAVE JEEP SCANNED FOR CAMSHAFT SENSOR AND CRANKSHAFT SENSOR FAULTS.

Apr 23, 2010 | 1994 Jeep Grand Cherokee

2 Answers

Replace a crankshaft position sensor on a 1996


1st I need to know what engine you have, 4.0L or 5.2L V8.

Oct 02, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Where is the Oil Pressure Sending Unit 96 Jeep Grand Cherokee 4L


the sensor is located right above the oil filter, careful they crack very easily...but are really easy to replace...

Dec 03, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...