Question about 1991 Ford F350

Open Question

My1991 ford f350 turns easy to the left but hard to the right

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4340 Answers

SOURCE: 2000 F350 Ford - when left indicator is turned on

This is a grounding issue, hopefully at one of the corners, but also can be in dash,

Pull each light bulb and re test... Current is feeding back through due to problem ground.

Another way to test, get really long wire, guarantee ground on battery, invoke test, have handy assistant observe the dash and take your long wire and ground each light assembly... Be sure to inspect trailer hookups ..

Posted on Sep 27, 2009

Ad
  • 11800 Answers

SOURCE: 2000 f350 super duty 7.3 drw steering seems to

The control valves from the power steering unit lock in position at extreme angles. Either the fluid is dirty - replace it - or the unit is worn out - valves can be replaced separately and the unit refurbished. Or just buy a new unit.

Posted on Oct 25, 2009

  • 5537 Answers

SOURCE: 2005 ford f350 4*4 hard pull to left .I have

When you say it pulls to the left, I am assuming only when the brakes are applied. And if the pull problem was there before you replaced the calipers, it is a problem like a plugged primary brake line from the master cylinder or proportioning valve. The master cylinder could be bad. The new right caliper could be bad. Need to disconnect hoses closer to master cylinder and hit brakes to see if fluid flows good. Then follow hoses down and repeat.

If this happened after the new pads were put on sometimes the pad length is different on the inner and outer pad and both longs on one side will grip more than the 2 short pads on the other side.

If this pulls without brakes on you may have stuck left 4x4.

Posted on Jan 14, 2010

  • 1244 Answers

SOURCE: have a ford f350 2003 when the truck is running

the hyrdo booster is bad has a interanl leak it is part of the or i should say is right behind the master cylinder

Posted on Jan 21, 2010

  • 157 Answers

SOURCE: steering is easy to turn

that sounds like the valve in your pump isint working

Posted on Jan 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

94 Ford F350 power steering real hard left or right pump or gear?


First thing to check would be the power steering pump. Check the fluid level and with the truck running, you should see fluid moving in the reservoir.

Feb 18, 2011 | 1995 Ford F350

1 Answer

I have a 2006 F350. When my right turn signal is turned on, it flashes rapidly, faster than the left. Could you please advise me to what the problem may be? Is this serious? Thank-you Brent...


one of your turn signal light bulbs is burnt out. Turn on your hazard lights and walk around the truck to identify the burnt out bulb that will need to be replaced.

Jan 05, 2011 | 1997 Ford F350 Crew Cab

1 Answer

Very hard to turn at idle or low (parking lot) speed. would it be the pump or hydro boost unit? or possably an air bubble?


it should be the pump had the same problem and changed the pump. when you put the new one on fill it up with derxon 3 or 5 auto trans fluid leave cap off and turn wheel to left and right slowly until air is out of system then fill to hash mark on stick.

Aug 06, 2010 | 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

2005 ford f350 4*4 hard pull to left .I have


When you say it pulls to the left, I am assuming only when the brakes are applied. And if the pull problem was there before you replaced the calipers, it is a problem like a plugged primary brake line from the master cylinder or proportioning valve. The master cylinder could be bad. The new right caliper could be bad. Need to disconnect hoses closer to master cylinder and hit brakes to see if fluid flows good. Then follow hoses down and repeat.

If this happened after the new pads were put on sometimes the pad length is different on the inner and outer pad and both longs on one side will grip more than the 2 short pads on the other side.

If this pulls without brakes on you may have stuck left 4x4.

Jan 14, 2010 | 2005 Ford F 350 Super Duty

1 Answer

2000 f350 super duty 7.3 drw steering seems to lock up on hard right and left turns. wheel shakes untill i stop and restart. i can sometimes stop the shaking if i quickly turn right and left while driving....


The control valves from the power steering unit lock in position at extreme angles. Either the fluid is dirty - replace it - or the unit is worn out - valves can be replaced separately and the unit refurbished. Or just buy a new unit.

Oct 12, 2009 | 2000 Ford F350 Super Duty Super Cab

2 Answers

Need fuse list for 2001 ford f350 trailer lights not working


In the fuse box under the hood, fuse in position 20 is a 7.5amp fuse for the trailer left turn circuit, fuse in position 22 is a 7.5 amp fuse for the right turn circuit, if the fuses are good and you have power at them it is going to be wiring, at the back of the truck close to the driver side at the bumper is a gray connector that will take factory wiring to you trailer wiring the yellow wire is left turn/brake light, the green wire is right turn/brake light, and the brown is tail lights, and the orange wire is 12volt feed for if there is a battery on the trailer that needs to be kept charged for break away safty brakes.

Sep 18, 2009 | 2001 Ford F350 Super Duty SuperCab

1 Answer

1992 Ford F350 Dually Diesel Truck Brake System problem.


Adjust your rear brake shoes. Then rebleed the system. Start at the master cylinder Bleed master first then the wheel furthest away from the master (right rear then left rear then right front then left front. Do that and your pedal should be good.

Nov 28, 2008 | 1992 Ford F350

Not finding what you are looking for?
1991 Ford F350 Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...