Question about 2005 Cadillac SRX

2 Answers

Replace front driver signal light bulb

I have the bulbs -- but can not see how to change the bulb?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,035 Answers

Depending on whether it is the front or the back turn indicator light will determine on what needs to be done. If it is the front turn indicator light open the hood of the car you may need to take the entire headlight out. The headlight may have screws, take the screws out then the front light will come out from the outside of the vehicle replace the burned out bulb. The bulb should snap right in and then put the headlight back in make sure you put all screws back in from the inside of the hood. Step2 If it is the back turn indicator light, go through the trunk of the vehicle. If there is a panel covering the lights you must unscrew the panel and then replace the burned out light bulb. Some panels can be folded down without removing all of the screws to access the lights. This light may not require for you to pop the entire light out you maybe able to just replace the bulb. After you have replaced it screw the panel back into place. The back light should not require the entire light to be lifted out just a simple bulb replacement. Step3 In replacing either the front or the back indicator light you must gain access to the turn signal housing which is usually in the same case as the headlight or your rear lights. It is very helpful to also get the owners manual out this will tell you exactly what type of bulbs you will need to get to replace the indicator bulb.

Posted on May 29, 2008

6 Suggested Answers

  • 12 Answers

SOURCE: replace the front turn signal light bulb

you should have two tongues holding the main headlamp assembly, they are towards the inside of the engine compartement, slide them off upwards and wiggle the assembly and should come off, once off you'll have access to you signal light, hope it helps

Posted on Dec 17, 2008

  • 512 Answers

SOURCE: Can't figure out how to change the bulb for turn signal on Jeep

it can be a pain because the screws are hidden. first you must remove the parking lamp raise the hood. one screw is visible from the top looking down at the lens...the other is hidden on the bottom side....look between the park laml and the turnsignal housing..a long phillip scew driver can reach it. once you have that removed lookng straight down at the turnsignal assembly you should see 2 screws. remove them and roll the assembly out and away from the body...you should see the bulb holder

Posted on Nov 16, 2008

  • 2 Answers

SOURCE: rt front turn sighal burned out - how to access bulb to replace

There is a latch to the Van's outside just insert a flat blade screw driver and the turn light assembly will swing toward the middle of the van.

Once open the lamps twist out.

Posted on Feb 07, 2009

  • 4 Answers

SOURCE: Replacing front turn signal bulb on 2006 Cadillac SRX

WikiAnswers
http://wiki.answers.com/Q/How_to_change_the_Cadillac_SRX_Front_Tun_Signal_Bulb

Posted on Feb 17, 2009

  • 14036 Answers

SOURCE: need replace turn signal bulb

YOU HAVE TO THE FRONT HEADLIGHT HOUSING TO REPLACE THE TURN SIGNAL BULB.

Posted on Aug 24, 2009

Testimonial: "thanks"

Zeevert
  • 373 Answers

SOURCE: procedure to change turn signal light bulb on a

Remove 3 or 4 of the plastic pins holding the inner fender. They are located around the lip of the fender opening. The pins are removed by pulling the center cap of the pin straight out about an 1/8" and then wiggle and pull the whole pin out.
Pull the inner fender down and back.
Reach your arm in and grab the socket and squeeze the locking tab.
Rotate the socket counter-clockwise less than a quarter turn, and pull straight back.
Reach your other hand in and remove the bulb by pulling it straight out of the socket. It takes a 3157 bulb

Posted on Jun 22, 2010

Testimonial: "Thank you so much for your help. Really I had ask the question about 3 months ago, but since I didn't had it fixed yet, it's OK now. Franco"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front driver's side signal light does not work. Changed the bulb and it still does not work. The driver's side rear works and the passenger side works (front and back). Also, when the signal arm is pushed...


when a bulb fails on one side of the indicators the other bulb, same side, flashes faster, SO.you have just answered the question yourself,as you have replaced the bulb with a new one, the contacts for the new bulb are at fault.

Sep 11, 2010 | Hummer H3 Cars & Trucks

1 Answer

Driver front turn signal does not blink. front


This may have more then one bulb in the front or possibly a bad socket try wiggling the new bulb in the socket to see if it will work.Compare all turn signal lights that come on the passenger side to those drivers side.Some vehicles also incorporate sidemarker lights with the turn signals.

May 29, 2010 | 2001 Pontiac Aztek

1 Answer

How do you change a front signal bulb on a 2004 accord


Front turn signal bulb replacement

1. Remove the inner fender
2. Disconnect the 3p connector from the front turn signal/side marker light.
3. Turn the bub socket ( 45 degree ), counterclockwise to remove the bulb.
4. Install a new bulb in the reverse order of removal.

Apr 12, 2010 | 2004 Honda Accord

2 Answers

Tail lights work on both sides. turn signal and


Sounds like you need to replace the drivers brake/tail light.

Dec 14, 2009 | 1998 GMC Sierra

1 Answer

1998 pontiac transport/montana has not tail or break lights...turn signals blink fast or not at all. changed rear bulbs and noticed carbon on front build up on front bulbs. Help!


If one of the filaments in the bulbs is burned out, the remaining working lights will flash alot quicker.
Check the bulbs, and replace if the filaments are broken.
If the front bulb has a carbon build up it blown out...change it..
Once the bulbs are replaced your signals should work properly.

Dec 09, 2009 | Pontiac Trans Sport Cars & Trucks

1 Answer

Front driver turn signal quit. changed bulb, worked for short time, then quit. bulb OK. passenger side quit 1-2 months later. bulb OK. neither front emergency flasher work. automatic daytime front lights...


Check for head light (daytime)relay to be bad,this might have to do with the turn signals also,if the turn signals on this car,also have running lights in them,If this relay is not bad,replace the body control module.

Nov 07, 2009 | 2005 Pontiac Grand Prix

2 Answers

Need replace turn signal bulb


YOU HAVE TO THE FRONT HEADLIGHT HOUSING TO REPLACE THE TURN SIGNAL BULB.

Aug 24, 2009 | 1996 Chevrolet Cavalier

4 Answers

Front signal light not working and rear signal lights flashing fast on 1999 intrigue


Your front turn signal socket is shot. Buy a new one at the dealer for about 30.00. It will fix it. You may be able to clean it and wiggle it to get it to work. But it wont last very long. I had the same problem. Replaced the socket and it is fine. Note: If one side is bad the other side it not far behind. Probably 2 or 3 months it will go also. Good Luck.
Bill

Apr 17, 2009 | 1999 Oldsmobile Intrigue

1 Answer

Left Signal light isnt blinking on my 2000 300M Chrysler


you need to replace the rear driver side light bulb. it will fix the problem.

Feb 27, 2009 | 2000 Dodge Ram 1500 Truck

Not finding what you are looking for?
2005 Cadillac SRX Logo

1,164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...