Question about 2006 Land Rover Range Rover Sport

1 Answer

If we changed the battery for the lock and unlock remote control for a Range Rover HSH 2006 and the code is lost, how do I reset the code.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Land Rover Master
  • 22,219 Answers

Sorry but looked in alldata book for you and it only shows up to 2005

Posted on Oct 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you enable a range rover engine when key battery is flat


There is a sequence of left and right turns of the key in the driver's door that will reset your bECM (Rovers brain) if the following have been tried.
1. Replace batteries in remote and 're-sync by depressing lock button on remote while physically turning and locking the door. Don't release button until locked and key removed. Repeat for unlock button.
2. Disconnect negative/earth cable from battery. While disconnected open driver's door, turn ignition to position 2, return to battery leaving driver's door open and reconnect the negative cable. Proceed to ignition. Turn off completely. Close all doors and hood and attempt starting.
Should both of these methods fail, run a search here on fixya for "engine disabled Range Rover P38" This will take you to step by step instructions on resetting the bECM which I opened this post with. It has been covered many times here, including by myself, no reason to post it again.
Good Luck!

Jul 14, 2014 | 2000 Land Rover Range Rover

1 Answer

I have range roover 2006 model sports yesterday i remove baterry because loose and then i pix now no crank only baterry i repai tnx


Removing the battery on these vehicles often results in an "arming" of the alarm system and needs to be reset by a dealer or a shop with qualified equipment. You can try disconnecting the battery for 10 minutes, hooking it back up and using the key fob to lock and unlock the vehicle before trying to start it. If the vehicle does not crank after the above procedure, then fault codes may need to be cleared and/or programming may need to be carried out.

Apr 23, 2014 | 2006 Land Rover Range Rover Sport

1 Answer

Key to my 2006 range rover sport not working


dead battery or you made need a new remote

Dec 18, 2013 | 2006 Land Rover Rover Range

1 Answer

How can i change battery of remote control for rangerover2006


it should open in the back or should open from the front being removed from the back and the battery will be inside.

Nov 30, 2010 | 2006 Land Rover Range Rover Sport

2 Answers

Replaced the Battery in the Key. It was not bad just replaced it as a preventative measure. The Ingnition wil not turn now. I can open the doors and hatch. I can place the key in the doorlock and turn...


You need to re-sync the Remote...

The remote handset uses a "rolling code" algorithm, meaning the code is changed every time remote locking or unlocking is performed. If you have removed the battery - then that Rolling code was lost.

If the normal Synchronization does not work, Possibly you will need to use the EKA Proceedure (Emergency Key Access).

Use this link to the appropriate information to aid you in solving your issues.

Oct 25, 2010 | 2005 Land Rover Range Rover

2 Answers

HOW I MAY CHANGE THE BATTERY FROM KEY REMOTE CONTROL


put the key into the ignition and turn to position 2 leave it for 10 mins it will charge the battery on the key remote

Aug 27, 2010 | 2006 Land Rover Range Rover Sport

1 Answer

I own a '99 Range Rover 4.6 hse. I recently reinstalled a battery that had gone dead. I cranked the engine but the alarm went off and the vehicle did not start. I am getting this message: gearbox fault. I...


Unfortunately, there is a trick to replacing the battery.
1) Open the Driver side door.
2) Open the Bonnet and take the battery cover off.
3) Use your remote to lock and unlock the car (keeping the driver side door open)
4) Pull the Negative Lead from the battery first, followed by the Positive Lead.
5) Change or replace with charged battery.
6) Closed down Bonnet.
7) Your windows, sunroof, and key FOB will not work... so follow the next steps.

7a) Insert your key, with door closed into the exterior lock on driver's side.
7b) While turning the key to lock the door, hold down the "lock" button on your remote for 5 seconds while in "lick" position
7c) Your remote will reset, and you should be able to use your remote now
7d) While driving, roll each window down twice. On your third attempt, you should only have to touch the window button, and the window will have reset

Enjoy your Rover!
MIke

May 21, 2010 | 1999 Land Rover Range Rover

4 Answers

1996 4.0 Range Rover won't unlock


This car is in super lock mode... when you press remote 2times to lock or when you lock with remote and try to unlock using key manually.

there is a 4 digit number to open the door, its like opening a safe, starting from the left(key in car door) it goes L/R/L/R. so if number code is 1234..... left 1, right 2, left 3, right 4.

or if this too troublesome you can ask landrover dealer to remove the KEYCODE.

happy trying.....
adrian/kk.

Jan 10, 2009 | 1996 Land Rover Range Rover

1 Answer

HELP ME WITH MY 2000 Range Rover!


Prob your RF reciver. Change it for about £130 ish. Make sure your access code works before the change to avoid confusion. Use part YWY 500 170 only.
If you can't get the £££ unplug the RF reciver (behind rear NS passenger seat) and use the key manualy. Good luck.

Dec 30, 2008 | 2000 Land Rover Range Rover

Not finding what you are looking for?
Cars & Trucks Logo

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76673 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...