Question about 2003 Mitsubishi Galant

1 Answer

How do you change the plugs on a 2003 mitsu gallant 4 cyl

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,978 Answers

Your coils and spark plug caps are one in the same. You need to unbolt the coil/plug caps on top of the valve cover. Lift them out of the way and you will find the spark plugs underneath.

Posted on Oct 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

09 accent cyl 4 missfire, plug injetor coil all ok cyl comp test all within spec. changed pcm old one stopped workin alltogether. all no change,intermittent missfire


SWAP COIL LIKE FROM CYL NUMBER 1 TO 4 AND ROAD TEST UNDER LOADS IF CHANGE THE MISS TO CYL NUMBER 1 NEED A COIL OR BAD PLUG AT CYL NUMBER 4

Sep 02, 2014 | Cars & Trucks

1 Answer

Cant find the block heater cord for 2011 mitsubitshi eclipse


are you sure its the heater core?I had a 2003 mitsu gallant and it was the a/c draining on the floor.It was the drain under the hood that needed to be sealed.You see around the drain they put something that helps with vibration and it erodes causing the water to go back in the vehicle.Find a good gasket material like something they use to put around windshields and work it around the drain.This is common in mitsus .If your sure its the heater core.Give more specific infomation

Dec 05, 2013 | 2000 Mitsubishi Eclipse

2 Answers

Don't know where no.4 cyl. is at-need to change spark plug -2003 dodge dakota slt v6


looking at front of motor its the second spark plug back on the left side

Apr 03, 2011 | Dodge Dakota Cars & Trucks

1 Answer

4th cylander keeps misfiring new plugs and wires


first question is it a four cyl? or six did u change the coil pack plug wire if a four cyl? did u use ngk plugs to replace the plugs? or it may be a fuel inj you would have to swap fuel injs with a different cyl to see if it follows the inj or stays with the cyl, if it stays may need to diag that cyl further compression check etc

Feb 03, 2011 | 2003 Mitsubishi Galant

1 Answer

I have a 2003 Expedition 5.4L Triton. Two days ago, with low gas (38 miles to empty), engine started running rough. Code read P0302, misfire cyl. 2. Since it had 113K miles, I figured its time to change...


Most likely the coils. Easiest way to check is swap them with another cylinder, start it, pull the plug wire connecter and if it doesn't change the engine the coil is bad. If it is the injector, then you can check it with an ohm meter. Touch the leads in the injector it should read 11 to 15 ohms. if you need help let me know.
Randy

Dec 02, 2010 | 2003 Ford Expedition

1 Answer

2003 OUTLADER WITH MIS FIRE CODE, I CHANGED PLUGS WIRES COILS AND STILL GET IT AND YES IT RUNS ROUGH


sounds like it might be a fuel inj ,does it have a misfire code which cyl , try swapping fuel injs see if misfire changes cyls and follows fuel inj to different cyl

Sep 24, 2010 | 2003 Mitsubishi Outlander

1 Answer

84000 miles on 6 cyl Mitsubishi Gallant. What is the recommended mileage for timing belt replacement?


Timing belt replacement for rubber belts is around 60, 000 miles, maximum is 90,000 miles, Since you have 84,000 miles, I would do it soon.

Dec 29, 2009 | 2003 Mitsubishi Galant

2 Answers

2003 PT Cruiser - check engine light


Use the correct champion plugs for starters, make sure the wire is firing. If the wire is firing, the coil pack is good. You will need to check compression and fuel delivery after that.

Jun 23, 2009 | 2003 Chrysler PT Cruiser

1 Answer

Dead cylinders 2003 sebring


it sounds like you may have the wires on the wrong coil. It should be #1 on the #4 coil, and the #3 wire on the #2 coil. you probably have them backwards so 1 and 3 are firing on the exhaust stroke.
the firing order is 1-3-4-2.
they should be hooked like this.
82c8490.jpg

3ddfc56.jpg

Jan 23, 2009 | 2003 Chrysler Sebring

Not finding what you are looking for?
2003 Mitsubishi Galant Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...