Question about 2004 Mitsubishi Endeavor

1 Answer

Is there a step by step instruction on how to change the left side mirror on my Mitsubishi Endeavor 04 ? thank you

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 6,826 Answers

Maybe try alldata.com, because on my online resource for the 2004 Mitsubishi Endeavor, there is no information on body work.

One could get the part from the salvage yard and look for the bolts like one would do for a GM car

One may have to remove some plastic parts to get at the fasteners.

Also, if there are cables for moving the mirror from the inside, then that should be considered, as well.

Also, if the mirror is heated, that should be considered.
---
(I got this off of Wiki Answers)
Very easily. Open the door, find two rubber circular boots right behind the
mirror. Take them off to expose the 2 bolts that hold the mirror on. Take the
bolts out and unplug the wire. Reverse these steps to install, hole this
helps...

There are three small bolts holding the driver's side mirror on. Two can be
accessed by opening door and removing the two circular rubber boots seen on the
upper end of the door . To access the third bolt you will need to remove the
door panel. you will need a forked driver to help remove the door panel. It can
be bought at any auto parts store. It has a flat Y shaped head that can be
inserted along the lateral and bottom edge of the door panel to pop it way from
the door frame. There are three screws holding the door panel on. Two under the
door handle and one behind the door latch. Then the door lifts up and off. Make
sure you have the window down before you take the panel off because you cannot
access the third bolt unless it is. You will have to unplug the electrical
connects that power the controls on the door handle to completely remove the
door panel. After you remove the panel there will be a hole in the upper right
hand door frame, possibly covered by a black patch. Beneath this is the third
bolt. you will also need to disconnect the light from inside the door frame
before you will be able pull the mirror off. There is a large rubber boot oval
shaped that you can pull out and you will see the electrical connection for the
mirror inside the hole on the right.


Good luck on this repair.

Posted on Oct 07, 2010

Testimonial: "Thank you for the tip... I'll try to work it out....but after taking the two bolts from inner side of the door ..the mirror didnt even move..."

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a way to reset keyless entry for 04 endeavor?


Search Results

    2004 Mitsubishi Endeavor Key Fob Remote Programming ...

    blog.keylessentryremotefob.com/.../04/2004-mitsubishi-endeavor-key-fo...
    Apr 25, 2013 - 2004 Mitsubishi Endeavor Key Fob Remote Programming Instructions ... you might have visit us at Keylessentryremotefob.com You can also ...

    Mitsubishi - Free Keyless Remote Fob Entry programming .

    How To Replace Mitsubishi Endeavor Key Fob Battery 2004 ...

    ? 2:04
    www.youtube.com/watch?v=yeQRdre7O0Q
    Oct 31, 2014 - Uploaded by Keyless Entry Remote Inc
    ... will show you How To Replace Mitsubishi Endeavor Key Fob Battery 2004 2005 To Order This Remote ...

Nov 01, 2015 | Cars & Trucks

1 Answer

Why do i have a loud roaring when driving 2005 mitsubishi endeavor especially when turning left?


Stating the obvious, check to see if your tire is rubbing on something when you turn!

Jul 21, 2014 | 2005 Mitsubishi Endeavor

1 Answer

How do you change the fog lights in a mitsubishi endeavor an 04


Most likely you have to get under the vehicle
& replace the lamp from behind the front
facia or bumper

May 23, 2011 | 2004 Mitsubishi Endeavor

1 Answer

I have unbearable wind noise from both the drivers side and passenger side mirrors above 40MPH. What can be done. Thank you, Dennis from Duxbury


There is a TSB Bulletin on issue. Number:12-82-04 dated 04/15/04.
Involves Replacing Door Mirror Gussets. First try opening window and squeezing rubber together (that glass runs through) by mirror to see if that helps reduce noise. I believe this is caused by closing door hold glass instead of door!
Replacement parts are:
Right Gusset PN 61158AE00B
Left Gusset PN 61158AE01B

I had left one changed at body shop (while car was there) and now its so quiet the right one is annoying me!

Jan 19, 2011 | 2003 Subaru Outback

2 Answers

2005 mitsubishi endeavor has power windows. driver side window won't go down and none of the switches on the drivers side will work the other windows in the car but all other windows roll down from their...


I had the same issue on my '04. The wiring harness inside the door had worn through exposing all the wiring. Eventually that gave out. I had to replace the harness. Cost about $300.

Dec 01, 2010 | 2005 Mitsubishi Endeavor

2 Answers

How to change water pump on 04 endeaver. It just started making noise on slow sharp turns. Fluid level is good and belt is not loose.


The noise could thn be coming from the power steering pump, its worth checking before you go for the water pump!

Dec 15, 2009 | 2004 Mitsubishi Endeavor

1 Answer

The horn on my 04 mitsubishi endeavor went out and also noticed at the same time the alarm on my lock n unlock remote doesn't work. How do i fix the problem?


Standing out side the car, reach in and push the horn pad. Do you hear a click under the hood?

If not, check your fuse. If the fuse is good, check the relay.

If you do hear the click, your horns have likely failed. You can check for 12 volts with a multimeter or test light on the horn wire when the pad is depressed to verify.
If the relay and fuse check out OK and you still do not have power at the horn wires, your pad may have failed or the wire has come loose from it. This is an airbag component and should not be disassembled without familiarity with airbag systems..

If you do have 12 volts at the wire with the pad depressed, replace your horns.

One horn is located below the drivers headlight.
The other horn is near the firewall on the passenger side.


Sep 15, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Cabin Air Filter - 2004 Mitsubishi Endeavor (Where?)


IT IS IN BEHIND THE GLOVE COMPARTMENT YOU HAVE TO TAKE IT OUT BY UNSREWING AND START FROM YOUR RIGHT SIDE

May 31, 2009 | 2004 Mitsubishi Endeavor

Not finding what you are looking for?
2004 Mitsubishi Endeavor Logo

753 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...