Question about 1998 Ford Windstar

1 Answer

My door lights stays on suspect the censors where are they located

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 20 Answers

If you are not getting a dinging noise I would suggest you get a fine grit sand paper.Open your sliding side door and sand down the the silver connections on the door and on the body of the van.You have to really put some pressure on it.Do it for a few minutes.Wipe them off and close the door.See if that solves the problem.I have read on many sites that this doesnt fix it.I have the same van and had the same problem.I did this and the lights go out,the door adjar light is off and I dont have any idiot lights flashing on the dash.it has been like this for three months now.

Posted on Oct 19, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whereis the air bag module located


Modules are usually under the center console. Sensors are located in many different spots. Ones on the radiator core support, under the plastic piece. Ones under the front seats. Ones at the center column, just behind the front seats, and rollover sensors. I haven't found them yet.

Apr 21, 2014 | 2005 Chevrolet Aveo

1 Answer

I have a 2007 hyundia sonata with the air bag light that comes on and stays on


Go to your local auto electrician,who will plug in scanner
This will give him fault code to locate problem
Sometimes a faulty censor,or bad connection,component failure.

Apr 14, 2010 | 2006 Hyundai Sonata

1 Answer

Door ajar and brakelamp lights on dash go on randomly for no reason, sometimes very bright, and sometimes not so bright. At first it would come on for a few seconds. Now it seems to be happening more and...


The brakelamp could mean brake probs or brake light needs repairing for the door ajar it could mean that the censor in the door isn't reading properly. It could also be a short in the dash wiring.

Aug 08, 2009 | 1991 Honda Accord

1 Answer

Interior lights stay on after ingnition is off


Clean the contacts on the side door with course steel wool then lube them with die-electric grease, avail from most parts stores or the dealer, this should take care of the problem, if not u will have to remove the rivets and install new switch contacts both on the door and the door jam.

Feb 05, 2009 | 1995 Ford Windstar

1 Answer

95 jeep grand cherokee laredo 5.4 replaced alternator and battery and cable still have dead battery every morning Please help


the best way to look at this problem is with a12 volt test light then remove the ground cable from the battery turn every thing off inside the car close all doors and remove keys then connect testlight to battery cable and touch the test light point probe to the negitive battery post if test light lights up for more than three seconds and stays on you have draw on the system. dont panic it maybe just a glove box light or door switch. if suspect a circuit simply un hook it retest again .if you open a door that will make light test come on recheck all doors closed. if you still have test light on locate fuse box and remove one fuse at a time until test goes out while holding door switch in.when locate circut use wiring diagram to assist from ther. if the light does not light up check altenator output volt meter shoud be 13.2 -15.5 volts when running.

Dec 09, 2008 | 1998 Jeep Cherokee

3 Answers

2004 dodge ram 1500 5.7 hemi 4x4 4 door 90k miles


Take throttle body off, clean Throttle Body with Carburator cleaner. I had same problem and its the ethynol in fuel that creates a build up in the throttle body which creates this problem. I did what a friend of mine said to do (service manager at Dodge Dealership) it hasnt happened again.

Dec 02, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
1998 Ford Windstar Logo

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5481 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...