Question about Toyota Tacoma

Open Question

Fuel system diagram of a 2003 toyota tacoma - Tacoma Toyota Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2003 Toyota Tacoma

The blower motor is located directly below the passanger glove box on the right. Its a round flat plate with 2 small screws holding it in place. All you need is a screwdriver and a pair of wire cutters (the wire cutters totally depend on whether the replacement is factory or not.) Simply unblot the existing part and replace it with the new part. If you have purchased an aftermarket part you will need to cut and attach the factory harness pigtail to your motor. Also the replacement part I purchased didn't come with the blower wheel, so I had to remove the old one and place it on the new motor. Works like a charm! Easy install and best of all....I have air after 2 years without!!

Posted on Jun 21, 2008

  • 125 Answers

SOURCE: Can't find the fuel filter on 2004 toyota tacoma 4 cyl 4x4

look under the truck

Posted on May 04, 2009

  • 273 Answers

SOURCE: Fuel Filter, 2002 Toyota Tacoma

follow your fuel lines back from the injectors/carb it is a cylinder shapped unit should be at the top of the engine near the windscreen

Posted on Jun 06, 2009

  • 2187 Answers

SOURCE: toyota tacoma 2003 check engine light is

If the car still runs then the problem is not major but may develop into one if unchecked. The sensors in the engine may have detected problems and should be stored in its ECU. If you have a scanner have it connected to the diagnostics it should give you a clue on what to check out.

Posted on Jul 08, 2009

  • 1 Answer

SOURCE: 2003 parking bulb toyota tacoma

OK, I just fixed mine. The unit pulls out. You have to get a screwdiriver, wrap it with a cloth so it doesn't scratch the paint, then gently wedge the entire unit out. When it pops out, you'll see the clips that keep it in place. You might think its breaking when you pull it out, but trust me this is how you do. Just be gentle with it. After you get the unit out, simply take the socket out and replace the bulb. I did it in five minutes.

Posted on Nov 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is iat sensor on 2006 toyota tacoma 4.ol 4door located ?


This is the 2001-2012 Toyota Tacoma wiring diagram, Toyota Tacoma IAT (Intake Air Temperature) Sensor Location and the Toyota Tacoma MAF (Mass Air Flow) Sensor Location, also included is a pinout of the sensor. You are likely installing a performance chip or a cold air intake kit for increased HP (Horsepower). You will want to be sure to disconnect the car battery before adding performance products.




Here is the Toyota Tacoma's Iat sensor diagram:




ab0b7213-0c7f-459c-b26e-77a685236e74.jpg

Apr 14, 2015 | 2006 Toyota Tacoma

2 Answers

2003 toyota tacoma won't start


What was checked/tested ?

Fuel pressure at motor & spark cranking?

Battery seems fine based on what kind of testing?

Won't Start
Won't Turn Over

Have to get your thoughts around what you say

Nov 29, 2012 | 2003 Toyota Tacoma

1 Answer

Sometimes the 2003 Toyota Tacoma pickup won't start. After turning the ignition key to start position and off position many times it starts. What is causing it and how do I fix it.


replace the fuel pump or check the relay and power going to the fuel pump first. if its getting voltage it might be bleeding the pressure back to the tank

Feb 05, 2011 | 2003 Toyota Tacoma

1 Answer

I have a 2003 Toyota prerunner 6 cylinder. It takes 10 minutes or more to fill gas tank. Just started last fillup.


It sounds like you dropped some alum foil from a dry-gas or fuel system cleaner bottle down your fill spout and it stuck your fuel check valve in a 1/2 open pos,,The large fuel fill hose will have to be removed and the check valve cleaned

Nov 02, 2010 | 2003 Toyota Tacoma

4 Answers

LOCATION OF FUEL FILTER 2005 TOYOTA TACOMA 2.7 4 CYL



Fuel filter is in the fuel pump
module assy. in the fuel tank for both V6 and I-4 models with no recommended service interval.

Jul 26, 2009 | 2005 Toyota Tacoma

2 Answers

Which fuse controls the stero and cigratte lighter


you should have that info in your manual. If not, you can download one from the web site.

Jun 15, 2009 | 2003 Toyota Tacoma

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...